How Many Class Hours Are There for Driving Test Subject 2?

2 Answers
VanJaxon
09/01/25 2:24am
C1 driver's license Subject 2 requires 16 class hours, while C2 driver's license Subject 2 requires 14 class hours. Examination Content for Subject 2: Subject 2, also known as the small road test, consists of five assessment items: reversing into a garage, parallel parking, stopping and starting on a slope, turning at a right angle, and driving through an S-curve. In some regions, there is a sixth item: high-speed toll card collection. Important Notes for Subject 2 Test: During the preparation before getting into the car, you must adjust the seat and fasten the seat belt before verifying your fingerprint; each test item in the examination area is monitored by GPS positioning. The control line (yellow dotted line) for each item represents the examination area for that item. Once the front of the vehicle crosses the control line, it means you have entered the examination for that item and must complete the test according to its rules; before proceeding to the next test item, always check if there is a vehicle ahead still undergoing the test. If there is a vehicle in the test area ahead, you must stop and wait before the yellow line of that item and must not enter.
Was this review help?
7
5
Share
CaydenAnn
09/13/25 5:22am
In my experience, the required hours for Subject 2 are usually quite strict, typically ranging between 10 to 16 hours depending on local regulations, but the exact number depends on the driving school and local DMV requirements. The allocated hours cover key skills practice such as reverse parking, parallel parking, and hill starts, with each item having a specific time proportion—for instance, reverse parking usually takes up the bulk. Insufficient practice hours often lead to mistakes among trainees. I've instructed many students, and shorter practice hours increase their stress levels, resulting in lower pass rates. Therefore, I recommend not rushing to cut down practice hours when learning to drive—completing the full hours diligently ensures safety. Nowadays, some regions have even increased practice hours for intensive training, reflecting the growing emphasis on road safety.
Was this review help?
15
4
Share
Expand All
More Forum Discussions

Can You Start the Engine in P Gear for an Automatic Transmission?

You can start the engine in P gear for an automatic transmission. Starting in P gear and passing through R gear without stopping will not cause damage to the transmission. An automatic transmission refers to a car's automatic gear-shifting mechanism, where the control system of the automatic transmission selects the appropriate gear based on the engine's speed and load during driving, eliminating the need for the driver to manually shift gears. The gears for an automatic transmission car are as follows: 1. P gear stands for Parking and Starting gear. When the gear is in this position, the wheels are mechanically locked to prevent rolling; 2. R gear stands for Reverse gear, used when reversing; 3. N gear stands for Neutral gear, used for temporary parking. To prevent the vehicle from rolling on a slope, it is important to step on the brake when using this gear; 4. D gear stands for Drive gear, used when the vehicle is moving forward; 5. L gear stands for Low gear, used when going downhill or descending a long slope. Engaging this gear allows the use of engine power for braking, avoiding the danger of overheating brake pads due to prolonged braking; 6. S gear stands for Sport mode, allowing free gear switching when engaged.
13
0
Share

How to Deal with Wax Marks Left by Polishing?

Spray a small amount of adhesive remover onto a clean cloth. Use the cloth with adhesive remover to wipe the areas with wax residue, applying slight pressure during the process. Rinse thoroughly with clean water. After the first rinse, use deionized water for the second wash. After the first wash, spin dry with a spin dryer, then use deionized water for the second rinse.
8
5
Share

What to do if the headlights of Sagitar get water inside and fog up?

For relatively minor cases of moisture or water ingress inside the headlights, the fogging will usually dissipate as the heat from the headlights causes the moisture to evaporate and exit through the vent tube after the headlights have been on for a while. In cases of severe moisture or water ingress, the headlight assembly should be removed, the lens opened, and allowed to dry. After drying, inspect the condition of the headlight surface.
4
2
Share

How to Set the Seat Memory Function in Passat Lingyu?

Turn on the ignition switch; Press down the red "Memory-Off" button; Adjust the driver's seat and exterior mirrors to the most comfortable position, then press and hold one of the memory buttons on the left side of the driver's seat; Turn off the ignition switch and remove the ignition key, press and hold the unlock button on the key until you hear a "dong" confirmation sound indicating the setup is complete.
17
4
Share

How to Disable the Anti-Theft System When the GL8 Won't Start?

Use the reset button on the odometer to set the first digit to any number between 0 and 9. Press the odometer reset button to set the second digit of the password, then press the odometer reset button again to set the third digit of the password. Pull out the clock adjustment button on the instrument cluster while pressing the daily odometer reset button.
18
5
Share

How to Remove Car Paint from Plastic?

To remove car spray paint, you can use some solutions that have the effect of diluting the paint. If the car spray paint still cannot be removed, gasoline will be needed. First, apply gasoline to the affected area, and then wash it with soapy water.
17
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.