How Many Days in Advance Can You Schedule the Driving Test Subject 3?

1 Answers
VonAmara
07/30/25 8:45am
Generally, it is five days in advance. Additional details: 1. The system automatically reviews applications five days before the exam date. Candidates who pass the review will receive a confirmation SMS, notifying them of the scheduled exam date, location, and session. To cancel the exam, applicants must submit a request at least one working day in advance. Typically, the scheduling results are released two days before the exam date, and a confirmation SMS is sent. However, if those two days fall on a weekend, the results will be released four days in advance. 2. Subject 3, also known as the Road Safety Driving Test, is part of the motor vehicle driver's license assessment. It refers to the road driving skills and safety awareness test in the driver's examination. The content of the road driving skills test varies depending on the type of vehicle license being pursued.
Was this review help?
9
0
Share
More Forum Discussions

What Causes Abnormal Noises in the Engine Compartment While Driving?

Abnormal noises in the engine compartment while driving can be caused by the following reasons: 1. It may be caused by abnormal noises from the engine valves, pistons, or accessories. 2. It can also be caused by abnormal noises from the transmission or chassis. 3. Loose connecting rod bolts can also cause abnormal noises. Below is some related information: 1. Sometimes, you may encounter abnormal noises from the engine while driving, but when you stop to inspect, the engine continues to run with the noise. In this case, you can loosen the carburetor adjustment needle slightly and then start the engine again for testing. If the noise appears, you can diagnose its characteristics. 2. If there is still no abnormal noise, you can perform a cylinder cut-off test and conduct an emergency acceleration test. This can both make the noise appear and determine the relationship between the noise and the cylinder position.
4
0
Share

Brief Introduction to Common Locations of Vehicle VIN Codes

Here is a detailed introduction to the common locations of vehicle VIN codes: 1. The VIN code can be found at the lower left or lower right corner of the vehicle's front windshield. 2. It may also be located on the car's trunk or engine frame, as well as on the factory nameplate and certificate of conformity. 3. During the sales process, the VIN code appears on the sales invoice and later on the tax payment certificate after taxation. 4. After registration, it will be displayed on the vehicle's license and registration certificate, and it also appears on the insurance policy when purchasing insurance. Here is some related information about VIN codes: 1. The VIN code, also known as the Vehicle Identification Number, is crucial for correctly identifying the vehicle model and ensuring accurate diagnosis and maintenance. 2. It contains information such as the manufacturer, year, model, body type and code, engine code, and assembly location of the vehicle.
13
2
Share

Is it illegal to drive with low beams on during the day?

Related laws and regulations do not explicitly prohibit the use of low beams during the day, so it is permissible to turn on low beams in poor visibility conditions during daylight hours. Low beams are designed for close-range illumination, offering a wider but shorter-range light coverage. Here is additional information: 1. Regulations on using low beams: Regarding situations where low beams should be used, Article 48 of the "Regulations for the Implementation of the Road Traffic Safety Law" stipulates, "On roads without central barriers or center lines, vehicles meeting at night should switch to low beams when the oncoming vehicle is more than 150 meters away, and low beams must be used when meeting non-motorized vehicles on narrow roads or bridges." 2. Penalties for not using lights at night: According to relevant laws and regulations, failure to use vehicle lights as required may result in a fine of 50 RMB and 1 penalty point.
15
4
Share

Does having one side wider than the other in the reverse parking test of Subject 2 result in penalty points?

Reverse parking with one side wider than the other is acceptable. As long as the vehicle body does not touch the lines, no penalty points will be deducted. Below are relevant details about Subject 2: 1. Training hours: Generally, C1 license requires 16 hours for Subject 2, while C2 license requires 14 hours. Completing the required training hours is a basic requirement for taking the Subject 2 test. Training hours can only be increased, not decreased. Adding test items requires corresponding additional training hours. 2. Duration recording: Each training hour consists of 60 minutes, with effective teaching time not less than 45 minutes. Additionally, each student's daily classroom learning and practical operation time cannot exceed 4 hours; in other words, a maximum of 4 training hours can be completed per day, and any excess will not be recorded by the system.
8
3
Share

Can the USB port in the new Santana connect to a phone for music playback?

Car USB ports cannot connect to phones for music playback. Below are specific details about in-car USB ports: 1. Power supply only: The USB port in cars is designed for charging phones and does not support phone connectivity; it only provides power. 2. Power supply conditions: The USB port supplies power only when the car is running; power stops when the engine is turned off. Below are extended notes on misconceptions about USB port charging: 1. No need for a car charger if the car has a USB port: Since most in-car USB ports are set up for audio data transfer, the majority of vehicle ports only provide 5V/0.5A current. Insufficient current can damage devices. 2. Charging current can be higher but not lower: The output current from the car charger should not exceed the phone's maximum rated input power. 3. More USB ports, slower charging: The current in USB ports depends on voltage, not the number of USB ports available.
2
5
Share

How much engine oil should be added to the Ford Edge?

Ford Edge 2.0T models use approximately 5.4L of engine oil during an oil change. Here is more information about the Ford Edge: 1. The Ford Edge is a mid-size crossover SUV model built on the Ford CD3 platform. The Edge, with its accumulated strength, strives to expand boundaries and lead its peers. The entry-level configuration of the Edge is equipped with Michelin tires. Like the Ford UCD platform, the CD3 platform belongs to Ford's global mid-size car platform, featuring both front-wheel drive and four-wheel drive configurations. 2. In terms of configuration, the Ford Edge comes standard with an automatic start-stop function. Except for the 2018 Ford Edge Ecoboost-245 two-wheel-drive base model with 5 seats, all other models are equipped with a panoramic sunroof. The Ford Edge also features a series of leading intelligent and premium configurations, including electrically foldable rear seats, anti-glare LED headlights, and a 360-degree panoramic camera system.
8
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.