How Long After Half a Beer Can You Drive?

Should You Release the Throttle When Using Paddle Shifters?

Should You Release the Throttle When Using Paddle Shifters? The detailed explanation of releasing the throttle during shifting is as follows: 1. When upshifting, release the throttle, depress the clutch, upshift, release the clutch, and press the throttle. When downshifting, release the throttle, depress the clutch, lightly apply the brakes, downshift, release the clutch, and apply throttle as needed. In all shifting operations, the throttle should be released. For manual transmission cars, shifting without releasing the throttle is significantly more difficult to perform. 2. When downshifting, release the throttle and lightly apply the brakes to control the vehicle speed within the range suitable for the target gear. Depress the clutch, engage the corresponding gear, and then gradually release the clutch. Downshifting is a deceleration process, but it doesn't mean completely ignoring the throttle pedal. After completing the shift and fully releasing the clutch pedal, you should immediately press the throttle pedal to achieve smooth power transfer. 3. It is possible to complete a shift while pressing the throttle pedal, but this will cause excessive wear on the clutch plates, which assist in the engagement and disengagement of the clutch. The release bearing will also endure greater impact, adversely affecting its service life.

20

2

Share

What Does BYD's Warranty Cover During the Warranty Period?

During the warranty period, as long as the vehicle owner uses the car normally under specified conditions and experiences any malfunctions or parts damage, the manufacturer will provide free repairs or replacement of corresponding parts. Generally, the warranty period for the engine and transmission is the same as the vehicle's warranty period, while the warranty for consumable parts such as batteries, air filters, cabin air filters, and timing belts is much shorter. Additionally, the vehicle's Maintenance Manual typically specifies that wear-and-tear parts like wiper blades, brake pads, clutch plates, tires, headlights, and glass are not covered under the warranty. BYD's battery warranty policy is divided into two parts: 1. The first part covers the battery cell, which enjoys a lifetime free warranty. The battery cell, composed of positive and negative electrode plates and separator paper as the main materials, is a non-directly usable electrochemical unit. It is the smallest unit forming the battery pack and the core component of the battery. 2. The second part includes components other than the battery cell, such as the casing, wiring, and circuit boards. The warranty duration for these parts is the same as that for the vehicle's second-tier core components, which is 8 years or 150,000 kilometers.

12

3

Share

What is the mileage and time for the first maintenance of SAIC Volkswagen?

SAIC Volkswagen's first maintenance mileage is 5,000 kilometers, and the time is six months. SAIC Volkswagen Automotive Co., Ltd. (referred to as "SAIC Volkswagen") is a Sino-German joint venture jointly operated by SAIC Group and Volkswagen Group. The company was signed and founded in October 1984 and is one of the long-established automotive joint ventures in China. The company's headquarters is located in Anting, Shanghai, and it has established production bases in Nanjing, Yizheng, Urumqi, Ningbo, Changsha, and other locations. For the first maintenance, you need to prepare the vehicle's driving license and purchase invoice. The first maintenance for a new car is usually required within 3,500 kilometers of driving or within six months of purchase, and one of these two conditions must be met. The vehicle's warranty certificate is also required. The warranty certificate includes a first maintenance card, which lists some free services for the first maintenance, and this card must be presented during the first maintenance. Before the first maintenance, it is necessary to make a phone appointment to confirm all the required documents and to avoid congestion and queuing. If the vehicle exceeds six months or 3,500 kilometers, a body inspection will be required during the first maintenance.

19

1

Share

Which model is the green Teana?

Teana green is the 19th generation Teana. Appearance of Teana: The 2021 Teana newly introduced red-black and white-black dual-color exteriors. Except for the entry-level 2.0L model, all models are equipped with 17-inch or larger rims, LED headlight groups, and LED daytime running lights. In addition, the model also launched a Phantom Package, which includes unique exterior accessories such as blackened rear emblems, front grille chrome trim, contours, rear spoilers, and Midnight personalized rear emblems. Power of Teana: The 2021 Teana offers a 2.0L naturally aspirated engine and a 2.0T turbocharged engine, paired with the new intelligent XTRONIC CVT continuously variable transmission equivalent to an 8AT gear range. The 2.0T model is equipped with a variable compression ratio turbocharged engine—VC-TURBO supercharged engine, which can intelligently and continuously switch the engine compression ratio between 8:1 (high performance) and 14:1 (high efficiency). The 2021 Teana can accelerate from 0 to 100 km/h in just 6.42 seconds, with a minimum fuel consumption of 6.6L per 100 km.

3

4

Share

Reasons for Loud Air Conditioning Compressor in Nissan Sylphy

Reasons for Loud Air Conditioning Compressor in Nissan Sylphy: Electromagnetic Clutch Issues: The compressor's electromagnetic clutch is a common source of abnormal noise. The compressor frequently operates under high loads, transitioning from low to high speeds, placing high demands on the electromagnetic clutch. Additionally, the clutch is typically installed close to the ground, often exposed to rain and dirt. When the bearings inside the electromagnetic clutch are damaged, abnormal noise occurs. Improper Tension of Compressor Drive Belt: If the drive belt is too loose, the electromagnetic clutch is prone to slipping. If the belt is too tight, the load on the electromagnetic clutch increases. Improper belt tension can lead to the compressor not working properly or even causing damage. If the compressor pulley and generator pulley are not aligned in the same plane during operation, it can reduce the lifespan of the drive belt or compressor. Repeated Engagement of Electromagnetic Clutch: Insufficient generator output, excessive pressure in the air conditioning system, or excessive engine load can cause the electromagnetic clutch to engage repeatedly. Incorrect Gap Between Electromagnetic Clutch and Compressor: If the gap is too large, the impact increases. If the gap is too small, the electromagnetic clutch may interfere with the compressor's mounting surface during operation. Lack of Lubrication in Compressor: When the compressor lacks lubricating oil or the oil is used improperly, severe abnormal noise can occur inside the compressor, potentially leading to wear and failure.

19

3

Share

What Causes Trembling While Driving?

Introduction to the causes of trembling while driving: The main fault reason is the increase of carbon deposits in the throttle, intake tract, valves and other parts. When the car is cold, some gasoline is adsorbed, and when the car is hot, this gasoline evaporates, causing the mixture to be too rich when the engine is idling, leading to unstable hot idling. The following are specific reasons: 1. Severe engine carbon deposits: The most common cause of car trembling is a dirty throttle or excessive carbon deposits in the fuel injector. When there is too much carbon deposit inside the engine, the gasoline sprayed by the cold start injector will be largely absorbed by the carbon deposits, resulting in a too lean mixture during cold start, making it difficult to start. 2. Ignition system problems: Check the working condition of the spark plugs, high-voltage wires, and ignition coils. Poor performance of the ignition system or bad spark plug firing can also lead to such faults. 3. Unstable oil pressure: If you have already cleaned the engine carbon deposits, washed the throttle, replaced the oil pads and spark plugs, etc., and still find the car body trembling when idling, it is recommended to go to a 4S shop to check whether the fuel supply pressure and the intake pressure sensor are normal. If the fuel pump supply pressure is abnormal or the intake pressure sensor value is wrong and working poorly, it will cause the car body to tremble. 4. Aging engine components: Car trembling is also related to the aging of engine mounts. Engine mounts are actually the shock absorption system of the engine, responsible for absorbing the slight tremors when the engine is running. If there is a problem with the engine mounts, these vibrations will be transmitted to the steering wheel and the interior of the car, causing trembling when idling.

1

3

Share

How Long After Half a Beer Can You Drive?

Should You Release the Throttle When Using Paddle Shifters?

What Does BYD's Warranty Cover During the Warranty Period?

What is the mileage and time for the first maintenance of SAIC Volkswagen?

Which model is the green Teana?

Reasons for Loud Air Conditioning Compressor in Nissan Sylphy

What Causes Trembling While Driving?

How Often Does the Panamera Undergo a Major Redesign?

What is the weight of a Jetta car?

At what mileage is a car generally scrapped?

Does Overfilling Volkswagen Antifreeze Have Any Impact?