How Long Do Car Tires Last?

How to Open the Fuel Tank Cap of Changan Oushang?

With the vehicle unlocked, simply press the fuel tank cap by hand to open it. Note that the fuel tank cap must be opened when the car is unlocked. The fuel tank cap is controlled by a switch button inside the car. Press the fuel tank switch button directly to open it. The electronic button is located on the left front door panel or on the center console. Alternatively, use the key to unlock the fuel tank cap directly. Some cars have a press-type or flip-open cap; after opening the cap, use the mechanical key to unlock it.

20

4

Share

How to Replace the Front Bumper of Changan Oushang X5?

Pry open the clips on the grille, then hold the left and right sides of the front grille with your hands and gently pull outward to separate the front grille from the front bumper. Remove the upper, lower, left, and right screws of the front bumper. Use a flathead screwdriver to pry open the clips securing the left and right sides of the front bumper. Hold the corners of the front bumper with your hands and gently pull outward to separate the front bumper from the vehicle body. Disconnect the wiring harness connectors for the fog lights on both sides.

14

4

Share

What is the normal tire pressure for Mercedes-Benz E-Class?

The tire pressure for Mercedes-Benz E-Class should be between 2.4-2.5 bar. Due to seasonal factors, the tire pressure can be increased by 0.2 bar in winter and decreased by 0.1 bar in summer. This data is based on the international standard GBT2978-2008. The tire pressure of the Mercedes-Benz E-Class is displayed on the multifunction screen, between the two dials. It will show the tire pressure and issue a warning if the pressure is too high or too low. The standards for too high or too low are based on the safe tire pressure set by the owner. Generally, a tire pressure exceeding 2.8 bar is considered too high, and a tire pressure below 2.0 bar is considered too low. Hazards of overinflated tires: Reduced friction and adhesion of the tires, affecting braking performance; causes steering wheel vibration and deviation, reducing driving comfort; accelerates localized wear of the tread center, shortening tire lifespan; increases vehicle vibration, indirectly affecting the lifespan of other components; overstretches the tire cords, reducing elasticity and increasing the load on the vehicle during driving. Hazards of underinflated tires: Increased friction coefficient with the road surface, leading to higher fuel consumption; causes heavy steering and deviation, posing safety risks; increases movement of tire parts, leading to abnormal heat due to excessive rolling; reduces the functionality of cords and rubber, causing delamination or cord breakage and excessive friction with the rim, damaging the tire bead and causing abnormal wear; multiplies friction between the tire and the ground, sharply raising tire temperature, softening the tire, and drastically reducing strength. High-speed driving may lead to tire blowouts. If the tire pressure monitoring indicator lights up (a yellow symbol, an irregular circle with no seal on top and four small spikes at the bottom, with an exclamation mark inside), there are generally three possible reasons: Abnormal tire pressure: Usually, an alarm is triggered when the pressure is below 1.8 bar or above 3.0 bar. In this case, the tire needs to be checked and the pressure adjusted. Tire pressure monitoring not reset: After inflating the tires, if the tire pressure is not reset in time, the system still records the previous data, causing the indicator to light up. Simply reset the tire pressure. Damaged tire pressure sensor: The tire pressure sensor, installed inside the tire and connected to the inflation valve, monitors tire pressure. If the sensor is damaged during driving, the tire pressure warning light will illuminate. For sensor damage, the only solution is to replace it with a new one.

6

3

Share

How to Start and Ignite a Changan Automobile?

Ensure the gear lever is in the P or N position. Do not start moving immediately after the engine starts. When pulling the gear lever out of the P position, press the brake pedal and press the lock button on the gear lever. When shifting from N to R, R to P, or 2 to L, the lock button must be pressed; otherwise, the gear lever will be locked and cannot be moved. When starting to move, press the brake pedal, shift the gear lever to the D position, release the handbrake first. There is no need to press the accelerator; as long as the foot brake is fully released, the car will start moving.

19

5

Share

What causes the ABS light to illuminate in a Touareg?

There are multiple scenarios where the ABS light may illuminate, with different causes and solutions for each state, as detailed below: State 1: ABS warning light remains constantly lit (most common scenario). Cause 1: The ABS wheel speed sensor's sensing area is contaminated by mud, sludge, or other pollutants, interfering with its ability to detect wheel speed signals. This prevents the ABS control module from determining vehicle speed or calculating wheel slip rates, consequently disabling its ability to issue appropriate braking commands. Solution: Clean contaminants from the wheel speed sensor and adjust the gap between the sensor and tone ring to restore normal function. Cause 2: Loose wiring connections or poor contact in ABS relays causing signal disruptions that trigger system faults. Solution: Inspect all wiring connections and securely reconnect any loose terminals. State 2: ABS warning light illuminates intermittently, extinguishing during acceleration. Cause: Battery voltage drops below 10.5V when multiple electrical systems are active. The light extinguishes as engine speed increases voltage. Possible low voltage supply to ABS system due to poor terminal connections or grounding issues. Solution: Check battery specific gravity; inspect charging system; verify power supply components (voltage relays or connection integrity). State 3: ABS warning light remains illuminated after engine start until ignition OFF. Cause: Poor ground connection at ABS hydraulic valve body; faulty wiring harness connector at valve body; ABS control module malfunction. Solution: Loosen and retighten valve body ground screw, cleaning contact surfaces if necessary; inspect connectors for excessive play; replace ABS or ABS/ASR control module if required. State 4: ABS warning light activates during high-speed driving. Cause: ABS control module detects excessive speed differential between front and rear wheels; incorrect tire or wheel rim specifications. Solution: Verify proper tire and wheel rim specifications as indicated on vehicle's fuel filler door placard. State 5: ABS warning light flashes intermittently. Cause: Improper brake light switch adjustment; internal contact failure in brake lights. Solution: With engine running, depress brake pedal while manually pushing brake switch linkage downward to reset position; replace brake light switch if defective. When the ABS warning light is illuminated, continued driving is not recommended. An active ABS fault indicates compromised anti-lock braking functionality. During emergency braking, wheel lock-up may cause uncontrolled skidding, preventing the driver from decelerating or maintaining vehicle trajectory, creating significant safety hazards.

15

5

Share

How to Start a Changan Car?

With the gear lever in the P or N position, do not start moving immediately after the engine starts. When pulling the gear lever out of the P position, press the brake pedal and press the lock button on the gear lever. When shifting from N to R, R to P, or 2 to L, you must press the lock button; otherwise, the gear lever will be locked and cannot be moved. When starting, press the brake pedal, shift the gear lever to D, release the handbrake first, and there is no need to press the accelerator. The car will start as soon as the foot brake is fully released.

2

1

Share

How Long Do Car Tires Last?

How to Open the Fuel Tank Cap of Changan Oushang?

How to Replace the Front Bumper of Changan Oushang X5?

What is the normal tire pressure for Mercedes-Benz E-Class?

How to Start and Ignite a Changan Automobile?

What causes the ABS light to illuminate in a Touareg?

How to Start a Changan Car?

How to Resolve Changan Keyless System Malfunction?

How to reset the maintenance reminder on Changan Raeton?

What to Do When the Changan Eado Car Key is Locked Inside the Car?

How to Remove the Headrest of a Changan Car Seat?