How large can the original Jimny tires be modified?

1 Answers
ElleMarie
07/30/25 1:10am
The original Jimny tires can be modified to 215/75R15. Steps for changing tires: Park the vehicle, turn off the engine, and engage the handbrake to prevent sliding; Loosen the screws in a diagonal manner; Lift the vehicle to a certain height; Remove the screws and take off the tire; Install the new tire and tighten the anti-theft screws diagonally; Lower the vehicle and tighten the screws and nuts. Precautions for changing tires: Pay attention to the front and back sides of the tire; The valve should also be replaced; Installation direction and inflation; It is best to install new tires on the rear axle of the vehicle; Avoid sudden braking after installing new tires; It is recommended to perform a four-wheel alignment when changing new tires.
Was this review help?
18
1
Share
More Forum Discussions

What Causes Intermittent Car Stalling?

Car stalling can be caused by a damaged fuel pump or clogged fuel injectors. Use of Low-Quality Fuel: Using low-quality fuel can lead to engine carbon buildup, resulting in stalling. Check the Fuel System: The fuel system, including whether the fuel pump is damaged, whether the fuel passages are clear, whether the fuel injectors are clogged, and whether the fuel pressure is normal, among other factors, can also cause the car to stall. Improper Operation: Lack of driving proficiency, where the driver's skills are not well-practiced or improper operation occurs, can also lead to car stalling. Solutions for Stalling: If the car stalls while coasting, first stabilize the steering wheel while applying slight braking. For manual transmission models, press the clutch, shift into the appropriate gear, then release the clutch to let the vehicle speed restart the engine. For automatic transmission models, shift into neutral and then restart the engine.
3
5
Share

What is the channel number for the intake manifold pressure of a Volkswagen?

Volkswagen fuel pressure data stream channel number is data stream group 140. Here is the relevant information: 1. Gasoline pressure: Depending on the model, gasoline pressure may vary. Most are around 300kpa, which is generally normal. Insufficient fuel pressure can cause difficulties in starting, stalling, and weak acceleration. 2. High-pressure direct injector: The high-pressure direct injector is supplied with high-pressure fuel by the high-pressure pump, which is then distributed to the high-pressure direct injector through the high-pressure fuel distribution pipe; low-pressure fuel is supplied by the high-pressure pump's guide connection device, and the fuel then enters the low-pressure fuel rail.
5
2
Share

What are the hidden features of the Beijing Hyundai ix25?

Hidden features of the Hyundai ix25 key: Press and hold the unlock button, and all four windows will roll down simultaneously; press and hold the lock button, and all four windows will roll up together. For high-end versions with a sunroof, the sunroof will also close. Below is related information: 1. Beijing Hyundai: Beijing Hyundai Motor Co., Ltd. (BEIJING-HYUNDAI-AUTO, referred to as "Beijing Hyundai") was established on October 18, 2002. It is the first Sino-foreign joint venture project in the automotive production field approved after China's accession to the WTO and has been designated as a flagship project and demonstration project to revitalize Beijing's modern manufacturing industry and develop the capital's economy. 2. Smart Key: The car's smart keyless entry system, abbreviated as PKE (PASSIVE-KEYLESS-ENTER), adopts the world's most advanced RFID radio frequency technology and the most advanced vehicle identity coding recognition system. It pioneers the application of a miniaturized, low-power RF antenna development solution and successfully integrates the remote control system with the keyless system, retaining traditional vehicle circuit protection. It truly achieves a dual RF system and dual anti-theft protection, providing maximum convenience and safety for car owners.
13
2
Share

Can You Pour Water on Overheated Brakes?

It is not advisable to pour water on overheated brakes. The working principle of brakes is introduced as follows: 1. Introduction 1: The working principle of brakes mainly comes from friction, using the friction between the brake pads and the brake discs, as well as the tires and the ground, to convert the kinetic energy of the moving vehicle into thermal energy after friction, thereby stopping the car. A good and efficient braking system must be able to provide stable, sufficient, and controllable braking force, and have good hydraulic transmission and heat dissipation capabilities to ensure that the force applied by the driver from the brake pedal can be fully and effectively transmitted to the master cylinder and each slave cylinder, and to avoid hydraulic failure and brake fade caused by high heat. 2. Introduction 2: The brake pads are the direct components that achieve braking, and the friction material's friction capability is very important. One is that the friction coefficient is not high, and the other is that the friction material is prone to thermal fade and ablation phenomena.
9
3
Share

What are the tips for successfully booking the B2 Subject 3 exam?

There is no way to increase the success rate of booking the B2 Subject 3 exam. The allocation of exam slots is determined based on the order of registration, and manual intervention in the booking results is not allowed. Below is relevant information about Subject 3: 1. Introduction to Subject 3: Subject 3 includes the road driving skills test and the safe and civilized driving knowledge test. It is part of the motor vehicle driver's license assessment and is the abbreviation for the road driving skills and safe and civilized driving knowledge test in the motor vehicle driver's examination. The content of the road driving skills test varies depending on the type of vehicle being licensed. 2. Test content of Subject 3: The driving skills test includes preparation before getting on the car, simulated lighting test, starting, driving in a straight line, gear shifting operations, changing lanes, parking by the roadside, going straight through intersections, etc. The safe and civilized driving knowledge test includes requirements for safe and civilized driving operations, safe driving knowledge under adverse weather and complex road conditions, etc.
4
0
Share

Why does the new Audi car display a 3000km oil change reminder?

Audi's new car displaying a 3000km oil change reminder is a manually set first maintenance notification, so there's no need to worry. Owners can follow the vehicle's manual for the first maintenance, adhering to whichever comes first between time and mileage. Car maintenance refers to the preventive work of regularly inspecting, cleaning, replenishing, lubricating, adjusting, or replacing certain parts of the vehicle, also known as car servicing. Modern car maintenance mainly includes the engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system, among others. The purpose of car maintenance is to keep the vehicle clean, maintain normal technical conditions, eliminate potential hazards, prevent faults, slow down the deterioration process, and extend the service life.
1
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.