How Long Can You Drive with the Maintenance Warning On?

2 Answers
DeBella
07/24/25 12:31pm
There is no fixed answer to how long you can drive after the car prompts for maintenance; it could range from tens to hundreds of kilometers, as long as the vehicle does not experience any malfunctions. Below is some relevant information about car maintenance: 1. Brake Fluid Replacement: The brake fluid must be replaced every two years or 50,000 kilometers, and the brake warning system and brake booster should be checked. For manual transmission vehicles, the transmission gear oil should be replaced every 12 months or 5,000 kilometers. 2. Precautions: If the maintenance reminder light comes on, it is best to perform maintenance as soon as possible. If vehicle malfunctions are detected and resolved promptly, it can also help improve the vehicle's resale value.
Was this review help?
6
5
Share
CassandraAnn
08/11/25 6:36am
The maintenance light is on, and I must remind you: don't take it lightly. I once encountered this during a long drive—after the warning, I could still drive a few hundred to a thousand kilometers because the car's computer had a buffer in calculating the remaining oil life. But driving too long with it is risky. Once, I delayed for 3,000 kilometers, and the engine overheated, making strange noises. When I stopped to check, the oil had dried up, nearly causing me to break down on the road. The repair cost nearly 10,000 yuan. Now, whenever I see the light flash, I immediately note it in my phone and schedule maintenance. I suggest you don’t exceed 1,000 kilometers—book a professional inspection right away to prevent further wear. Driving safety comes first; don’t let a small delay lead to big trouble.
Was this review help?
2
2
Share
Expand All
More Forum Discussions

Does the Geely GS throttle need to be matched after cleaning?

After cleaning the throttle of the Geely GS, it needs to be rematched using a dedicated onboard computer. Throttle Introduction: The throttle is a controllable valve that regulates the air entering the engine, available in two types: traditional cable-operated and electronic throttle. The air entering the intake pipe mixes with gasoline to form a combustible mixture, which then burns to produce power. Connected to the air filter at the top and the engine block at the bottom, it is often referred to as the throat of the car engine. The responsiveness of the car's acceleration is related to the cleanliness of the throttle. Throttle Working Principle: In traditional engines, the throttle control mechanism operates via a cable or rod, with one end connected to the accelerator pedal and the other to the throttle linkage plate. The electronic throttle primarily uses a throttle position sensor to control the opening angle of the throttle based on the engine's power requirements, thereby regulating the amount of air intake.
2
4
Share

Which side is the three-cylinder engine on the Audi A6?

Audi A6's three-cylinder engine is arranged as 1-2-3 starting from the right side; cylinders 4-5-6 are on the left side. Body dimensions: The vehicle measures 5038 mm in length, 1886 mm in width, and 1475 mm in height, with a wheelbase of 3024 mm. It has a fuel tank capacity of 73 liters and a curb weight of 1800 kg. Powertrain: Equipped with a 2.0-liter turbocharged engine producing maximum power of 190 horsepower (140 kW) and peak torque of 320 N·m, paired with a 7-speed dual-clutch transmission. The front suspension features a five-link independent setup, while the rear suspension also uses a five-link independent configuration.
14
1
Share

Why is the car lock light flashing continuously?

Double flash switch damage, or internal malfunction, it is best to go to the repair shop for a computer diagnosis. If the anti-theft device does not make the original car's turn signal flash when locking or unlocking the door, the possible reasons are as follows: 1. Signal wire: The turn signal control signal wire of the installed anti-theft system is not properly connected. 2. Fuse: The fuse in the turn signal control wire of the installed anti-theft system is blown. 3. No signal: The installed anti-theft system control turn signal output has no signal. Regarding the indicator light not flashing, possible reasons include: 1. Lock/unlock signal: The installed anti-theft system does not detect the original car motor's lock signal or unlock signal. 2. Input fault: The ACC signal input in the installed anti-theft system is faulty. 3. Anti-theft system: The installed anti-theft system has failed.
15
5
Share

How to Deal with BMW ABS System Malfunction?

BMW ABS system malfunction solutions include removing dust and reconnecting the wheel speed sensor wiring. Cause 1: The sensing part of the ABS wheel speed sensor is covered by mud, sludge, or other contaminants, affecting the sensor's ability to detect the corresponding vehicle speed signal. This prevents the ABS computer from determining the vehicle speed and the wheel slip rate, thus failing to issue appropriate commands to adjust braking. Solution: Clean the dirt on the wheel speed sensor and adjust the gap between the sensor and the signal ring to restore normal function. Cause 2: Poor signal quality due to loose connections between system lines or poor contact of the ABS relay can cause system malfunctions. The most common issue is a loose connection of the wheel speed sensor wiring, which will also show as a poor wheel speed sensor signal in the ABS computer's fault memory. Solution: Check the wiring connections and reconnect any loose parts.
15
2
Share

Why Was the BYD Song EV Discontinued?

The BYD Song has a relatively short driving range, which is sufficient for daily commuting. However, if longer range is needed for specific purposes, its limited range becomes a concern, likely a key reason for its discontinuation. The performance specifications of the BYD Song are as follows: 1. Torque: The engine drives the front wheels, with a maximum power of 141kW and maximum torque of 320N/m. A permanent magnet synchronous motor is installed at the rear axle, delivering a total power of 180kW and maximum torque of 330N/m to drive the rear wheels. 2. Driving Range: The combined maximum power of the entire powertrain is 321kW, with a combined maximum torque of 650N/m, paired with a 6-speed dual-clutch transmission. The rear axle motor is powered by a 15.2kWh ternary lithium battery, providing an NEDC pure electric range of 81km.
13
1
Share

How much refrigerant should be added to the Baojun 730?

Baojun 730 requires approximately 500ml of refrigerant. Refrigerant, also known as coolant or freon, is a medium substance used in various heat engines to facilitate energy conversion. The function of the refrigerant is to use its own physical changes to remove heat from the car. Under high pressure, the refrigerant forms a liquid while releasing heat. Method to discharge excess refrigerant: Prepare an automotive refrigerant recovery and charging machine along with a refrigerant canister; connect the machine's pipelines to the high and low-pressure pipes of the car's air conditioning system; set the required amount of refrigerant to be recovered and start the recovery process. Effects of overcharging refrigerant: It can increase the pressure in the air conditioning system, trigger high-pressure alarms in the car's air conditioning, frequently interrupt the compressor's operation; reduce cooling efficiency; cause damage to air conditioning components; and lead to burst pipes in the car's air conditioning system.
1
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.