How many brake lights does the Tharu have?

1 Answers
TimothyLynn
07/30/25 4:35am
The Tharu has 1 brake light. Brake lights are generally installed at the rear of the vehicle, featuring a red-colored main body to enhance light penetration. This ensures that following vehicles can easily detect when the front vehicle is braking, even in low visibility conditions, thereby helping to prevent rear-end collisions. The Tharu is a compact 5-door, 5-seat SUV with dimensions of 4453mm in length, 1841mm in width, and 1632mm in height, and a wheelbase of 2680mm. It is equipped with a 1.4T turbocharged engine, delivering a maximum power of 110kW and a maximum torque of 250Nm, paired with a 7-speed dual-clutch transmission.
Was this review help?
12
3
Share
More Forum Discussions

Starting and Parking Sequence for the Tiguan L?

The Tiguan L is equipped with an electronic parking brake, which only requires pressing the electronic parking brake button during starting and parking. A detailed introduction to the starting and parking sequence for the Tiguan L is as follows: 1. Starting the Tiguan L: Turn on the ignition without starting the engine (wait for the self-check to complete), shift to N gear, start the ignition, and release the electronic parking brake. When starting the Tiguan L, first turn the ignition key to the second position (power mode) to allow the car's computer system to begin self-checking for at least 6 seconds. Then, press the foot brake, shift the gear from P to N, release the foot brake, turn the ignition key to the starting position to ignite the engine, press the foot brake again, release the handbrake, shift the gear from N to D, and slowly release the foot brake to successfully start the car. 2. Parking the Tiguan L: Shift the car to N gear, wait until the car is completely stationary, engage the electronic parking brake, turn off the engine in N gear, and finally shift to P gear. To park the Tiguan L, first press the foot brake to stop the car, then shift the gear from D to N, engage the handbrake, turn off the engine, release the foot brake (but do not turn off the power), confirm that the car is completely stationary under the handbrake's effect, press the foot brake again, shift the gear from N to P, finally release the foot brake, turn back the key, turn off the power, and pull out the key to successfully park the car.
5
1
Share

How to Solve Fogging on the Outside of Car Windows in Summer?

Fogging on the outside of car windows occurs because the air conditioning is turned on inside the car. The temperature difference between the inside and outside of the car causes this phenomenon. You can first turn off the air conditioning inside the car, as this will equalize the temperatures inside and outside, making it less likely for fogging to occur. More information on preventing fogging on the outside of car windows is as follows: 1. Turn on the recirculation mode inside the car: This enhances air circulation, which helps dissipate the fog. 2. Use the windshield wipers on the outside glass: This helps the defroster keep the windows clear and transparent. 3. Use glass cleaner to wash the windows: This can prevent fogging. 4. Anti-fog spray: One application can keep fogging at bay for about a month, and it can be used on both the inside and outside glass. 5. Use detergent: Mix a small amount with water to clean the glass inside and out, making it less prone to fogging.
17
3
Share

What is the solution for not deregistering a car after selling it as scrap metal?

If a car is directly sold as scrap metal without deregistration, it is necessary to go through the scrapping process at the vehicle management office. If the car is no longer in use, it must be scrapped at the motor vehicle scrapping center. Only after obtaining the relevant recycling certificate can the vehicle owner proceed to deregister the motor vehicle records. If a car is directly sold as scrap metal without deregistering the registration, it will affect the subsequent driver's license inspection, and the vehicle management department will suspend the registration of newly purchased vehicles. Additionally, if the vehicle is privately resold or dismantled without proper procedures, the owner will lose the right to register new vehicles. It is important to note that vehicles are not automatically deregistered. The vehicle owner must go to the relevant department to complete the deregistration process. According to the "Road Traffic Safety Law of the People's Republic of China," motor vehicles that meet the national mandatory scrapping standards cannot be privately dismantled or sold. The vehicle owner must go to a certified motor vehicle recycling company to fill out an application form and submit the vehicle registration certificate, license plate, and driving license. The recycling company will confirm the vehicle's identity before dismantling it and then issue a "Scrap Motor Vehicle Recycling Certificate" to the owner. The owner must then take this certificate to the vehicle management office to complete the deregistration of the vehicle records.
11
2
Share

What is the battery model for the BMW 7 Series key?

The battery model for the BMW 7 Series key is CR2032. CR2032 is a lithium manganese dioxide battery, named according to the IEC standard. The breakdown is as follows: C - Indicates a chemical battery system with lithium metal as the negative electrode and manganese dioxide as the positive electrode. R - Indicates the battery is cylindrical in shape; if it were square, F would be used instead. 20 - Indicates the battery diameter is 20mm. 32 - Represents the battery height of 3.2mm. The nominal voltage is 3.0V, with an endpoint voltage of 2.0V. The rated capacity varies between 200-240mAh, depending on the manufacturer's quality. The shelf life of a CR2032 battery is typically 5 years. However, if the manufacturer's production standards are low or quality control is poor, the lifespan may be significantly reduced. Domestic top-tier brands can generally guarantee this lifespan. Under ideal conditions (sealed, room temperature, no moisture, etc.), the lifespan can extend to 8 years or even 10 years. BMW models such as the 3 Series, 5 Series, and 7 Series all use the CR2032 battery for their keys. Replacing the key battery involves just three steps: Step 1: Remove the mechanical key. Press the latch on the side of the smart key to release the mechanical key. Step 2: Open the battery cover. After removing the mechanical key, you will notice two slots on the top of the smart key: a deep slot (keyhole) and a shallow slot (for opening the battery cover). Insert the mechanical key into the shallow slot and pry it open to reveal the coin cell battery. Gently remove the old battery. Step 3: Replace the battery. Insert the new battery, reattach the battery cover, and reinsert the mechanical key to complete the replacement. Two important notes when replacing the BMW 7 Series key battery: 1. The key uses a CR2032 coin cell battery—ensure you purchase the correct model. 2. Replace the battery quickly, as the key has a memory function. If power is lost for more than 5 minutes, the key will require reprogramming.
5
1
Share

What materials are needed for a driver's license medical examination?

For the driving school medical examination, you will need a recent one-inch white background photo, your ID card, a photocopy of your ID card, and some change. Below are the medical examination items: 1. Height requirements: To apply for large passenger vehicles, tractors, city buses, large trucks, or trolleybuses, the height must be at least 155 cm. For medium-sized passenger vehicles, the height must be at least 150 cm. 2. Vision requirements: For large passenger vehicles, tractors, city buses, medium-sized passenger vehicles, large trucks, trolleybuses, or trams, the naked or corrected vision of both eyes must reach at least 5.0 on the logarithmic visual acuity chart. For other vehicle types, the naked or corrected vision of both eyes must reach at least 4.9 on the logarithmic visual acuity chart. 3. Color vision requirements: No red-green color blindness. The actual driving school medical examination aligns with the vision requirements. 4. Hearing requirements: Able to distinguish the direction of sound with each ear at a distance of 50 cm from a tuning fork. 5. Upper limb requirements: Both thumbs must be intact, and each hand must have at least three other fingers intact, with normal limb and finger movement functions. 6. Lower limb requirements: Normal movement function. For applying to drive manual transmission vehicles, the difference in lower limb length must not exceed 5 cm. For automatic transmission vehicles, the right lower limb must be intact. 7. Trunk and neck requirements: No movement dysfunction.
19
4
Share

What to Do When ETC Expires?

Bring the ETC device and ETC card to the bank's ETC service outlet for inspection. For non-human-induced loosening or damage, the device can be reactivated or replaced for free. You can also log in to the ETC Express Card official website for service or call the ETC customer service hotline. Reasons for expiration include: self-removal or relocation of the OBU device; ETC running out of power; ETC electronic tag falling off or loosening. Below is relevant information about ETC: 1. Definition of ETC: ETC (Electronic Toll Collection), translated in Chinese as the electronic non-stop toll collection system, is an automatic toll collection system for highways or bridges. It uses dedicated short-range communication between the vehicle-mounted electronic tag installed on the vehicle's windshield and the microwave antenna in the ETC lane at the toll station, along with computer networking technology for backend settlement with the bank. This allows vehicles to pass through highway or bridge toll stations without stopping to pay tolls. 2. New ETC Application: Displaying an expired card is a normal condition. Without activation, pressing the ETC anti-tamper switch on the back will cause the red light to briefly illuminate, and the OLED display will show that the ETC tag is invalid, indicating the ETC electronic tag is not activated, which is normal. 3. Usage Process: The ETC pass card adopts a real-name system and can be reported as lost. The pass card holder must be the vehicle owner. During use, it is essential to ensure a one-to-one correspondence between the pass card, electronic tag, and the registered vehicle for normal use in the electronic toll collection system on highways within the networked area.
2
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.