How is the rear space of the Regal and the Atenza?

How to Unscrew Rusty License Plate Bolts?

Methods to unscrew rusty license plate bolts: 1. Use a rust remover to clean the threads, then try to unscrew it; 2. Prepare a flathead screwdriver and a Phillips screwdriver, each equipped with an angle grinder. Connect the angle grinder to the power source, plug it in, then hold the grinder's handle with both hands. Use your right hand to turn on the angle grinder's switch, and cut a straight slot on the license plate bolt cap with the angle grinder to remove it. For car owners without an angle grinder, you can try using needle-nose pliers or duckbill pliers to firmly grip the bolt ring. Once the bolt ring is deformed, release the pliers, then insert a flathead screwdriver into the deformed area and use inertia to remove the bolt cap. After removing the license plate bolts, be sure to clean up the bolts promptly and avoid littering, as they could potentially puncture the vehicle's tires.

18

0

Share

Vehicle Scrapping and License Plate Retention Process?

Apply within six months after completing the transfer or cancellation registration; the vehicle owner must have owned the original vehicle for more than three years; all traffic violations and accident liabilities related to the original vehicle must be settled. Can a vehicle be scrapped in a different location: According to Article 30 of the "Motor Vehicle Registration Regulations", if the vehicle is damaged and cannot be driven back to the place of registration, the owner may sell the scrapped vehicle to a recycling enterprise in the vehicle's current location. How long can a license plate be retained after vehicle scrapping: According to Article 43 of the "Motor Vehicle Registration Regulations", after completing the transfer or cancellation registration of a motor vehicle, the original owner may apply to the vehicle management office to use the original license plate number when registering a newly purchased vehicle. The application to use the original license plate number must meet the following conditions: (1) apply within six months after completing the transfer or cancellation registration; (2) the vehicle owner must have owned the original vehicle for more than three years.

3

Share

What Causes the Clicking Sound Outside the Car When Shifting an Automatic Transmission?

Automatic transmission shifting with abnormal sounds can be attributed to the following reasons: 1. Large valve clearance when the engine is cold: Poor lubrication during the transition from cold to hot engine state may cause noise when shifting, lasting about 3 minutes, which is a normal phenomenon. 2. Problems caused by parking on a slope: If the P (Park) gear is engaged first before applying the handbrake when parking on a slope, an external force due to inertia will cause the vehicle's weight to be entirely borne by the P gear, resulting in noise when shifting; if the handbrake is applied first, the handbrake bears the force, and no noise will occur. 3. Transmission issues: Wear and tear on the transmission, loose drive shaft, differential wear, wear on the transmission's output shaft, gear wear, or malfunctioning shift mechanism require immediate attention at a 4S shop or professional auto repair shop for technician repair.

15

0

Share

What do the three modes of Outlander 4WD mean?

The following is a detailed introduction to the three modes of Outlander 4WD: 1. The eco mode is used under normal driving conditions, which is relatively fuel-efficient and allows the vehicle to turn more smoothly. It is generally used when driving in urban areas, offering the best fuel economy. 2. The auto mode is typically used in rainy or snowy weather, where a noticeable increase in power can be felt. The downside is that the engine noise increases, and fuel consumption rises. It is generally used on rainy gravel roads, muddy roads, mountain roads, and highways. 3. The lock mode is the four-wheel-drive mode, used on rugged mountain roads, usually for escaping difficult situations or climbing steep slopes. The 4WD lock mode should not be used for extended periods, as it will significantly increase fuel consumption, engine noise, and temperature, causing considerable damage to the engine, transmission, and other drivetrain components, thereby shortening the vehicle's lifespan.

18

3

Share

Can I wear a skirt for the Subject 2 driving test?

Generally, it is not recommended to wear a long skirt while practicing driving, as it may easily get tangled with the clutch or brake pedals, posing safety hazards. Below are precautions for the Subject 2 test: 1. Reverse parking into a garage: (1) Ensure accurate alignment with reference points and lines, observing the distance between the car body and lines via rearview mirrors to avoid crossing boundaries. (2) Do not stop until the vehicle is fully inside the garage; control the clutch properly to prevent midway stops or incomplete parking. After entering the area, park at the designated spot, then reverse into the garage; exit towards another direction and repeat the process; finally exit towards the test area to complete the exam. 2. Parallel parking: (1) Maintain proper side distance when aligning with the garage to avoid crossing lines, and watch for not hitting garage corners when exiting. (2) Remember to activate turn signals when exiting. After entering the area, align parallel to the garage, drive to its front-left side, reverse into the garage from the right rear, then exit to finish the test.

17

1

Share

What is the relationship between Zeekr and Lynk & Co?

Zeekr and Lynk & Co both belong to the Geely Group. Here is an introduction to Lynk & Co and Zeekr: 1. Lynk & Co Introduction: Lynk & Co is a premium brand of the new era jointly established by Geely Holding, Geely Auto and Volvo Cars. Based on the CMA (Compact Modular Architecture) jointly developed by Volvo Cars and Geely Auto with Volvo Cars taking the lead, it was launched in Berlin on October 20, 2016, along with its first mass-produced model, the Lynk & Co 01. 2. Zeekr Introduction: Zeekr is jointly invested by Geely Auto and Geely Holding Group, with Geely Auto holding 51% of the shares and Geely Holding Group holding 49%. The new company plans to inject 2 billion RMB in cash, with Li Shufu serving as the chairman of Zeekr and An Conghui as the CEO of Zeekr.

5

0

Share

How is the rear space of the Regal and the Atenza?

How to Unscrew Rusty License Plate Bolts?

Vehicle Scrapping and License Plate Retention Process?

What Causes the Clicking Sound Outside the Car When Shifting an Automatic Transmission?

What do the three modes of Outlander 4WD mean?

Can I wear a skirt for the Subject 2 driving test?

What is the relationship between Zeekr and Lynk & Co?

Are Pure Electric Vehicles Afraid of Water Immersion?

Which country does the Wrangler brand belong to?

What to Do if a Volkswagen Car Burns Engine Oil?

What does R status on a driver's license mean?