Failed the Driving Test (Subject 3) Four Times, How to Find a Way to Pass?

What is the fuel tank capacity of the Q5?

Audi Q5 has a nominal fuel tank capacity of 75 liters. The methods to check a car's fuel tank capacity and the unit of measurement for fuel tank capacity are introduced as follows: Methods to check a car's fuel tank capacity: Check through the owner's manual. The car manual can be considered a comprehensive guide, containing detailed information about the vehicle, from maintenance schedules to fuel tank capacity. Owners can refuel according to this capacity, and it is advisable not to exceed the safe capacity. Unit of measurement for fuel tank capacity: Internationally, the standard unit for measuring car fuel tank capacity is liters (L). Different countries also have corresponding standards for fuel tank capacity. In China, the regulation stipulates that the actual fuel tank capacity should be 95% of the rated value, but in practice, the actual capacity is usually greater than the nominal capacity.

10

1

Share

What Are the Eight Defensive Driving Techniques?

Looking further ahead, scanning surroundings, leaving room, drawing attention, focusing on driving, knowing the route well, and being prepared for emergencies are the eight techniques. Here are the details: 1. Look further ahead: When driving, try to look as far ahead as possible, especially for novice drivers who tend to have a "shorter" view, usually focusing only 3 to 6 seconds ahead based on speed. Experienced drivers, however, typically look about 15 seconds ahead. A longer view helps with lane changes, overtaking, and ensures safer driving. 2. Scan surroundings: It's essential to have a complete understanding of the area around your vehicle. While driving, be fully aware of the vehicles, road conditions, and pedestrians in front, to the sides, and behind your car. If your view is obstructed, change lanes promptly—for example, avoid following large vehicles too closely. Extra caution is needed when reversing, particularly checking the area behind the car.

13

5

Share

What Situations Are Prone to Occur When Driving on Muddy Roads?

When driving on muddy roads, due to the decrease in lateral friction between the tires and the ground, the phenomenon of 'wheel sideslip' is prone to occur. Typically, because the soil on muddy roads is relatively soft and sticky, this greatly increases the resistance to the vehicle's movement and also reduces the adhesion of the car tires to the ground. This is the reason why vehicles are prone to skidding and rolling over when driving on muddy roads, and sometimes even getting stuck. Precautions for driving on muddy roads: When driving on muddy roads, the driver should try to keep the vehicle at a low speed. This can effectively allow the car engine to output greater torque while also reducing the resistance of the muddy road to the vehicle's forward movement. In addition, try to avoid shifting gears when driving on muddy roads because the resistance of the vehicle on muddy roads is already very high. If you shift gears at this time, it is easy for the car to suddenly stall due to excessive resistance. When driving on muddy roads, remember not to stop easily. Once stopped on a muddy road, it is difficult to start again. If the vehicle stops on a muddy road and moves repeatedly in the same place, the wheels will sink deeper and deeper into the mud. For long-distance muddy roads, do not rely on the vehicle's inertial force but use a low gear with high throttle to pass through at a low and steady speed. To effectively overcome resistance and allow the car to drive smoothly on muddy roads, make full use of all the vehicle's power devices. For example, for front-wheel-drive vehicles, the front-wheel-drive device can be activated in time, and vehicles with a differential lock function can lock the wheel differential when one side of the wheel slips. Choose routes with flat surfaces, hard roadbeds, and shallow mud. On rutted roads, try to follow the ruts as much as possible to avoid road surface water accumulation. On roads with curves, try to drive along the middle of the road as much as possible.

3

5

Share

How to Charge Wuling MINIEV in High-Rise Buildings?

You can charge it in the garage or rent a parking space and pull an extension cord. More information about Wuling Hongguang MINIEV is as follows: 1. Features: As a four-seat new energy vehicle, Wuling Hongguang MINIEV does not rely on charging piles. It comes with an integrated high-efficiency charging gun and can be directly charged using a standard 220V three-pin household power supply with grounding. The charging power is less than 2kW. The 120KM range version takes about 6 hours to charge, while the 170KM range version takes approximately 9 hours, making it very convenient. 2. Configuration: The Hongguang MINIEV battery is equipped with low-temperature pre-heating charging technology, battery insulation function, and an intelligent battery management system (BMS), which allows real-time monitoring of the battery status, facilitating charging and power usage monitoring.

6

3

Share

What are the different models of the Magotan?

The Magotan offers three models: a 1.4-liter turbocharged version, a 2.0-liter low-power turbocharged version, and a 2.0-liter high-power turbocharged version. Below are the specific details of these three Magotan models: 1.4-liter turbocharged version: Fuel-efficient, the turbocharged engine performs well in acceleration. Compared to naturally aspirated engines of the same displacement, turbocharged engines deliver better power because they have a larger 'lung capacity,' resulting in superior performance. 2.0-liter low-power turbocharged version: The low-power 2.0T has a smaller piston diameter than the high-power version, but the compression ratio is increased to 11. This makes the low-power engine more thermally efficient, and structurally, it is more advanced. 2.0-liter high-power turbocharged version: It uses the common Otto cycle, where the compression and expansion ratios are equal, eliminating the need for valve timing coordination. In terms of driving performance, this cycle system ensures smoother engine 'breathing,' delivering direct and rapid power transmission.

12

5

Share

What is the wading depth of a Jetta?

The wading depth of a Jetta is 20-30 cm. Here are the relevant details: 1. Vehicle wading depth standards: Different vehicle models have varying wading depth standards. For sedans, the wading depth is 20-30 cm, for SUVs it's 30-60 cm, and for hardcore off-road vehicles, it can reach 70-100 cm. Generally, as long as the water level does not exceed the height of the engine air intake, there shouldn't be major issues. Even if water submerges the exhaust pipe, the strong exhaust pressure can expel the water. When wading, it's advisable to maintain a low gear to prevent stalling. 2. Issues after vehicle wading: Deformation and damage to the connecting rod mechanism. When a mixture of water and air enters the engine through the intake, since gases are compressible but liquids are not, the connecting rods can deform under the water's pressure. If the driver attempts to start the car at this point, the significant counterforce can cause the bent connecting rods to rub against the cylinder walls, leading to irreversible damage to the engine block.

20

5

Share

Failed the Driving Test (Subject 3) Four Times, How to Find a Way to Pass?

What is the fuel tank capacity of the Q5?

What Are the Eight Defensive Driving Techniques?

What Situations Are Prone to Occur When Driving on Muddy Roads?

How to Charge Wuling MINIEV in High-Rise Buildings?

What are the different models of the Magotan?

What is the wading depth of a Jetta?

What are the hazards of Volkswagen engine oil leakage?

Will the engine oil level increase in the xrv1.8?

Do I still need to go to the DMV after selecting a license plate number on 12123?

What are the Mercedes-Benz E-Class models?