Has the Volkswagen Scirocco Been Discontinued?

1 Answers
McDaniella
07/30/25 7:00am
Volkswagen Scirocco has been discontinued. It was a sports car launched by Volkswagen, also an imported vehicle primarily introduced to the Chinese automotive market through imports. The Scirocco featured front-wheel drive, ventilated disc brakes, and was powered by an L-type 4-cylinder 2.0-liter direct fuel injection engine. It offered two trim levels: "Sport" and "Luxury". In terms of body dimensions, the Scirocco measured 4248mm in length, 1810mm in width, and 1404mm in height, with a wheelbase of 2578mm. It came equipped with a rear parking radar system, six airbags, and an ESP electronic stability system.
Was this review help?
15
1
Share
More Forum Discussions

What are the symptoms of a faulty transmission solenoid valve in the Hyundai Elantra?

Faulty transmission solenoid valve in the Hyundai Elantra may cause symptoms such as gear shifting hesitation, inability to shift gears, or failure to move when shifted into D gear. Below are the relevant introductions: 1. Dual-clutch transmission: It is a product developed based on manual transmission. Its structure is similar to that of a manual transmission, but it has an additional set of clutch and gear-shifting control mechanism. 2. CVT transmission: It is an automatic transmission with a relatively simple internal structure, consisting of only two cone pulleys and a steel belt. The steel belt can move on the cone pulleys, allowing the transmission to change speed and torque. 3. AT transmission: It is an automatic transmission with a more complex internal structure, containing many planetary gears. The AT transmission relies on planetary gears to change speed and torque. It is connected to the engine through a torque converter, resulting in smoother gear shifts.
16
2
Share

Reverse Parking Skills?

Here are the summarized techniques: 1. Determine the parking space position: Assess whether the space is "suitable". If acceptable, approach it slightly. When the front wheels pass the space, start steering to make the car move away from the space. 2. Utilize the lane width and observe mirrors: Maximize the available lane width to position the car at an "angle". This reduces the angle between the car and the parking space, minimizing steering adjustments during reversing. The angled position also allows the driver to monitor two rear danger points via mirrors. When the car is angled enough for the driver to see the corner of the left-side vehicle in the left mirror, begin reversing. Continuously check the left mirror to monitor the distance between the left rear wheel and adjacent vehicles - the first "danger point". 3. Monitor the rear: Once your left rear wheel clears the front of the left-side vehicle, the "danger point" shifts to the right rear corner. Shift focus to the right mirror to assess clearance from the right-side vehicle. When a "gap" appears between your car and both side vehicles in the right mirror, you've successfully passed all danger points. Continue steering to adjust the reversing path and straighten into the space.
8
0
Share

Why Does the Car Window Keep Fogging Up?

Reasons for car window fogging: 1. The temperature of the car window glass in contact with the outside is relatively low, causing water vapor inside the car to condense on the glass, forming fog. 2. When the window temperature is below the dew point, at a certain air humidity, if the window temperature is lower than the dew point, condensation easily forms on the surface of the window, leading to the common fogging phenomenon on the windshield. 3. There is a certain temperature difference between the two sides of the window. Here are three methods to remove fog from the car window: 1. Use an anti-fog agent: Spray a small amount of defogger on the car window glass and wipe it clean. While polishing the glass, a thin transparent protective film forms on the glass, effectively preventing the condensation of water vapor on the glass and the formation of fog. 2. Utilize air convection: Due to seasonal changes, the temperature difference between the inside and outside of the car increases. The warm and humid air inside the car meets the cold windshield, releasing heat and liquefying, which easily causes fogging. Therefore, you can also slightly open the car window to allow air convection between the inside and outside of the car, balancing the temperature difference and achieving an anti-fog effect. 3. Use the car heater: Turn on the heater and direct warm air onto the glass to quickly raise the temperature of the front glass, eliminating the conditions for the warm and humid air inside the car to release heat and liquefy on the window glass, thereby preventing fogging.
15
0
Share

What is the maximum wading depth of the 2021 Audi A6L?

The maximum wading depth of the 2021 Audi A6L is 500mm. The wading depth of the 2021 Audi A6L is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when driving through waterlogged roads. Therefore, in terms of safe wading depth, off-road vehicles and SUVs have obvious advantages. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a reference when passing through waterlogged roads. If the air intake of the 2021 Audi A6L is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it can cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. The height of the air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before driving through water, always turn off the auto start-stop function to prevent the engine from automatically restarting if the vehicle stalls in the water, which could lead to severe engine damage due to water ingress. Assess the underwater road conditions based on the passage of preceding vehicles and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration. On roads prone to water accumulation, observe warning water level markers, trees, or other reference points like the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed. Be aware of your vehicle's safe wading depth. If the water depth exceeds half the height of the tires or the engine's air intake, do not attempt to drive through. Instead, choose an alternative route.
14
5
Share

What Causes the Abnormal Noise When the Window is Fully Closed on Bumpy Roads?

Window abnormal noise may be caused by the abnormal width of the window glass guide channel. This leads to friction between the glass and other parts when driving on bumpy roads, resulting in abnormal noise. The following is an introduction about car windows: 1. Introduction: Car windows are windows set on the four walls of the compartment to block wind and rain without obstructing the view. They are generally made of glass materials, and with the passage of time, car window glass has also evolved rapidly. 2. Classification: Safety glass—laminated glass, tempered glass, and zoned tempered glass, among other varieties, have greatly improved the performance of automotive glass. 3. Composition: Ordinary automotive glass is made of silica glass, with the main component silicon oxide accounting for more than 70%, and the rest composed of sodium oxide, calcium oxide, magnesium, etc.
5
4
Share

Is the battery dead if the electric vehicle won't charge?

The electric vehicle not charging may indicate a battery failure. The possible reasons and solutions are as follows: Battery End of Life: The battery has reached the end of its service life. Solution: Replace or repair the battery. Poor Fuse Contact: The fuse inside the battery is broken or there is poor contact between the battery fuse tube and fuse holder. Solution: Replace the fuse. Adjust their positions to ensure good contact, or replace the fuse tube. Low Voltage: The charger has no output voltage or low output voltage, or there is poor contact between the charger and the 220V AC power source. Solution: Replace or repair the charger; reconnect the power source. Abnormal Indicator Light: Abnormal charger indicator light causing false full charge. Solution: Replace or repair the charger.
10
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.