How Long Does the Entire Subject 2 Test Take?

1 Answers
SanBrooke
07/30/25 10:09am
Subject 2 test typically takes about 15 minutes. Here is some relevant information about the Subject 2 test: 1. Subject 2: Also known as the small road test, it is part of the motor vehicle driver's license assessment. It is the abbreviation for the field driving skill test. For small vehicles C1/C2, the test items include five mandatory tests: reverse parking, parallel parking, hill start and stop, right-angle turn, and curve driving (commonly known as S-curve). Some regions may include a sixth item, highway toll card collection. 2. No time limit for the entire Subject 2 test: There is no stipulated time limit for the entire Subject 2 test. However, the reverse parking must be completed within 210 seconds (starting from engaging the reverse gear), otherwise it will be considered a test failure. Parallel parking must be completed within 90 seconds, otherwise it will be considered a test failure. For hill start and stop, the vehicle must start moving uphill within 30 seconds after stopping.
Was this review help?
15
0
Share
More Forum Discussions

What does the speed ratio of a car mean?

Car speed ratio refers to the transmission ratio of a car, which is the ratio of the rotational speeds of the two transmission mechanisms before and after the gearbox in the car's transmission system. Below is some content introduction about car speed ratio: The transmission ratio of a car's transmission system is divided into two types: the speed ratio of the main reducer and the speed ratio of the gearbox. The speed ratio of the main reducer is a fixed value, while the speed ratio of the gearbox varies depending on the gear used. The speed ratio data for various types of cars can be found in the car performance data manual. Extended content: Driving performance refers to acceleration, torque response of the power unit, noise, and vibration. Large-displacement engines provide greater, faster, and smoother torque responses. Front-engine front-wheel-drive transmission systems have better torque responses than front-engine rear-wheel-drive systems. 1. If the minimum transmission ratio is too small, the car will operate under heavy load, resulting in poor acceleration, noise, and vibration. 2. If the minimum transmission ratio is too large, fuel economy will be poor, and the engine will produce significant noise at high speeds.
1
3
Share

What Causes the Failure of the Focus Wiper Motor Module?

Focus wiper motor module failure is caused by motor burnout. Here are some precautions for using wipers: 1. Maintain hygiene: When there are streak marks on the glass surface, the wiper blade may be dirty. You can sprinkle alcohol on a towel and wipe the surface of the wiper blade. Cleaning once a month can improve the working efficiency of the wiper. 2. Check the rubber: If the wiper makes abnormal noises while working, it may be due to aging or cracks in the rubber strip. If the wear is not severe, you can use sandpaper to smooth out rough spots on the surface. 3. Avoid sunlight: Park the car in a shady place where it is not exposed to the sun, such as a garage. Summer is a season that is particularly harsh on cars. Wiper blades are rubber products, and exposure to sunlight will only accelerate the aging process. 4. Refill liquid: Directly adding water to the windshield washer fluid reservoir is not conducive to the maintenance of the windshield and wiper blades in the long run. To ensure the longevity of the components, always use formal windshield washer fluid. Refill the washer fluid in time to be prepared for unexpected needs.
14
2
Share

Where is the charging port of Volkswagen?

The USB port of the Volkswagen Lavida is located below the central control display. For older models of Lavida, the USB port is inside the armrest box. Some versions are not equipped with a USB port, so don't be surprised if you can't find one. Additional information: 1. Car USB: The car USB is a type of onboard transmission cable that supports hot-plugging. It has advantages such as flexible connection, ease of use, and independent power supply. It is a universal interface for USB devices like flash drives and MP3 players. The USB port in the Lavida also supports mobile phone charging and data transmission. Besides playing music via Bluetooth, you can also insert a USB flash drive into the USB port to play songs. 2. Precautions for car USB: With the increasing popularity of car multimedia systems, almost every car is equipped with a USB port. It is advisable to connect the USB flash drive or data cable when the vehicle is stationary to avoid misalignment or damage to the USB port due to body movements during driving. Improper use of the USB port can cause internal pins to bend or misalign. Most importantly, such damage is not covered under the manufacturer's warranty. To protect the car's USB port, please use flash drives and data cables with standard USB plugs from reputable brands.
13
0
Share

What are the differences between Harley and Indian motorcycles?

Indian and Harley differ in the following aspects: 1. Engine quality differs: Indian uses joint-venture brand engines, such as the universal SEG series engines, which are relatively reliable in terms of quality and stability. In contrast, Harley's engine and transmission quality stability is inferior to Indian's. 2. Brand influence varies: Harley typically relies on foreign automakers for technology and domestic manufacturers for labor, thus offering more technical assurance compared to Indian. Additionally, the extent of brand influence directly impacts the vehicle's resale value, with Indian's resale rate being significantly lower. 3. Motorcycle models differ: There is also a considerable gap between Harley and Indian in terms of models. Currently, Indian, leveraging its local advantage, better understands consumer needs, offering greater advantages in motorcycle space, configuration, and pricing—essentially higher cost-performance. However, in the high-end motorcycle segment, Indian cannot compete with Harley. 4. Performance differs: Harley tends to develop its powerful engines without advocating for extreme modifications. The TwinCam 88 and TwinCam 88B engines have already secured a place in the company's reputation; the powerful Revolution engine in the V-Rod motorcycles is leading Harley-Davidson motorcycles on a journey they've never experienced before.
11
5
Share

What aspects should be paid attention to when buying a car?

When buying a car, the following issues should be noted: 1. The vehicle identification number, engine number, chassis number, whether it is a manual or automatic transmission, and the documents for vehicle delivery must not be missing. At the same time, clarify the price, including the ex-factory price and other fees, to prevent dealers from playing tricks. 2. Pay attention to the details marked on the contract. Many contracts now state at the end that all interpretation rights belong to the dealer, which is very unfair to consumer rights. However, there is no choice, as dealers will not sell the car without signing the contract. Therefore, in the car purchase contract, issues such as car maintenance charges, delivery method, location, time, and whether the responsibilities of both parties are equal in terms of breach of contract must be clarified. 3. The stamps on the car purchase contract, invoice, and other documents must be consistent. If purchasing an imported car, there may be inconsistencies in the stamps, indicating that the imported car was bought from abroad by multiple dealers contributing parts of the money. This not only increases the price but is also very unfavorable to consumer rights. 4. When everything is arranged properly and ready for vehicle pickup, carefully inspect the condition of the car body. The condition of the car sold by the dealer to the consumer must be clearly understood.
7
5
Share

What Causes the Abnormal Noise from Motorcycle Disc Brakes?

Abnormal noise from motorcycle brake pads may be caused by rust or wear on the brake pads. Below is an introduction to abnormal noise in motorcycle brakes: Introduction to the causes of brake pad noise: Rust on the brake pads: If the motorcycle has not been ridden for a long time or the brake pads get wet and rust during riding, a sharp abnormal noise may occur. This noise usually disappears after using the brakes several times. Brake pad wear: Disc brake pads are prone to wear. When the brake pads are excessively worn, this phenomenon occurs. In this case, new brake pads must be replaced to prevent damage to the brake disc. Solutions for abnormal brake noise: Remove the brake pads and locate the limit spring plate, which is embedded in the caliper. Note the clips on the sides and remove them by hand or with a flathead screwdriver. Take out the spring plate and slightly bend its curvature upward with needle-nose pliers. Then, inspect the brake pad fixing screw, lightly sand it smooth with fine sandpaper, apply grease, and reinsert the brake pad. Since the curvature has increased, you may need to press the brake pad down by hand. Reinsert the brake pad fixing screw and reassemble everything as it was. Finally, apply a bit of grease to the fixing screws and tighten them.
7
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.