···
Log in / Register

How many degrees does each mark represent on the Geely water temperature gauge?

4 Answers
DelDallas
09/05/25 8:05am

Each small mark on the car water temperature gauge represents 15 degrees, while each large mark represents 30 degrees. Additional information: The 'C' on the car water temperature gauge indicates 60 degrees, and the red 'H' mark represents 110 degrees. The span from 60 to 110 degrees allows for estimating the approximate temperature indicated by the water temperature gauge. Possible causes of elevated car water temperature: Poor engine cooling, prolonged use without cleaning internal and external dirt from the radiator affecting coolant circulation and heat dissipation, damaged fan or other cooling components. Engine: Most cars use water-cooled engines, which rely on continuous circulation of antifreeze within the engine for heat dissipation.

Was this review help?
6
0
Share
VanAdalynn
09/17/25 8:16am

I've been driving a Geely for several years, and regarding the issue of one bar on the temperature gauge, there isn't a fixed degree. The gauge's full range from cold to hot is roughly between 60 to 120 degrees, with each bar possibly representing 10 to 20 degrees, but the exact numbers aren't crucial—it's more about the needle's position. During normal driving, it should stay near the middle mark, typically around 90 degrees, which is considered healthy. If it rises into the red zone, it indicates overheating and requires caution—possible causes include insufficient coolant, a faulty fan, or a thermostat issue. Remember to regularly check the radiator and overflow tank; top up if the level is low, especially during summer long-distance drives when overheating is more likely. I've experienced sudden needle spikes before, but fortunately, timely stops prevented engine damage. Abnormal water temperature significantly harms engine longevity, so it's important to take it seriously.

Was this review help?
6
1
Share
Expand All
JadeAnn
11/01/25 2:00am

As a car-savvy user, one tick on Geely's temperature gauge doesn't represent a specific value. The dial is designed to show a temperature range of approximately 60-120°C, with each tick roughly representing 10-20°C – though it's quite vague. Practically speaking, just watch for the midpoint at 90°C. If the temperature gets too high, the engine may experience knocking or oil leaks, requiring immediate shutdown to investigate causes like coolant leaks, water pump failure, or fan malfunction. I recommend using diagnostic tools for precise readings, but visual monitoring suffices for daily use. Keep coolant clean and change antifreeze regularly to prolong vehicle life – don't wait until major issues arise requiring expensive repairs.

Was this review help?
15
4
Share
Expand All
CarterLynn
12/15/25 2:08am

Keep an eye on the coolant temperature gauge while driving. For Geely vehicles, the scale markings may vary, but generally the full range falls between the cold and hot indicators, typically around 70 to 100 degrees Celsius with each marking representing a 10-degree increment. The middle range is the safe zone. If the temperature rises into the warning zone, it indicates potential issues like low coolant level or a stuck cooling fan. In such cases, stop the vehicle immediately to prevent engine seizure or overheating accidents. Regularly check coolant levels and replace the filter to ensure smooth operation.

Was this review help?
1
5
Share
Expand All
More Forum Discussions

How early can a B2 driver's license annual review be conducted?

Annual reviews cannot be conducted in advance. Below is relevant information about annual reviews: 1. Concept: Also known as motor vehicle inspection. The inspection items and scope vary depending on the usage nature of the motor vehicle. 2. Time: For small cars and blue-license minivans, within the first six years after new vehicle registration, an inspection is required every two years; after six years, it becomes an annual inspection; after ten years, it's an annual inspection, and after fifteen years, it's twice a year. For trucks, after registration, an annual inspection is required; after ten years, it's twice a year. The documents required for vehicle annual inspection include: the vehicle's driving license, valid compulsory insurance policy, and vehicle and vessel usage tax.
3
5
Share

What are the four basic types of car insurance?

Vehicle insurance four basic types refer to vehicle damage insurance, third-party liability insurance, no-deductible insurance, and passenger insurance. The following is a detailed introduction: 1. Vehicle damage insurance: Vehicle damage insurance means that if the vehicle owner causes total or partial loss of the vehicle due to an accident during driving, the insurer shall compensate according to the insurance contract. 2. Third-party liability insurance: Third-party liability insurance refers to the economic liability that the insured or their permitted driver should bear according to the law when an accident occurs during the use of the insured vehicle, causing personal injury or death or direct property damage to a third party, and the insurance company is responsible for compensation. 3. No-deductible insurance: If an accident within the scope of insurance liability occurs, resulting in vehicle loss or third-party liability compensation, the insurer shall be responsible for compensation according to the amount stipulated in the "Terms" for compensation. 4. Passenger insurance: Refers to during the insurance period, the insured and their permitted legal driver, in the process of using the insured vehicle, if an accident occurs causing personal injury or death to the personnel on the insured vehicle, the economic compensation liability that should be borne by the insured according to the law.
16
5
Share

What is the maximum wading depth of the Haval H9?

The maximum wading depth of the Haval H9 is 700mm. The wading depth of the Haval H9 is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when passing through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of the Haval H9 is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth must not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before wading, always turn off the auto start-stop function to prevent the engine from automatically restarting after stalling in water, which could cause severe damage due to water ingestion. Assess the underwater road conditions based on the passage of preceding vehicles and choose an appropriate entry point. Observe the path taken by other vehicles and follow it at a low speed, avoiding sudden acceleration or deceleration. On roads prone to water accumulation, use warning water level markers, trees, or the wheels and doors of other vehicles as reference points to estimate water depth before deciding whether to proceed. Know your vehicle's safe wading depth. If the water depth exceeds half the tire height or the engine's air intake, do not proceed and choose an alternative route instead.
16
0
Share

Should the Buick GL6 Use 92 or 95 Octane Gasoline?

According to the official vehicle manual recommendation, the Buick GL6 should use 92 octane gasoline. In addition to checking the appropriate gasoline grade in the vehicle manual, you can also find it on the fuel tank cap, which will also indicate the recommended octane. Generally, the gasoline grade can also be determined based on the engine's compression ratio. Vehicles with an engine compression ratio between 8.6-9.9 should use 92 octane gasoline, while those with a compression ratio between 10.0-11.5 should use 95 octane gasoline. However, with the application of new technologies, the compression ratio alone cannot determine the gasoline grade. High-compression engines can also be tuned to use lower-octane gasoline because, besides the compression ratio, other factors such as ignition timing, turbocharging technology, and Atkinson cycle technology also play a role. Generally, the higher the gasoline octane number, the higher the octane value and the better the anti-knock performance. 92 octane gasoline contains 92% isooctane and 8% n-heptane, while 95 octane gasoline contains 95% isooctane and 5% n-heptane. If the Buick GL6 occasionally uses the wrong gasoline grade, simply switch back to the correct octane after the tank is empty. However, prolonged use of the wrong gasoline grade can have the following effects: For vehicles recommended for low-octane gasoline, using a higher octane will not cause damage, but the increased octane value may alter the fuel's ignition point, leading to delayed combustion in the engine. This reduces the engine's power output and thermal efficiency, resulting in poorer performance. For vehicles recommended for high-octane gasoline, using a lower octane can cause engine knocking. The significantly lower octane value reduces the fuel's ignition point, causing premature ignition during the compression stroke. If the fuel ignites before the spark plug fires, resistance occurs during the upward stroke. This resistance makes the engine run very unevenly. Mild knocking may only increase noise without significant engine damage, but noticeable knocking indicates severe engine conditions. The vibrations not only affect driving stability but can also cause abnormal wear on the pistons and cylinders, potentially leading to cylinder scoring in severe cases.
20
4
Share

How Many Kilometers Can the First Maintenance Be Exceeded?

First maintenance can be exceeded by 500 kilometers. The following is an introduction to the first maintenance: 1. Concept: The first maintenance of a car refers to the initial maintenance, generally at 5000 kilometers/6 months. 2. Notes: The engine has a break-in period with a new car. Different brands and models of cars are equipped with different engines, some of which use special technology and have strict requirements for engine oil. Some engines have special materials and high precision, resulting in relatively less wear. In addition to changing the engine oil and oil filter, the first maintenance also includes a comprehensive inspection and diagnosis of the vehicle's condition and usage. Usually, the first maintenance is free of charge.
4
1
Share

What is the difference between FAW Haima and Haima?

FAW Haima and Haima differ in that Haima is a Chinese automobile manufacturer, while FAW Haima is a Japanese automobile manufacturer. Here are the relevant introductions: 1. Haima Automobile: The logo of Haima Automobile features an abstract falcon shape embedded in a circle symbolizing the sun, representing "the rising sun and the soaring roc," which embodies the corporate image of Haima Automobile's upward striving and determined ambition to soar. 2. FAW Haima: FAW Haima Automobile Co., Ltd. is located in Jinpan Industrial Development Zone, Haikou City, covering an area of 1 million square meters. After more than ten years of construction, Haima Automobile has established excellent asset structures and advanced management systems, built leading domestic production lines for automobile stamping, welding, painting, and assembly processes, and established shared development and supporting platforms and marketing networks with strategic partners. It is a large-scale passenger car production enterprise designated by the state.
17
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.