Highway Driving: Sport Mode or Eco Mode?

How many liters of engine oil should be added to the Roewe RX5?

According to the Roewe RX5's "Maintenance Manual", it is recommended to use 5W-30 full synthetic engine oil for the Roewe RX5, and 5L of engine oil can be added. Here is some introduction about the Roewe RX5: 1. The Roewe RX5 adopts the "Blue Core" high-efficiency power technology, equipped with two turbocharged direct injection engines: 2.0T and 1.5T. 2. The 2.0T engine has a maximum power of 220 horsepower and a peak torque of 350 Nm, with a minimum comprehensive fuel consumption of 8.1L per 100 km; the 1.5T engine has a maximum power of 169 horsepower and a peak torque of 250 Nm, with a comprehensive fuel consumption of only 6.8L per 100 km.

6

4

Share

Can You Drive a Car 2 Hours After Painting?

Generally, you should wait 24 hours after painting a car before driving it, but you can touch it after two hours. Below are the specific methods for painting: 1. Thinner: You can appropriately add the matching special thinner; in addition, adjust the spray gun pressure to a lower setting. The nozzle should be about 30cm away from the surface to be painted and sprayed vertically. 2. Hardener: Adding too much hardener may cause an orange peel effect, so the amount of hardener should be appropriately reduced. 3. Adjusting the boiling point: If the surface temperature or ambient temperature is too high, the thinner may evaporate too quickly after spraying, causing resin loss and uneven pigment distribution, leading to an orange peel effect. Adjusting the ratio of thinners with different boiling points can alleviate this issue.

13

3

Share

Can You Start the Engine While Charging a Car Battery?

You can start the engine while charging a car battery. Precautions for battery charging include: 1. In cold weather, check if the electrolyte is frozen before charging; do not charge a frozen battery. 2. Before charging, check the electrolyte level; do not charge if the electrolyte is insufficient. 3. During charging, measure the density and voltage of the electrolyte approximately every hour and monitor its temperature. The functions of the battery are: 1. To supply power to the starting system, ignition system, electronic fuel injection system, and car's electrical systems when starting the engine. 2. To provide power to the car's electrical equipment when the engine is off or at low idle. 3. The car battery acts as a voltage stabilizer for the entire electrical system. 4. The car battery stores excess electricity generated by the alternator.

8

0

Share

Does the number 8 on car glass represent 18 or 08?

Car glass with the number 8 represents 08. The labels on car glass use numbers to indicate the production year and dots to indicate the month. If the dot is placed before the number, it means the glass was produced in the first half of the year; if the dot is placed after the number, it means it was produced in the second half of the year. Here are some related details: 1. The safety glass used in cars is a product subject to mandatory national certification, commonly known as the "Square and Circle Mark," which is the most common and important symbol on car glass. There are also international certification marks, such as the U.S. "DOT" mark and the European ECE "E" mark, indicating that the product has been certified by these foreign regulatory bodies and can be exported abroad. 2. On car glass, the last string of symbols and numbers corresponds to the production year of the glass. The last row of numbers and symbols is "..8," where 8 represents the year, meaning 2008. If the dot is before "8," it indicates production in the first half of the year, calculated as "7 minus the number of dots." So, "...8" would be 7-1=6, meaning the glass was produced in June 2008. If the dot is after "8," it indicates production in the second half of the year, calculated as "13 minus the number of dots." For example, "8.." means the glass was produced in 13-2=11, or November. 3. Identifying the vehicle's manufacturing date: The Vehicle Identification Number (VIN) can be found below the windshield or on the left side of the dashboard. Although the VIN has 17 digits, the most important one to recognize is the 10th digit, which represents the vehicle's manufacturing year (W-1998, X-1999, Y-2000, 1-2001, 2-2002, etc.).

9

1

Share

What Causes Transmission Slippage?

Transmission slippage can be caused by the following issues: 1. Hydraulic oil level is too low. 2. Hydraulic oil level is too high, causing excessive air bubbles when vigorously agitated by the planetary gear set during operation. 3. Excessive wear or burning of clutch or brake friction plates and brake bands. 4. Excessive wear of the oil pump or leakage in the main oil circuit, resulting in excessively low oil pressure. 5. Slippage of the one-way overrunning clutch. 6. Damage to the piston seal rings of the clutch or brake, causing oil leakage. 7. Damage to the piston seal rings of the shock absorber, causing oil leakage. Here are some related steps for diagnosis: 1. For automatic transmissions exhibiting slippage, first check the hydraulic oil level. If the oil level is too low or too high, adjust it to the normal level and recheck. If the automatic transmission does not slip after adjusting the oil level to normal, no further repair is needed. 2. Inspect the quality of the hydraulic oil. If the oil appears dark brown or has a burnt smell, it indicates that the clutch or brake friction plates or the brake itself are burnt, and the automatic transmission should be disassembled for repair. 3. Conduct a road test to determine if the automatic transmission is slipping and identify the affected gear and the severity of slippage. Place the control lever in different positions and move the car. If the engine speed suddenly increases when the automatic transmission shifts to a certain gear but the vehicle speed does not increase accordingly, that gear is slipping. The higher the engine speed, the more severe the slippage.

14

2

Share

What is the actual range of the BYD e3 ride-hailing version?

The official released range of the BYD E3 is 305Km/405Km. In actual use, the range will decrease depending on driving habits and environmental conditions. The larger the fuel tank capacity, the more fuel it can hold, the longer and stronger the vehicle's range, and the farther it can travel, reducing the number of refueling stops. Here is more relevant information: 1. Range: Range can also be referred to as endurance capability, which is the total distance a vehicle or ship can travel continuously with maximum fuel reserves. For electric vehicles, the range refers to the distance traveled from a fully charged state of the power battery to the end of the test under standard conditions. It is an important economic indicator for electric vehicles. 2. The relationship between range and speed: Due to air resistance. When a car is running at high speed, most of the power is used to overcome air resistance. The magnitude of air resistance is determined by factors such as frontal area and speed. The higher the speed, the greater the air resistance, which increases electricity and fuel consumption, directly reducing the range.

1

0

Share

Highway Driving: Sport Mode or Eco Mode?

How many liters of engine oil should be added to the Roewe RX5?

Can You Drive a Car 2 Hours After Painting?

Can You Start the Engine While Charging a Car Battery?

Does the number 8 on car glass represent 18 or 08?

What Causes Transmission Slippage?

What is the actual range of the BYD e3 ride-hailing version?

Does the Mitsubishi Outlander meet the China VI emission standard?

Is the engine of the 2020 RAV4 domestically produced?

Can 92 Octane Gasoline Be Mixed with 95 Octane Gasoline?

How to Check China 5 and China 6 Standards?