How Many Cylinders Does the BMW 1 Series Have?

Is it mandatory to shift to 4th gear in Subject 3?

During the gear shifting exercise in Subject 3, it is necessary to shift up to 4th gear. The speed requirement is between 25-57 km/h. The gear requirement specifies that you must maintain a speed of 35 km/h in 4th gear for more than 3 seconds. This means that during the Subject 3 test, once the gear is in 4th, the vehicle speed must not drop below 35 km/h, and this speed must be sustained for over 3 seconds. The standard for gear and speed matching is as follows: 1st gear corresponds to 0-27 km/h, 2nd gear to 5-37 km/h, 3rd gear to 15-47 km/h, 4th gear to 25-57 km/h, and 5th gear to 35-61 km/h.

4

0

Share

What is the trick for maintaining 30cm distance in right-angle turns?

Engine hood reference point, wiper rivet reference point, and rearview mirror reference point. Here are the detailed explanations: Engine hood reference point: When entering a left right-angle turn, first align the vehicle body and drive close to the right side of the road, ensuring that the right 1/3 of the engine hood aligns with the right edge line of the road. Maintain this alignment by making slight steering adjustments, keeping the right side of the vehicle approximately 30cm from the road edge line. Wiper rivet reference point: When entering a left right-angle turn and aligning the vehicle body to drive close to the right side, position the left wiper rivet to align with the right edge line of the road. Maintain this position while driving, keeping the vehicle body approximately 30cm from the road edge line. Rearview mirror reference point: For a left right-angle turn, observe the right rearview mirror. When driving close to the right side, ensure that the door handle in the mirror image just touches the right edge line of the road, keeping the right side of the vehicle approximately 30cm from the edge line. For a right right-angle turn, due to different observation distances and angles, when the mirror image shows the vehicle body or rear wheel is about two fingers' width from the roadside line, the left side of the vehicle should be approximately 30cm from the roadside line.

5

0

Share

What is the complete process of the simulated voice prompts for the Subject 3 driving test?

Voice prompts include: Please turn on the headlights, drive at night under conditions of poor lighting without streetlights, drive closely behind a vehicle in the same direction at night, and switch the headlights to high beam. Here are the detailed instructions: Please start and continue the test: Turn on the left turn signal (wait for more than 3 seconds before turning the steering wheel), press the clutch all the way down and shift to 1st gear, honk the horn, and release the handbrake. If starting on a slope, you can lightly press the brake with your right foot to prevent rolling back when starting. Look back to observe the traffic behind, confirm safety, then slowly release the clutch. When reaching the semi-engaged state, move your right foot from the brake to the accelerator, press the accelerator to add power, and start smoothly. After starting, turn off the turn signal. Voice prompt to change lanes: Turn on the left turn signal, look back to observe the traffic behind. After confirming safety, wait for the turn signal to be on for 3 seconds before turning the steering wheel. After completing, turn off the turn signal. (Note: Do not change lanes within 30 meters of an intersection).

1

2

Share

Is there a voice prompt for gear shifting in Subject 3?

There is no voice prompt for gear shifting in Subject 3, but there is a distance limit. Within the specified distance, you must shift from first gear to third gear, otherwise you will fail. The time for gear shifting in Subject 3 is usually one minute and thirty seconds. The driving distance using first and second gears should not exceed 500 meters. In the Subject 3 test, you start with first gear and can shift to second gear once the vehicle starts moving. When driving in second gear, accelerate to 20 km/h to shift to third gear. When the speed exceeds 30 km/h, you can shift to fourth gear. When turning halfway, accelerate to shift from second gear to third gear. After shifting to third gear, release the throttle. Once the turn is completed, the system will prompt you to shift down to second gear (you must complete the action within five seconds). Then, the system will prompt you to shift up to third gear again, also within five seconds. During the test, when you hear the voice prompt "Please complete the gear shifting action," you should adjust the gear to second gear, then sequentially shift up to fifth gear. In fifth gear, the speed must exceed 40 km/h, and then you should sequentially shift down to second gear. Gear and speed must match. Check the dashboard. When passing through school zones, you must be in third gear at speeds below 30 km/h. Using fourth gear or exceeding 30 km/h will result in failure. Remember to downshift when reducing speed. When shifting gears, press the clutch all the way down, shift gears, release the clutch, and accelerate. Do not release the clutch too quickly to avoid vehicle jerking. Do not skip gears when upshifting, and do not look at the gear lever when shifting.

14

2

Share

How many test sessions are there for Subject 1 in one day?

There are five test sessions scheduled for Subject 1 each day. The first session starts at 9:00, the second at 10:00, the third at 13:00, the fourth at 14:00, and the fifth at 15:00. Subject 1 does not limit the number of test attempts. Each test has two opportunities. If both attempts fail, you need to reschedule the test. The test process for Subject 1: Follow the staff's instructions and receive your driving training file in order at the waiting area; Bring and present your ID card for inspection by the supervising officer; Mobile phones must be turned off upon entering the test area; No loud talking is allowed in the test area; Regulation textbooks are not allowed in the test area (or should be kept in your bag); After the test, keep your ID card safe and submit the file to the "Document Submission Window" at the front of the test area; Candidates who pass the test will sign under the guidance of the staff at the exit and then leave the test area; Candidates who fail the test may leave the test area and wait for notification from their driving school regarding the retest time.

1

0

Share

Which car has a lion head logo?

The Peugeot logo features a lion head. Peugeot is an automobile brand under Peugeot Automobile Company, a subsidiary of the French PSA Peugeot Citroën Group. Its models include the Peugeot 5008, Peugeot 4008, Peugeot 3008, Peugeot 2008, Peugeot 208, Peugeot 408, etc. Taking the 2020 Peugeot 408 as an example: its body dimensions are 4750mm in length, 1820mm in width, and 1488mm in height, with a wheelbase of 2730mm. The 2020 Peugeot 408 is equipped with a 1.2L turbocharged engine, delivering a maximum horsepower of 136PS, a maximum power of 100kW, and a maximum torque of 230Nm, paired with a 6-speed dual-clutch transmission. The front suspension of the 2020 Peugeot 408 is a MacPherson independent suspension, and the rear suspension is a longitudinal trailing arm semi-independent suspension.

20

4

Share

How Many Cylinders Does the BMW 1 Series Have?

Is it mandatory to shift to 4th gear in Subject 3?

What is the trick for maintaining 30cm distance in right-angle turns?

What is the complete process of the simulated voice prompts for the Subject 3 driving test?

Is there a voice prompt for gear shifting in Subject 3?

How many test sessions are there for Subject 1 in one day?

Which car has a lion head logo?

Can Car Rims Be Repaired?

How Many Liters of Water Are Needed to Wash a Car?

Can I Cancel the Theft Insurance After Three Years of Purchase?

What are the brands of electric vehicles?