How long after getting a driver's license can you use shared cars?

1 Answers
VanSerenity
07/29/25 11:59am
You can use shared cars after holding a driver's license for one year. Here is relevant information: Rental conditions: General car rental requirements are "being at least 18 years old and possessing two original certificates", meaning you can use shared cars as long as you have your ID card and driver's license. Amid the wave of the sharing economy, car rental platforms have emerged by deeply integrating mobile internet with car time-sharing rentals, breaking traditional car travel models to serve urban short-distance travel needs. Highway driving: Passing the driving test and obtaining a license means you can drive, but during the probationary period, you are not allowed to drive alone on highways. Highway driving requires accompaniment by an "experienced driver" who has held a same-level or higher license for at least two years.
Was this review help?
4
1
Share
More Forum Discussions

Does the Volkswagen Lamando 230 consume engine oil?

No, it does not consume engine oil. This is the third-generation EA211 engine. The Volkswagen Lamando 230 does not consume engine oil: The Volkswagen Lamando 230 does not exhibit engine oil consumption issues; it is a normal phenomenon of engine oil consumption. Reasons for engine oil consumption: During vehicle operation, engine oil does experience some consumption, but within a maintenance cycle, the oil level does not fall below the lower limit. There are many reasons for engine oil consumption, such as poor-quality gasoline, which can lead to carbon deposits in the engine during combustion. If these carbon deposits are not cleaned for a long time, they can cause the piston rings to become stuck, preventing them from properly scraping oil. As a result, oil remains on the cylinder walls. To address this issue, it is necessary to clean the carbon deposits thoroughly, which can help alleviate the problem of engine oil consumption.
16
5
Share

How Often Should You Add Antifreeze to Your Car in Summer?

Antifreeze should normally be replaced every two years or every 40,000 kilometers, whichever comes first. Precautions for replacing antifreeze: When replacing antifreeze, it is essential to completely drain the old antifreeze and clean the cooling system. This ensures no sediment or scale remains in the cooling system, which could otherwise affect the performance of the new antifreeze. Please note that antifreeze coolants of different brands and models should not be mixed, as differences in chemical compositions may render the antifreeze ineffective. Antifreeze is a coolant containing special additives, primarily used in liquid-cooled engine cooling systems. It offers excellent properties such as freeze protection, boil-over prevention in summer, year-round waterproofing, and corrosion resistance. Functions of antifreeze: It cools the engine by dissipating excess heat and prevents the cooling water in the pipes from freezing in winter, thereby avoiding engine block damage. Additionally, antifreeze provides anti-corrosion protection for cooling components and is an indispensable fluid for the engine.
18
5
Share

What RPM Should the Engine Reach for Hill Start?

Hill start requires the engine to reach around 1500 RPM. This RPM ensures sufficient power for uphill starts without causing engine shudder. In cold seasons, the engine may need higher RPMs to prevent stalling and warm up faster, but maintaining around 1500 RPM is ideal to minimize engine wear. Smooth hill starts depend on proper coordination between clutch and throttle. Otherwise, the engine may stall or the car could roll backward. The correct procedure: engage first gear, press the accelerator to 1500-2000 RPM (check tachometer), hold steady. Slowly release the clutch to the biting point, then slightly re-engage (just before actual biting point), while quickly releasing the handbrake to complete the hill start.
2
5
Share

What are the criteria for determining whether motor vehicle drivers yield to pedestrians at crosswalks?

Motor vehicle drivers yielding to pedestrians at crosswalks and the relevant legal regulations are as follows. At crosswalks without traffic signals, drivers should yield to pedestrians when they are crossing. Failure to do so may result in fines and penalty points. Even at crosswalks with traffic signals, drivers must yield to pedestrians, even if the pedestrians are crossing against the red light. As motor vehicle drivers, they should comply with regulations and slow down in advance when approaching a crosswalk, regardless of whether pedestrians are crossing, and proceed through the intersection at a safe speed. When vehicles are permitted to turn and pedestrians are crossing, turning motor vehicles must not obstruct pedestrians. According to Article 47 of the Road Traffic Safety Law, motor vehicles should slow down when approaching a crosswalk and must stop to yield if pedestrians are crossing. On roads without traffic signals, motor vehicles must give way to pedestrians crossing the road.
16
2
Share

How many meters is a tractor head truck?

According to regulations, the maximum length for a tractor head truck with railings is 14.6 meters, 17.5 meters for a flatbed, and 16.4 meters for a container. Introduction to tractor head trucks: A tractor head truck is another name for a trailer. A trailer can only form a complete transportation tool when combined with a tractor or other vehicles. Total weight of a tractor head truck: A tractor head truck that bears its total weight by itself is called a full trailer, usually referred to simply as a trailer. Its characteristics include no independent power, independent load-bearing, and reliance on other vehicles for traction. A trailer is a non-powered road vehicle designed and technically required to be towed by a motor vehicle for normal use, used for transporting people or goods, or for special purposes.
6
3
Share

What is the reason why the water temperature gauge of Tianjin truck key does not return to position in 1st gear?

The reasons why the water temperature gauge of Tianjin truck key does not return to position in 1st gear are as follows: Possible causes: It may be due to a broken power line of the water temperature gauge, burnt heating coil of the water temperature gauge, burnt heating coil or poor contact of the water temperature sensor, poor connection or broken wire of the water temperature sensor, or damage to the voltage regulator that supplies stable power to the water temperature gauge circuit. Function of the water temperature gauge: The water temperature gauge indicates the temperature of the coolant, but it also reflects the engine temperature. After all, the coolant is used to cool the engine. Therefore, if the water temperature is too high, the engine cannot operate normally. Conversely, if the water temperature is too low, it can also be a significant factor leading to higher fuel consumption.
1
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.