How many cars does Tesla produce in a day?

Is practicing Subject 3 on the road considered unlicensed driving?

Practicing Subject 3 on the road with a driving school instructor in a training car is a normal learning process and does not count as unlicensed driving. Additional information for the Subject 3 test includes checking the vehicle before getting in. Walk around the left side of the vehicle to the rear, then to the front, and finally to the driver's side door to prepare for the road test. Along the way, check whether the tire pressure is normal, if there are any stones stuck in the tires, any cracks, or nails. Also, inspect under and around the vehicle for any obstacles. The procedure for entering the vehicle requires standing about 45 centimeters away from the driver's door, facing the door, and aligning with the door handle. Use your left hand to hold the door handle, observe the traffic behind you, and only then open the driver's door. To start the engine, pull the handbrake, press the clutch pedal, and shift the gear lever to neutral. Slightly press the accelerator, turn the ignition switch to start the engine, and release the ignition switch promptly after starting. Check the brakes, listen for any unusual engine sounds, and monitor the dashboard instruments. After completing these checks, report to the examiner and ask for permission to start driving. During the Subject 3 test, it is important to inspect the vehicle's exterior and safety conditions in advance, ensure all lights are functioning properly, and strictly follow the test requirements—avoid crossing lines or exceeding speed limits.

9

5

Share

Can someone else go for the vehicle inspection on my behalf?

Vehicle inspection can be conducted by someone else on your behalf, as long as they have the vehicle's registration certificate and the compulsory traffic insurance policy for the current year. The agent needs to bring their own ID card, the vehicle owner's ID card, and driving license. Vehicle inspection process: Drive the vehicle to the inspection station entrance and wait for inspection; undergo a vehicle appearance check, assist the staff in filling out the motor vehicle appearance registration form, and take photos; proceed with payment and information registration; conduct the motor vehicle online inspection, followed by an internal performance inspection; after passing, complete the relevant procedures and receive the environmental protection label and annual inspection certificate. Vehicle inspection precautions: Documents. Essential documents required: Original and copy of the vehicle registration certificate, road and bridge fee IC card, road maintenance fee payment receipt, vehicle and vessel tax certificate, original insurance card, original ID card. Timing. Vehicles over 6 years old can apply for annual inspection within 3 months before the expiry date, but not after. Preparation. First, confirm if the vehicle has any traffic violations, as vehicles with outstanding violations will not be accepted by the vehicle management office. You can check for violations at the traffic police station. Vehicle appearance. Ensure safety devices such as the triangular warning sign and fire extinguisher are complete. Also, check if the vehicle's color and appearance match the photo on the registration certificate.

20

1

Share

What is the sequence of the 'Be cautious when reversing' voice prompt?

Regarding whether it's 'Reversing, be cautious' or 'Be cautious, reversing', the meaning is essentially the same—it primarily depends on how the recording was segmented during production. Detailed explanation: However, from a humanistic perspective, 'Be cautious, reversing' is more appropriate. As the saying goes, 'courtesy before action,' placing 'please' at the beginning sounds more polite. Moreover, due to the richness of the Chinese language, a single phrase often carries multiple meanings. The inventor of this voice prompt: Li Shufu, founder of Geely Auto. The story goes that Li Shufu was chatting with his brother who ran a restaurant when he noticed the dangerous reversing maneuvers of delivery tricycles. Inspired, he recorded a 'Be cautious, reversing' voice clip that drivers could play during reversing operations.

17

1

Share

What are the requirements for gear shifting?

The requirements for gear shifting are to start in first gear, shift to second gear when the speed reaches 10 km/h, shift to third gear when the speed reaches 20 km/h, shift to fourth gear when the speed reaches 30 km/h, and shift to fifth gear when the speed reaches 40 km/h. The gear shifting must be completed within 100 meters, and the gear sequence should be increased from low to high. Conditions for gear shifting: right first, then left. The right side is the accelerator and brake, while the left side is the clutch pedal. Whether shifting up or down, always start with the accelerator or brake on the right side, then match the speed before pressing the clutch pedal. Immediate action: After pressing the clutch pedal, act immediately. The left hand stabilizes the steering wheel, while the right hand quickly shifts gears. Left lift, right press like a seesaw: Coordinate the clutch and accelerator. Slowly lift the clutch, pause slightly at the semi-engagement point, and gently follow up with the accelerator without pressing too hard—it's like stepping on a seesaw. Speed range: First gear corresponds to 0-5 km/h. Second gear corresponds to 5-20 km/h, third gear corresponds to 20-40 km/h, fourth gear corresponds to 40-60 km/h, and fifth gear corresponds to 60-100 km/h. Precautions: First, know the location of the gear shifting section on the test route. Then, find a spot 20-30 meters before the gear shifting section. When the car reaches this 20-30 meter point, shift to second gear and accelerate to 27-29 km/h. Wait until the voice announcement for gear shifting operation is heard, then shift to third gear to minimize acceleration time. Releasing the accelerator and pressing the clutch must be well-coordinated. The moment the accelerator is released, immediately press the clutch to ensure the speed does not drop. If there is a delay between releasing the accelerator and pressing the clutch, the speed will decrease, which is not conducive to acceleration. After shifting to third gear, release the clutch smoothly. Avoid releasing the clutch too quickly, as this will cause the car to jerk.

18

1

Share

Which One is the Car Fog Light?

Fog lights generally refer to car fog lights. Car fog lights are installed at the front and rear of the vehicle. Front fog lights are typically bright yellow, while rear fog lights are red. The symbol for the rear fog light is slightly different from that of the front fog light—the light lines of the front fog light symbol point downward, whereas those of the rear fog light are horizontal. They are usually located on the dashboard inside the car. In foggy weather, both front and rear fog lights are typically used together. How to Turn On Fog Lights: Button-operated fog lights. Some vehicles have buttons to turn on the front and rear fog lights, usually located near the dashboard and labeled with fog light symbols. After turning on the vehicle's lights, pressing the front fog light button will activate the front fog lights, while pressing the rear fog light button will activate the rear fog lights. Fog lights are used for road illumination and safety alerts during rainy or foggy weather. Due to low visibility in foggy conditions, the driver's line of sight is limited. Fog lights can extend visibility, especially the strong light penetration of yellow anti-fog lights, which improves the visibility for both the driver and other road users, allowing oncoming vehicles and pedestrians to spot each other from a greater distance. Because anti-fog lights are bright and highly penetrating, they do not scatter due to fog, so proper use can effectively prevent accidents.

3

5

Share

Is it necessary to transfer the file for taking the fourth subject test in another location?

It is necessary to transfer the file for taking the fourth subject test in another location. If you encounter any issues, you can file a complaint with the transportation management bureau, the competent authority of the original driving school. The fourth subject test, also known as the theoretical test or driver's theory test, is part of the motor vehicle driver's license assessment. The test paper consists of 50 questions, mainly in the form of cases, pictures, and animations, with a full score of 100 and a passing score of 90. You need to bring your ID card to the vehicle management office in the city you are transferring to. Make sure it is a vehicle management office that can handle inter-city transfer services. Some cities have several branch vehicle management offices, but not all of them accept inter-city transfer applications. Therefore, it is advisable to call ahead and confirm whether the office can handle the transfer. To apply for the fourth subject test in another location, simply bring your ID card to the local vehicle management office at your current residence to complete the test location change procedure. There is no need to return to the original test location, nor is it required to submit additional documents such as residence permits or temporary residence permits. Additionally, the test location change can only be done once. After the change, all remaining subject tests and the license collection must be completed in the new city.

6

1

Share

How many cars does Tesla produce in a day?

Is practicing Subject 3 on the road considered unlicensed driving?

Can someone else go for the vehicle inspection on my behalf?

What is the sequence of the 'Be cautious when reversing' voice prompt?

What are the requirements for gear shifting?

Which One is the Car Fog Light?

Is it necessary to transfer the file for taking the fourth subject test in another location?

What is the time limit for the driver's license test?

Which Cars Use 95 Octane Gasoline?

Is It Necessary to Apply a Paint Protection Film to a Black Car?

How Many Points Are Deducted for Stalling on a Slope?