Has the fuel tank noise issue in the 2021 Xingrui been resolved?

2 Answers
MarleyAnn
07/24/25 8:04am
No, but the fuel tank noise issue in the Xingrui is only an isolated case. Introduction: As the first model of Geely's 4.0 era, the Xingrui carries the important mission of Geely's high-end transformation. After its launch, it quickly became a dark horse in the market with its "disruptor" stance, thanks to its mid-size car dimensions, 2.0T high-performance engine, and a price comparable to compact cars. It has received widespread acclaim from various sectors of the market. Powertrain: The most notable highlight of the Xingrui is its powertrain, featuring the same Volvo 2.0TD T4 engine, with a maximum power of 190 horsepower and a maximum torque of 300Nm.
Was this review help?
6
1
Share
HarperDella
08/11/25 3:46am
As an owner of a 2021 Xingrui for over a year, I can confirm the fuel tank rattle is a genuine issue, particularly noticeable on bumpy roads or after refueling. Initially dismissed it as minor, but it gradually affected driving comfort. Geely issued recall services for certain batches, offering fuel tank bracket replacements or software upgrades - my vehicle showed improvement after dealership servicing. The problem isn't completely resolved as causes vary: fuel impurities, loose mounting bolts, or potential design flaws. Fellow owners should check warranty records and contact official channels to verify applicable solutions. Daily recommendations: avoid overfilling the tank, minimize rough road driving to reduce shaking, and remind technicians to inspect the fuel tank area during maintenance. Prioritize safe driving and address promptly to prevent potential severe malfunctions from prolonged neglect.
Was this review help?
8
3
Share
Expand All
More Forum Discussions

What Causes the Sudden Blackout of the Boyue's Central Control Screen?

Boyue's central control screen suddenly going black may be caused by power supply failure, wiring issues, or damage to the screen itself. Additional Information: 1. Specific Causes: Abnormal power supply to the display screen; problems with cable connections; damaged display screen; abnormal video output signal from the motherboard. 2. Solutions: An occasional occurrence is normal, as the voltage is relatively low when starting the car, with most power being used for ignition. If the screen fails to light up multiple times during startup, it's advisable to check whether the display screen's power supply is normal. If the power supply is abnormal, the power module should be replaced. Then, inspect whether the cable connections are secure. If there are issues, replace the cables. If everything appears normal, the problem likely lies with the display screen itself.
15
3
Share

How to Remove Bubbles in Car Film?

The methods to remove bubbles in car film are: 1. Use a sharp object to puncture the bubble. 2. Use a flat tool to squeeze the air out of the bubble. Below is relevant information about car film: Car film is a thin layer applied to the front and rear windshields, side windows, and sunroof of a vehicle. This thin layer is called solar film or heat-insulating film. Precautions after applying car film include: 1. Avoid rolling windows up and down for 3 days. 2. Do not clean the heat-insulating film or turn on the defogging heating wires for a week. 3. Do not use nails or sharp objects to pry the edges of the film to prevent dirt from entering. 4. Avoid attaching suction cup items to the film for 1 to 2 weeks. 5. If there are bubbles, displacement, or blurred vision on the film surface, seek professional help immediately to avoid affecting driving safety.
14
5
Share

What to Do When Your Car Electronic Key Fails?

Solutions for car electronic key failure: Every remote key comes with a mechanical key, which can be used to open the car door: 1. Slide the safety switch on the remote key. The remote key has a safety switch; sliding it reveals the hidden mechanical key, which can then be removed. 2. Insert the mechanical key into the car door lock to open the door. Turning the mechanical key requires a bit of force, and hearing an unlocking sound confirms that the car lock has been released. Possible causes and solutions for car electronic key failure: 1. The car electronic key may fail due to a dead battery in the key. Solution: Replace the key battery with a new one promptly. 2. The issue might be with the car key or the car's anti-theft system. Solution: Visit a 4S shop for inspection and repair by a professional technician. 3. The problem could be caused by signal interference. Solution: If possible, switch to manual locking immediately. If manual locking isn't an option, move the car a short distance before locking it. Additionally, be vigilant for any suspicious individuals nearby and report to the police or seek assistance from radio management authorities if necessary.
19
2
Share

What is the EOBD fault warning light?

eobd fault warning light is generally caused by system failures, such as poor contact in car wiring, EGR valve blockage, excessive emissions, or sensor malfunctions. Below is information about the eobd fault warning light: 1. The eobd fault warning light is part of the on-board diagnostic technology, abbreviated as OBD. EOBD is also referred to as OBD. 2. All vehicles must be equipped with an OBD system, which is designed, manufactured, and installed to ensure the vehicle can identify degradation types and fault types. 3. The OBD system continuously monitors the engine's operating conditions to check if the vehicle's emissions exceed standards. If they do, it immediately issues a warning. Therefore, when the OBD fault light comes on, it indicates an emission-related fault in the vehicle. 4. The illumination of the fault light generally indicates the presence of a fault. It is necessary to check the wiring, EGR valve, and vacuum regulator valve connections for issues, or whether a sensor has malfunctioned.
6
0
Share

Is it difficult for a 1.5L naturally aspirated engine to reach 120 km/h on the highway?

1.5L naturally aspirated engine reaching 120 km/h on the highway depends on the number of passengers in the car. Under normal circumstances, it is not difficult. The following is an introduction about engines: 1. V-type engine: Simply put, a V-type engine divides all cylinders into two groups, arranging adjacent cylinders at a certain angle (the angle γ between the centerlines of the left and right cylinder banks is less than 180°), so that the two groups of cylinders form an angled plane. Viewed from the side, the cylinders form a V-shape (usually at a 60° angle), hence the name V-type engine. 2. VR engine: The VR engine is an exclusive product of Volkswagen. In 1991, Volkswagen developed a V6 2.8L engine with a 15° angle, called the VR6, and installed it in the third-generation Golf. This engine has a compact structure, with a width close to that of an inline engine and a length not much longer than an inline 4-cylinder engine.
17
5
Share

What is the original brand of the spark plugs for the Malibu XL?

The spark plug model for the Chevrolet Malibu is LTR6IX-11. The spark plug is a crucial component of the gasoline engine's ignition system. It introduces high voltage electricity into the combustion chamber and generates a spark by jumping across the electrode gap, thereby igniting the combustible air-fuel mixture in the cylinder. The structure of the spark plug is described as follows: 1. Steel shell: The lower part of the steel shell has fine threads for installation into the cylinder head's spark plug hole, while the upper part features a hexagonal nut for use with a spark plug socket to tighten or remove the spark plug. 2. The metal rod serves as the center electrode. The lower end of the metal rod contacts the upper end of the center electrode through a conductive glass body, and the upper end of the metal rod is equipped with a terminal nut. 3. Between the steel shell and the center electrode, there is a high-alumina ceramic insulator that insulates the center electrode when electrified. 4. The lowest part of the steel shell is fitted with a curved side electrode. 5. The middle of the steel shell's exterior has a copper gasket.
4
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.