How Long Does Subject 3 Training Take?

2 Answers
DelNora
08/27/25 3:44am
According to the "Motor Vehicle Driver Training and Examination Syllabus," the total training duration for Subject 3 must reach 34 hours. This includes 24 hours of practical road driving skills training and 10 hours of safety and civilized driving theory training. Additionally, the daily training time must not exceed 4 hours. Subject 3 Examination Content: 1. Pre-driving Inspection: This involves walking around the vehicle once for inspection. The examination vehicle will have buttons installed at each of its four corners. During the inspection, all four buttons must be pressed to complete this step. 2. Lighting Test: To familiarize drivers with the use of vehicle lights in various nighttime conditions, candidates must follow the system's prompts to switch lights accordingly. 3. Straight-line Driving: This is a standard procedure: release the handbrake, shift into gear, slowly release the clutch until fully engaged, and then gently apply a small amount of throttle once the vehicle stabilizes at idle speed. 4. Lane Changing and Overtaking: When changing lanes, use the turn signal and remember to shift from 1st to 2nd gear when accelerating, avoiding excessively high RPMs. Ensure proper coordination between the accelerator and clutch during gear shifts to prevent gear grinding. 5. Approaching Schools, Bus Stops, and Intersections: Upon hearing these prompts, reduce speed and maintain it below 30 km/h, applying the brakes as needed. 6. Pulling Over: When parking, use the turn signal, observe traffic conditions behind you, and ensure the vehicle is not parked too far from the yellow line.
Was this review help?
12
2
Share
SanAndrew
09/09/25 2:52am
I just got my driver's license last year, and I remember the road test (Subject 3) required about 18 hours of training. Each session lasts around 60 minutes, and the driving school schedules the lessons where you practice basic operations like starting, changing lanes, and parking with the instructor on the road. You must complete all required hours before you can book the exam, otherwise, the system won’t allow it. I finished my training in three weeks, with five or six lessons each week—it felt quite intense, but I genuinely learned safe driving techniques, such as handling intersections and night driving. If you don’t complete the required hours, you can’t take the test, so I diligently attended all lessons and passed on my first attempt. My advice to new learners is not to slack off—make the most of this time to practice real skills instead of just clocking hours, because Subject 3 tests actual driving ability, which directly impacts your safety when driving alone later. More hours don’t necessarily mean better results; the key is effective learning.
Was this review help?
12
4
Share
Expand All
More Forum Discussions

How to Apply Color Change Film to BMW 1 Series?

Here is a detailed introduction on how to apply color change film to BMW 1 Series: 1. Color change film material. The color change film uses high-density vinyl film, which can adhere to the car body surface on top of the original paint, providing protection. Removing the film restores the original color. Additionally, the color change film not only allows for single-color coverage but also enables dual-color and multi-color splicing, and even supports custom painting to create various patterns. Importantly, the color change film isolates the car paint from the air, effectively preventing acid-base corrosion and oxidation. 2. Functions of car body film. (1) Adds a protective layer to the car body, shielding the paint from sun, rain, and scratches from sand and stones. The color change film fully covers the car paint, isolating it from the external environment and protecting it from acid rain, UV rays, bird droppings, and tree resin. It also prevents scratches and wear from stones and dust. (2) Preserves the original paint color and gloss, slowing down aging and keeping the car looking new, thereby maintaining its value. Under the cover of the color change film, the car body remains fully protected from external damage. Even after several years, removing the film reveals the original paint still bright and new. (3) Eliminates the need for waxing, glazing, or coating. Simple cleaning is sufficient for long-term maintenance. Once the color change film is applied, regular basic cleaning is all that’s needed for comprehensive upkeep.
10
1
Share

Why are some car license plates green?

Some license plates are green because: Green license plates are a new type of plate specially designed by the state for easier differentiated management, used to quickly distinguish between traditional fuel vehicles and new energy vehicles. The format of green new energy license plates is: regional abbreviation plus area code letter plus pure electric or hybrid letter plus numbers. For small new energy vehicles, the first character of the special license plate uses the letters D or F (D represents pure electric new energy vehicles, F represents plug-in hybrid electric vehicles and fuel cell vehicles, which are non-pure electric new energy vehicles). For large new energy vehicles, the sixth character of the special license plate uses the letters D or F (D and F represent the same vehicle types as those for small new energy vehicle special license plates).
2
4
Share

Is the MG 5 a three-cylinder or four-cylinder engine?

MG 5 is equipped with a four-cylinder engine. The MG 5 comes with two engine options: a 1.5-liter naturally aspirated engine and a 1.5-liter turbocharged engine. The 1.5-liter naturally aspirated engine in the MG 5 delivers 120 horsepower and a maximum torque of 150 Nm, with the maximum power achieved at 6,000 rpm and the maximum torque at 4,500 rpm. Here are some precautions for using a car engine: 1. Avoid coasting in neutral: The engine itself has a deceleration fuel cut-off function, and coasting in neutral is not conducive to fuel economy. 2. Pay attention to observations while using the vehicle: If you notice oil on the ground, determine whether there is an engine oil leak and promptly communicate with the car dealership to eliminate potential safety hazards. 3. For vehicles equipped with a turbocharger: Do not turn off the engine immediately after high-speed driving or climbing a slope; let it idle for 10 minutes before shutting it down. Turbocharged vehicles accumulate carbon deposits several times faster than naturally aspirated vehicles. 4. If brake fluid is contaminated with water or impurities: Or if you notice sediment in the brake fluid, replace it promptly or filter it carefully. Otherwise, it may lead to insufficient braking pressure, affecting braking performance.
18
2
Share

Does the Volkswagen Polo have a reversing camera?

The Volkswagen Polo does not come with a reversing camera, but it can be installed as an aftermarket accessory. A reversing camera uses a wide-angle infrared camera installed at the rear of the vehicle, displaying a clear view of obstacles behind the car on an in-car screen. The reversing camera is also known as a parking assist system, reverse visual system, or vehicle monitoring system, and is widely used in various large, medium, and small vehicles for reversing or driving safety assistance. The Volkswagen Polo features a MacPherson strut front suspension and a semi-independent non-drive axle rear suspension. It is powered by a 1.5L naturally aspirated engine, which delivers a maximum power of 83 kW and a maximum torque of 145 Nm.
4
3
Share

What Does Vehicle Suspension Stiffness Adjustment Mean?

Vehicle suspension stiffness adjustment refers to the ability to manually adjust the softness or firmness of a car's suspension. However, with advancements in technology, the operational state of a car's suspension can now be adjusted automatically. The suspension system used in vehicles affects both comfort and handling. Suspension stiffness adjustment can be either manual or automatic. During driving, the driver can adjust the suspension's stiffness via buttons inside the car. At high speeds, the suspension can become firmer to enhance the vehicle's stability. When driving on bumpy roads, the suspension softens to filter out minor vibrations, thereby improving comfort. During high-speed cornering, the shock absorber's resistance automatically increases to reduce body roll.
20
1
Share

Is Overtaking Allowed at Pedestrian Crossings?

Overtaking is not permitted at pedestrian crossings. When vehicles are traveling in the same lane, the following vehicle should maintain a safe distance from the vehicle ahead to allow for emergency braking. According to Article 47 of the Road Traffic Safety Law of the People's Republic of China: When passing through a pedestrian crossing, motor vehicles should slow down; if pedestrians are crossing, the vehicle must stop and yield. On roads without traffic signals, motor vehicles must yield to pedestrians crossing the road. When overtaking, the driver should first turn on the left turn signal, switch between high and low beams, or sound the horn. On roads without a center line or with only one lane in the same direction, the vehicle ahead should reduce speed and move to the right to allow overtaking when safe. The overtaking vehicle should pass on the left after ensuring a sufficient safe distance and, after establishing the necessary distance, turn on the right turn signal and return to the original lane. According to Article 43(4) of the Road Traffic Safety Law of the People's Republic of China, overtaking is prohibited under the following circumstances: When the vehicle ahead is making a left turn, performing a U-turn, or overtaking; When there is a possibility of encountering oncoming traffic; When the vehicle ahead is an emergency vehicle such as a police car, fire truck, ambulance, or engineering rescue vehicle performing urgent duties; When passing through areas with no safe overtaking conditions, such as railway crossings, intersections, narrow bridges, curves, steep slopes, tunnels, pedestrian crossings, or sections of urban roads with heavy traffic.
16
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.