How Early Can an Annual Vehicle Inspection Be Conducted?

1 Answers
EmiliaDella
07/29/25 3:04pm
An annual vehicle inspection can be conducted up to three months in advance. Before applying for the inspection, the vehicle owner must resolve all traffic violations and accidents related to the vehicle. The vehicle management office should, within one day of accepting the application, verify the vehicle, review the submitted documents and certificates, and issue the inspection compliance mark. Annual vehicle inspection is a mandatory test for every vehicle (motor vehicle) that has obtained an official license plate and registration certificate. Its purpose is to examine the main technical conditions of the vehicle, encourage enhanced maintenance and care, ensure the vehicle remains in good condition, and guarantee driving safety.
Was this review help?
18
1
Share
More Forum Discussions

What causes intermittent shaking in a Nissan 1.6 engine when hot?

Nissan 1.6 engine intermittent shaking when hot can be caused by the following reasons: Clogged fuel injectors: After prolonged use, fuel injectors may become clogged. One reason is the long-term accumulation of carbon deposits, which can block an injector and cause cylinder misfire symptoms. Another reason is the gradual aging of injectors due to prolonged exposure to high-pressure gasoline, leading to a series of issues. If a fuel injector is clogged, it may result in "cylinder misfire," causing intermittent shaking in the car. Ignition coils and cylinder wires: Each cylinder's spark plug corresponds to an ignition coil and cylinder wire. If these components fail, the spark plug won't fire, and the cylinder won't operate, leading to cylinder misfire symptoms. Cylinder misfire typically causes intermittent shaking in the car. Spark plugs: Spark plugs need to maintain an operating temperature between 450°C and 870°C. If the temperature falls below 450°C, carbon deposits can easily form, resulting in intermittent shaking.
13
3
Share

What causes the fault code after replacing the rear taillight on a BMW X5?

BMW X5 rear taillight fault code causes are as follows: Switch failure: Over time, switch wear, poor contact, corrosion, and aging can cause the rear taillights or headlights to not illuminate or have poor contact. Detection method: Set the multimeter to the 200V voltage range, locate the rear taillight headlight wire, and connect the two probes to the positive and negative terminals of the headlight wire. Turn on the power and switch to see if there is voltage displayed. If there is no display, the switch may be faulty. Find the headlight switch wire and use a wire or iron tweezers to short-circuit the switch wire. If it lights up, it indicates the switch is faulty. Bulb failure: Bulbs are mostly "filament-type" bulbs. Driving on uneven roads or prolonged use can easily cause the internal filament to break or fuse, resulting in no illumination. Detection method: Unscrew the rear taillight bulb and observe if the filament is broken. Rear taillights generally have two filaments, one for the headlight and one for the brake light. If one is broken, it could be the headlight or rear taillight.
2
0
Share

What Causes the Abnormal Noise in Honda 190?

Honda 190 abnormal noise causes: 1. Engine mount rubber aging or loosening: The engine mount rubber is the rubber block between the engine and the frame, used to reduce vibration during engine operation and secure the engine. Once the engine mount rubber ages or loosens, the engine will shake, causing abnormal noise. 2. Engine misfire noise: Engine misfire mainly refers to one or more cylinders not working properly, usually manifested as: intermittent exhaust gas flow from the car, severe shaking of the exhaust pipe, and clearly audible engine noise. This phenomenon is closely related to ignition coil failure. 3. "Piston slap" noise: Due to poor lubrication conditions, excessive wear of the piston and cylinder wall leads to the clearance fit tolerance between the piston and cylinder wall exceeding the normal range. During engine operation, the piston skirt impacts the cylinder wall, producing a clear "clanking" sound, which is more noticeable at idle or low speeds. 4. Overly rich air-fuel mixture: When the engine's air-fuel mixture is too rich, the symptoms are: difficulty starting the engine, uneven engine operation, black smoke from the exhaust pipe, accompanied by abnormal noise, and sometimes backfiring. 5. Carbon deposits, clogged filter: Engine power decreases, and fuel consumption increases.
5
1
Share

What brand is the Jimny?

Jimny (JIMNY) is a light ORV off-road vehicle produced by Suzuki of Japan. In terms of power, it uses a 1.3L naturally aspirated engine with a maximum power of 63kW and a maximum torque of 110Nm, featuring a body-on-frame structure, front and rear rigid axles, and a part-time four-wheel drive system. Jimny exterior: Some optimizations have been made to the front bumper, grille, and hood, though these changes are subtle and hard to notice without close observation. The fog lights have also been slightly modified, appearing somewhat larger in size. Additionally, Jimny has introduced a new body color called light blue metallic, offering consumers more choices. Jimny configuration: There are no changes in the powertrain, which still uses the same 1.3L naturally aspirated engine with a maximum power of 63kW and a maximum torque of 110Nm. Though small, the Jimny is fully equipped, with features like a body-on-frame structure, front and rear rigid axles, and a part-time four-wheel drive system, earning it a certain status among off-road enthusiasts. It is a car with excellent cost performance.
18
5
Share

What is the fuel tank capacity of the Elysian Hybrid?

The fuel tank capacity of the Elysian Hybrid is 50 liters, as officially announced. Owners who have purchased the Elysian Hybrid can also check this information on the vehicle's configuration sheet. The Elysian Hybrid uses 92-octane gasoline, with a fuel consumption of 6.1L per 100 kilometers. A full tank can provide a driving range of approximately 819 kilometers. During daily driving, it is essential to monitor the remaining fuel level in the tank. This is typically done by observing the fuel gauge inside the vehicle. Under normal circumstances, the fuel level will be accurately reflected on the gauge. The fuel gauge usually has 5 to 6 segments. It is recommended to refuel when only 2 segments remain to avoid running out of fuel midway. During actual refueling, the amount of fuel added may exceed the marked capacity. This is because the fuel tank capacity specified by the manufacturer is measured from the bottom of the tank to the safe fill level. There is additional space between the safe fill level and the tank opening, which is designed to accommodate fuel expansion due to temperature increases, preventing overflow. If fuel is filled up to the tank opening, the actual refueling amount may exceed the marked capacity.
18
1
Share

How Many Years Can a Geely Emgrand Generally Last?

According to its design standards, a car's normal lifespan is basically around 15 years. With good maintenance and care, it can last up to 20 years; if treated poorly and the condition deteriorates, it may last around 10 years. Minor maintenance at 10,000 kilometers: Oil filter, air filter, and fuel filter. Intermediate maintenance is at 20,000 kilometers, and major maintenance is performed every 40,000 kilometers. At 20,000 kilometers, maintenance includes replacing the engine oil, oil filter, air filter, and cabin air filter, along with some routine checks: Air filter: Proper installation of the air filter can reduce wear on parts such as cylinders, pistons, and piston rings. (Generally, clean every 5,000 kilometers and replace the air filter every 10,000 kilometers.) Oil filter: Proper installation of the oil filter can prevent impurities from mixing into the engine oil during use, thereby avoiding wear on moving parts and oil passage blockages. When replacing the engine oil, the oil filter must also be replaced; otherwise, it may affect the quality of the lubricating oil. The replacement cycle for engine oil and oil filter is generally every 5,000 kilometers.
6
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.