How many colors does the Baojun e100 have?

How early can a vehicle with semi-annual inspection be inspected in advance?

Vehicles requiring inspection every six months can also undergo annual inspection up to 90 days in advance. China's Road Traffic Safety Law clearly stipulates in its vehicle inspection regulations that annual vehicle inspections can be conducted on any working day within 90 days prior to the deadline. Whether it's biennial inspection, annual inspection, or semi-annual inspection, all are permitted to be conducted up to 90 days in advance. The first annual inspection for passenger cars is conducted when the vehicle reaches six years of age. Non-operational small and micro passenger vehicles, including family cars over 6 years but under 10 years old, require biennial inspection. For vehicles exactly six years old, the owner needs to drive the vehicle to the inspection station with ID card, vehicle license, vessel tax or tax exemption certificate, and compulsory traffic insurance policy for vehicle testing. After passing the inspection, a certification form will be issued, which along with the carried documents should be presented at the relevant window to obtain the annual inspection sticker.

17

5

Share

Where is the Touareg Water Temperature Sensor 2 Located?

Touareg water temperature sensor 2 is located inside the bumper at the front of the engine, in direct contact with the coolant. Below is more information about the water temperature sensor: 1. Principle of the water temperature sensor: The electronic control unit measures the temperature of the engine coolant based on this change. The lower the temperature, the greater the resistance; conversely, the smaller the resistance. The electronic control unit uses this change to measure the temperature of the engine coolant as a correction signal for fuel injection and ignition timing. The temperature of the engine coolant can be used to understand the operating state of the car, whether it is stopped or moving, or how long it has been running. 2. Structure of the water temperature sensor: There is a wire connected to the electronic control unit (ECU). The car water temperature sensor is installed on the water jacket of the engine block or cylinder head, in direct contact with the coolant, to measure the temperature of the engine coolant. The temperature sensor used in the coolant temperature gauge is a negative temperature coefficient thermistor, whose resistance decreases as the temperature increases.

1

Share

How Long After Sheet Metal Painting Can You Wash the Car?

In good weather, one week is sufficient; in cloudy weather, 15 days are recommended. Below is expanded information on precautions during the painting process: 1. Gun Adjustment: Before spraying, ensure the spray gun and related equipment are clean and in normal working condition. Check if the gun produces an ideal spray pattern. An ideal pattern should be symmetrical, with evenly distributed atomization and clear edges, with minimal overspray outside the pattern edges. Lower atomization pressure helps achieve correct, uniform spray patterns, reducing bounce and overspray. 2. Gun Handling: Maintain the spray gun perpendicular to the workpiece surface. The distance between the gun and the surface is typically 15~30cm, depending on the angle of the surface. For a wetter, darker, and thicker coat, reduce the distance; for a drier, lighter, and thinner coat, increase the distance. 3. Gun Movement: This includes the angle of the gun to the surface and its speed. Keep the gun at a right angle to the surface and move it parallel at a constant speed of 30~60cm/s. Tilting the gun or moving it in arcs or at variable speeds will result in uneven paint thickness, leading to streaks and blotches.

3

2

Share

How to distinguish the inner and outer sides of Giti tires?

There are three methods to distinguish the inner and outer sides of Giti tires. Below is a detailed explanation of these three methods: 1. Symmetrical tread tires: There is no distinction between front, back, left, right, inside, or outside during installation. The side with the production date should be placed on the outside. 2. Asymmetrical tread tires: During installation, the side marked with the word "outside" should be placed on the exterior. 3. Unidirectional tread tires: There is no distinction between inner and outer sides during installation, but the side with the production date should be placed on the outside. However, the tire must be installed in the direction indicated by the arrow, which represents the rolling direction of the wheel. Installing unidirectional tires incorrectly can reduce grip, create uneven resistance on both sides, diminish braking effectiveness, cause the vehicle to pull to one side, result in unstable steering, and hinder water drainage during rainy conditions, leading to potential safety hazards. If tires are installed incorrectly, the vehicle's comfort will be affected, and wear will accelerate more quickly than under normal conditions.

1

0

Share

Can You Release the Clutch in First Gear?

You can fully release the clutch when driving in first gear. However, the clutch should be released slowly in first gear. Once the car starts moving, you can release it completely. Since first gear provides a relatively high output torque, releasing the clutch gradually helps prevent the car from jerking forward or stalling. Steps for starting a car: Fasten the seatbelt and adjust the seat; quickly press the clutch pedal to the floor and shift into first gear; turn on the indicator, check the surroundings, and release the handbrake; quickly lift the clutch to the semi-engaged position, pause slightly, then slowly release the clutch while gently pressing the accelerator to ensure a smooth start. Correct clutch operation when shifting gears: Avoid keeping the clutch in a semi-engaged state for extended periods. Some drivers have the bad habit of unconsciously resting their foot on the clutch pedal, keeping it semi-engaged while driving. The left foot should be moved away when the clutch is not in use, as prolonged semi-engagement accelerates clutch wear. Fully depress the clutch before shifting. If the clutch pedal is not fully pressed down when shifting, it can cause a "gear grinding" phenomenon, which can severely damage the transmission over time. Only press the clutch pedal when braking at speeds below 20km/h. Pressing the clutch at higher speeds does not aid braking effectiveness. However, during emergency braking, both the brake and clutch should be pressed simultaneously.

9

2

Share

Are Out-of-Town New Energy Vehicle License Plates Subject to Traffic Restrictions?

Out-of-town new energy vehicle license plates are subject to traffic restrictions. Below is an introduction to the process of purchasing license plates for new energy vehicles: Obtaining Temporary License Plates: After selecting the vehicle at the 4S dealership and paying the final installment, you can purchase insurance at the insurance counter within the 4S store. Then, with all the necessary documents in hand, proceed to the nearest traffic management bureau to obtain temporary license plates. For the first-time application, choosing a bureau close to the 4S store is sufficient. Business Verification: Business verification, also known as business filing, is the process where the local Administration for Industry and Commerce records and files the newly sold vehicle for future reference. If the purchased new vehicle hasn't undergone business verification before the inspection and license plate registration, it won't affect the subsequent inspection and registration process. After obtaining the temporary license plates, return to the 4S store to drive the vehicle for business verification. Tax exemption certificate for vehicle purchase tax, online license plate self-selection: To self-select license plates online, you need to register and choose a number on the Public Security Traffic Safety Comprehensive Service Management Platform.

13

3

Share

How many colors does the Baojun e100 have?

How early can a vehicle with semi-annual inspection be inspected in advance?

Where is the Touareg Water Temperature Sensor 2 Located?

How Long After Sheet Metal Painting Can You Wash the Car?

How to distinguish the inner and outer sides of Giti tires?

Can You Release the Clutch in First Gear?

Are Out-of-Town New Energy Vehicle License Plates Subject to Traffic Restrictions?

How to Add Windshield Washer Fluid to Jetta VS5?

How to Turn and Return the Steering Wheel?

What Causes Occasional Slight Idle Shaking in Camry?

How to Remove the Daytime Running Lights on a Volvo XC60?