How many cylinders does the Haval H6 Coupe engine have?

1 Answers
JayceDella
07/30/25 2:31am
The Haval H6 Coupe is equipped with a four-cylinder engine. The entire Haval H6 Coupe lineup uses a 1.5-liter turbocharged four-cylinder engine. This 1.5-liter turbocharged four-cylinder engine delivers a maximum power of 110 kW and a peak torque of 210 Nm, with the maximum power achieved at 5,600 to 6,000 rpm and the maximum torque available between 1,800 to 4,400 rpm. Positioned as a sporty SUV, the Haval H6 Coupe measures 4,545 mm in length, 1,835 mm in width, and 1,700 mm in height, with a wheelbase of mm. It is paired with a 7-speed wet dual-clutch transmission.
Was this review help?
12
4
Share
More Forum Discussions

How to Identify Flood-Damaged and Accident-Damaged Cars?

Check for signs of being pried open, damaged, or filled with adhesive. Then use the key to open each car door to see if every door lock can be turned easily. Inspect whether the mounting brackets for the lighting and signal lamp groups in the engine compartment are broken or loose. If there is a large amount of sediment or rust spots attached inside, it may indicate a flood-damaged car. Check the wires and vacuum pipes above the engine body, as well as the gaps between the high-voltage ignition coils and spark plugs for traces of mud attachment.
10
2
Share

How to reset the maintenance light on a 2020 Corolla?

Press and hold the "A" button, step on the brake pedal, and do not release either of them during the process. Do not start the engine, but the vehicle's power must be turned on. When the characters on the instrument panel flash or the entire display screen flashes, continue to hold the "A" button, and "..." will appear on the instrument panel. Release the reset button "A" and the brake pedal. The maintenance light reset operation is now complete. Turn off the vehicle's power.
13
5
Share

How to Turn On the Navigation Lights?

After powering on, go to the vehicle settings where you can find the lighting controls. Look for the option labeled 'Daytime Running Lights' and check if it shows 'Off'. If it does, press the OK button on the right side of the steering wheel to switch it to 'On'. Then, restart the vehicle, and you will see the navigation lights on both sides illuminated when standing in front of the car.
15
2
Share

How to set the beep sound when locking the car?

Locking the car with a beep sound can be enabled through a 4S shop. Pressing the lock button will produce one beep, while pressing the unlock button will produce two beeps. The beep sound when locking the car is a prompt from the vehicle's anti-theft system. This prompt sound can be muted by pressing the mute button on the remote control.
3
2
Share

What to Do If the Handbrake Button Cap Falls Off?

First, you need to remove the center console panel, then take off the electronic handbrake button, after which you can replace it with a new button cap. Replacing the handbrake button cap requires replacing the entire brake button assembly; there is no option to replace just the button cap alone.
4
1
Share

What to Do When the Traffic Light Stays Red?

Contact the 110 command center personnel or notify the traffic police officer responsible for traffic light management to fix the signal light, and inquire whether running the red light under these circumstances will result in penalty points. In general, a continuously red light indicates a signal controller program error. In such cases, you can safely proceed through the intersection after confirming it is safe to do so by reducing speed.
13
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.