Has the Toyota Crown Been Discontinued?

What is used for matching when replacing an electronic steering gear?

Replacing an electronic steering gear requires the use of a dedicated diagnostic tool to match the steering angle sensor G85. Below are the specific causes of electronic steering gear malfunctions: 1. Excessive air: The power steering system contains a large amount of air, leading to abnormal car steering. 2. Foreign objects: Presence of foreign objects in the steering hydraulic lines causes the steering pump flow control valve to stick. 3. Loose connections: Loose connections in the power steering system result in steering fluid leakage. 4. Piston cylinder wear: Excessive wear of the steering gear piston cylinder, poor sealing of oil seals, or sticking/damage of the control valve.

6

1

Share

What is the tire specification of the Honda Lingpai?

Honda Lingpai's original tires come in two brands: Goodyear and Yokohama, with the model size parameter being 205/55R16. Relevant information about the tires is as follows: 1. When purchasing tires, always check the production date: If the production date is too old, do not buy them. Tires are rubber products and will age even if not used. 2. During regular use, frequently check tire pressure and the surface for any damage: The sidewall of the tire is relatively fragile, and if it is scratched or punctured, it cannot be repaired. It is recommended that owners replace their tires every four years, even if the mileage driven within those four years is minimal.

16

1

Share

Should You Turn on the Width Lights When Driving at Night?

When driving at night, you should turn on the width lights as well as the headlights. The functions of width lights and precautions for using lights at night are as follows: Features and functions of width lights: Width lights serve as indicator lights to alert other vehicles. These lights are usually installed along the edges of the car's roof, indicating both the height and width of the vehicle. Precautions for using lights at night: On well-lit urban roads, low beams are generally sufficient. On poorly lit roads, switch to high beams, but remember to switch back to low beams when approaching oncoming traffic. If your vehicle becomes immobile due to a breakdown or accident at night, turn on the hazard lights.

14

2

Share

What to Do When There is Friction Between Brake Pads and Brake Discs?

If there is abnormal friction noise between the brake discs and brake pads, it is recommended to have them checked at a 4S shop. If a metallic scraping sound (which could also be due to the initial break-in period after installing new brake discs) accompanies light braking, the brake pads must be replaced immediately. Additional information is as follows: 1. Since brake discs are significantly more expensive than brake pads, it is advisable to regularly inspect the brake pads to avoid damaging the brake discs. 2. The abnormal noise caused by this may disappear after some wear. If braking feels difficult, it might indicate that the brake pads have largely lost their friction capability, necessitating immediate replacement. After all, some low-quality brake pads contain hard spots, which can also cause abnormal noise.

19

3

Share

How many kilometers does car gear oil need to be replaced?

Car gear oil should be replaced every 60,000 to 80,000 kilometers, with the replacement locations being the manual transmission and rear axle. Below is relevant information about gear oil: Functions of gear oil: Gear oil mainly refers to the lubricating oil for transmissions and rear axles. It differs from engine oil in terms of usage conditions, composition, and performance characteristics. Gear oil primarily serves to lubricate gears and bearings, prevent wear and corrosion, and assist in heat dissipation for gears. Common gear oil specifications: Most foreign automotive gear oils are classified according to SAE viscosity grades and API performance categories. Conventional vehicle gear oils typically use specifications such as 75W/90, 80W/90, and 85W/90.

20

2

Share

Does the Audi A3 trunk have only one light?

Audi A3 trunk has only one light. Function of the trunk light: When the trunk is opened, the trunk light will automatically turn on to facilitate loading and unloading items, as well as maintenance. However, if there is an issue with the trunk light switch or circuit, this light can become the source of vehicle power leakage. How to determine trunk light malfunction: If the trunk light remains on after closing the trunk door, it is likely due to an abnormal sensor device and requires professional handling. It may also be caused by poor contact, where the trunk door fails to fully trigger the trunk light's sensor when closed. In this case, you can try adjusting the sensor device to see if it resolves the issue.

6

4

Share

Has the Toyota Crown Been Discontinued?

What is used for matching when replacing an electronic steering gear?

What is the tire specification of the Honda Lingpai?

Should You Turn on the Width Lights When Driving at Night?

What to Do When There is Friction Between Brake Pads and Brake Discs?

How many kilometers does car gear oil need to be replaced?

Does the Audi A3 trunk have only one light?

What does the C2 license Subject 2 test include?

How Many Axles Does a 4.2-Meter Truck Have?

How are points deducted when motorcycle and car driving licenses are merged?

Where to Buy Car Modification Parts?