How Long Can a Car Sit Without Being Driven Before It Gets Damaged?

How to Resolve the Anti-Theft Authentication Failure in Landwind X7?

The following are the relevant solutions for the anti-theft authentication failure in Landwind X7: Press the one-button start to open the door and sit in the driver's seat, take out the remote key, and press it against the one-button start button for more than 30 seconds. Then, continue to press the remote key against the one-button start button and press the unlock button on the remote key. You can press it several times or press the lock button and trunk button a few more times. Pull the engine compartment opening handle. If you try several times and still cannot deactivate the alarm for the engine anti-theft system authentication failure, you can pull the engine compartment opening handle under the dashboard on the driver's side, get out of the car, walk to the front of the car, face the car logo, squat down, and look into the gap between the three chrome strips. Connect the battery's positive and negative terminals. Then, locate the positive and negative terminals of the battery, manually remove the plastic cover on the negative terminal, use an M12 external hex wrench to loosen the nut on the negative terminal clamp, remove the clamp from the terminal, wait for 1-2 minutes, and then reattach the clamp.

5

4

Share

What does Michelin tires mean?

Michelin tires: 1. Unidirectional tires: Mount the tire on the rim according to the rotation arrow indicated on the tire sidewall. The rotation direction on the tire sidewall should match the vehicle's forward direction. 2. Asymmetric tread tires: When mounting the tire on the rim, ensure the side marked with 'outside' faces outward. If the tire side has white raised letters or a sidewall protection layer, install that side outward. Additional information: According to Michelin's initial design for the 'Follow Me' program, it deliberately highlighted its terminal channels from the start. Consumers who purchase two tires at any Michelin 'Follow Me' authorized retail store can enjoy professional services provided by 'Follow Me,' such as free 24-hour roadside assistance and free puncture repairs.

11

1

Share

Should the Electric Vehicle Be Turned Off While Charging?

Electric vehicles should be turned off while charging. Charging without turning off the vehicle not only significantly slows down the charging efficiency but also reduces the battery's lifespan to some extent. When the remaining battery level cannot meet the mileage required for the next destination, you should find a nearby charging pile to charge. If time permits, it is advisable to choose slow charging mode; if time is urgent, fast charging mode can also be selected. However, it is essential to ensure the vehicle is turned off before charging. Insert the charging gun into the vehicle's charging port first, then start the charging pile. After charging is complete, turn off the charging pile before removing the charging gun. Battery maintenance methods: Avoid sudden acceleration while driving. Although pure electric vehicles can match sports cars in terms of 0-100 km/h acceleration performance, avoid sudden acceleration during startup, when carrying passengers, or going uphill. This is because rapid acceleration causes the battery to discharge at high current, leading to the formation of lead sulfate crystals, which can damage the physical properties of the battery plates and result in a sudden drop in speed and performance. Prevent the vehicle from being exposed to extreme heat or cold. Do not park a pure electric vehicle under intense sunlight for prolonged periods, as high temperatures can increase internal pressure in the battery, causing water loss, reduced battery activity, and accelerated plate aging. Conversely, do not assume that long-term parking in cold environments is harmless. Extremely low temperatures can also drastically reduce the vehicle's range and negatively impact the battery pack's performance. Many owners in northern regions report that during extremely cold winter temperatures, charging times are generally longer, and the range is significantly reduced. Master the correct charging time. Both undercharging and over-discharging can affect the battery's lifespan. Charge the vehicle according to its actual usage. If the battery indicator light comes on, charge it as soon as possible to avoid over-discharging, which can shorten the battery's lifespan. Typically, the average charging time for a battery is around 8-10 hours, and charging should not be excessively prolonged to prevent overcharging, which can cause the battery to overheat and reduce its lifespan. Develop a good habit of regular inspections. Whether it's a traditional fuel-powered vehicle or a new energy vehicle, it is essential to develop a routine inspection habit. If you notice a sudden drop in the range during driving—such as losing more than ten kilometers at once—it may indicate a battery issue. In such cases, take the vehicle to a 4S shop for inspection and repair immediately. Delaying can worsen the battery's degradation. Ensure the battery is fully charged when stored idle. If the vehicle needs to be parked for an extended period, do not assume it is acceptable to leave it in a low-charge state and recharge it when needed. This is incorrect because batteries left in a long-term low-charge state are prone to sulfation, where lead sulfate crystals form on the plates, severely damaging the battery. Therefore, even during long-term parking, maintain a certain charge level and ensure the battery is charged at least once a month.

7

3

Share

Do You Need a Driver's License to Drive an Electric Vehicle?

Driving an electric vehicle requires a driver's license. Here are the specific details about driving an electric vehicle: 1. Driving without a license: According to Article 99 of China's "Safety Law," driving a motor vehicle without obtaining a motor vehicle driver's license, or when the license is revoked or temporarily suspended, will result in a fine and may also lead to detention for up to 15 days. 2. Driving without a license plate: According to national regulations, electric vehicles must meet the relevant provisions of the "National Motor Vehicle Manufacturers and Products Announcement" issued by the Ministry of Industry and Information Technology, and must have a vehicle certificate, purchase invoice, tax certificate, compulsory traffic insurance, etc. Motor vehicles not listed in the "Road Motor Vehicle Manufacturers and Products Announcement" cannot be licensed as required.

19

5

Share

What are the reasons for the Mazda Ruiyi's inability to accelerate?

Reasons for the Mazda Ruiyi's inability to accelerate include uncleaned or faulty throttle, faulty spark plugs, clogged fuel injectors, and excessive engine carbon buildup. Uncleaned or faulty throttle: Check the air filter; if it is clogged, it needs replacement. The throttle also requires cleaning; otherwise, it may cause poor air intake, leading to reduced vehicle power. Faulty spark plugs: Inspect the spark plugs for severe carbon buildup. If the electrodes are burnt, poor sparking can result in unburned fuel, leading to reduced power and increased fuel consumption. Clogged fuel injectors: Issues with fuel injectors and engine oil, such as using substandard gasoline, clogged fuel injectors, or delayed oil changes with overly thick oil, can all cause a drop in power. Excessive engine carbon buildup: This causes the injected gasoline to be absorbed by the carbon deposits instead of entering the combustion chamber. Carbon buildup acts like a sponge, absorbing the sprayed fuel—the more fuel absorbed, the thicker the carbon buildup, and the weaker the car's performance. An endoscope can be used to check the extent of carbon buildup, and some older models may require a major overhaul to resolve the issue.

18

2

Share

What Causes a Motorcycle to Fail to Shift into Neutral When Stopped?

Motorcycle fails to shift into gear may be due to low shift pressure, poor hydraulic pump performance, blocked hydraulic lines, or shifting clutch malfunction. Low shift pressure: This prevents the shifting clutch from engaging properly, resulting in failure to shift into gear. Poor hydraulic pump performance or seal failure: Leads to insufficient hydraulic system oil pressure, causing the shifting clutch to slip and resulting in failure to shift into gear. Blocked hydraulic lines: Over time, mechanical impurities accumulate on the filter screen or filter element, gradually reducing the filtration cross-section and decreasing hydraulic oil flow, making it difficult to maintain pressure for the shifting clutch, causing it to slip. Shifting clutch malfunction: Damaged sealing rings causing leaks, worn piston rings, burnt friction plates, or deformed steel plates can all lead to the transmission failing to shift into gear. Note: If shifting into gear is difficult, first check the pressure indicated on the shift pressure gauge. If the pressure is low in neutral, it may indicate insufficient hydraulic pump oil supply pressure. In this case, pull out the dipstick to check the oil level in the transmission.

13

5

Share

How Long Can a Car Sit Without Being Driven Before It Gets Damaged?

How to Resolve the Anti-Theft Authentication Failure in Landwind X7?

What does Michelin tires mean?

Should the Electric Vehicle Be Turned Off While Charging?

Do You Need a Driver's License to Drive an Electric Vehicle?

What are the reasons for the Mazda Ruiyi's inability to accelerate?

What Causes a Motorcycle to Fail to Shift into Neutral When Stopped?

Will insurance cover engine water damage without wading insurance?

How many liters of engine oil does the Porsche 718 require?

What are the Three Guarantees Regulations for Electric Vehicles?

What is the fuel tank capacity of Guangben in liters?