Does Transmission Oil Leakage Have an Impact?

2 Answers
Galadriel
09/05/25 8:20am
Transmission oil leakage does have an impact, as it can lead to poor lubrication and heat dissipation in the transmission, and may cause the transmission's control mechanism to malfunction. The causes of transmission oil leakage include: 1. Corrosion or aging deformation of the oil seal; 2. The oil seal spring falling off or the oil seal being installed in the wrong direction; 3. Wear or indentation on the shaft neck; 4. Prolonged high-speed and high-power operation of the transmission; 5. Lack of regular maintenance for the transmission; 6. Shrinkage and hardening of sealing components, leading to loss of elasticity; 7. Damage to pipelines; 8. Excessive axial clearance, loose bearing seats, or worn bearings. Solutions for transmission oil leakage: 1. Replace the aged or deformed oil seal; 2. Check the installation direction of the oil seal; 3. Replace or repair the shaft neck; 4. Adjust the vehicle speed appropriately to ensure the transmission operates within an acceptable power range; 5. Perform regular maintenance on the transmission.
Was this review help?
2
4
Share
FinnRose
09/17/25 8:29am
Transmission oil leakage is indeed problematic. Transmission fluid acts like the lifeblood of the gearbox, responsible for lubricating gears and preventing overheating. Once leakage occurs, the reduced fluid level leads to insufficient lubrication, causing increased friction between internal components and accelerated wear. Over time, you may notice rough shifting, unusual noises, or jerky movements. In severe cases, the transmission could fail completely, requiring costly replacement. Leaking oil might also drip onto other components, causing additional damage. During long drives, I pay extra attention to these details, regularly checking fluid levels and seals. If you spot oil stains in your parking space, get it repaired promptly. Ignoring it not only means financial loss but also compromises driving safety. Replacing a gasket is usually inexpensive, but delaying repairs may lead to major overhauls. Remember, proper car maintenance protects both your wallet and safety. This issue shouldn't be underestimated – early action is always wise. Simply put, transmission oil leakage is a warning sign; don't wait for major problems to regret inaction.
Was this review help?
1
4
Share
Expand All
More Forum Discussions

What to do if the Roewe i5 electronic handbrake cannot be released after pressing?

After parking the vehicle, shift the gear to D and immediately step on the accelerator, the electronic handbrake will be automatically released. Press the brake and push down the electronic handbrake button. When the red indicator of the electronic handbrake on the dashboard disappears, it means the electronic handbrake has been released.
10
4
Share

What to Bring for Volkswagen's First Maintenance?

Items required for the first maintenance include: driver's license; maintenance manual; warranty manual; owner's ID card; vehicle's registration certificate; vehicle's purchase invoice, to be taken to the designated first maintenance facility for the vehicle's initial service. Important note: Make an appointment with the 4S store in advance. The first maintenance refers to the initial service after the new car has been driven, with the specific timing varying by vehicle, typically after driving 1,000 to 3,000 kilometers. It is crucial to attend the first maintenance on time, neither early nor late. The completion of the first maintenance signifies the end of the car's break-in period, allowing it to be driven at standard loads and normal speeds as required by the vehicle. The timing for the first maintenance is calculated from the date of vehicle pickup. There are two indicator values for the first maintenance: mileage and time. Whichever comes first serves as the standard. First maintenance items include: checking tire condition/wear and adjusting pressure if necessary; inspecting the operation of the lighting system (headlights, indicators, emergency signal lights, trunk lights, passenger compartment lights, glove box lights, dashboard warning lights, etc.); checking the operation of windshield wipers and washers/wiper blade position/wear; visually inspecting the exterior of the body, underbody protective components, pipes/hoses (exhaust, fuel lines, brake lines); condition of rubber components (dust covers, bushings, spacers, etc.); visually inspecting the condition of various control belts; checking/adjusting clutch pedal height and travel; checking/adjusting hand brake travel; checking and tightening chassis screws; cleaning the air filter element. Time required: Completing all tasks takes approximately 2 hours. The most important aspect of the first maintenance for a new car is changing the engine oil and oil filter. When changing the engine oil, the oil filter must also be replaced simultaneously. The selection of engine oil must refer to the "Vehicle Use and Maintenance Manual," as different vehicle models specify different oil grades. Maintenance precautions: Do not wash the interior of the car with water: Many people clean their cars themselves during holidays, washing the body with water and wiping it with a cloth. Here, it is important to note that the interior of the car should not be washed directly with water. If the floor mats are dirty, they can be cleaned with a vacuum cleaner or taken out, scrubbed with a brush and detergent, dried, and then put back. There are many holes under the rubber mats on the cabin floor. If water enters, it will not dry naturally but will flow through the holes to areas like the gearbox, causing erosion and corrosion. The best practice is to clean with a vacuum cleaner and then wipe with a cloth to prevent water accumulation. Do not mix different brands of antifreeze: When the antifreeze in the car is low, it is recommended to drain the antifreeze and add the same brand of antifreeze from the beginning. Since different brands of antifreeze have significantly different chemical properties, mixing them can cause corrosion between different types of antifreeze. Different brands of antifreeze use different corrosion inhibitors, so they should not be mixed to avoid unnecessary trouble. Do not lubricate tire bolts and nuts: When the bolts on a car become rusty during driving, they are often oiled to function properly again. To prevent rust on the wheel bolts and nuts, some people apply lubricant to them, but this poses a safety risk. When the car is driven at high speeds, the bolts and nuts can easily loosen or even fall off, leading to driving malfunctions. Do not press the accelerator when starting an EFI car: The starter of an EFI car is different from that of a regular car. Its fuel injection control device can automatically adjust the fuel supply based on the starter's temperature and operating conditions, ensuring a smooth start.
5
2
Share

How to Adjust Business Class Seats?

The white button adjusts the seat back tilt. Lean back, and the seat back will tilt. Release the button, and the seat back will stay in the set position. Lean back, and the seat back will return to its original position. To adjust the seat tilt, locate the button on the left or right side of the seat. To restore it to the original position, hold the same button again.
4
5
Share

How to Start a Civic When the Key Fob Battery is Dead?

Pull out the key. Generally, the mechanical spare key is hidden inside the remote key fob. Open the car door. Typically, the mechanical key can only unlock the driver's side door. If you need to open other doors, you must first enter the car and manually unlock them. Press to start. When the key fob battery is dead, the transmission power is relatively low, which may prevent the vehicle from starting.
19
2
Share

How to Repair a Car Radiator Leak?

Check for signs of oil emulsification (cylinder head gasket failure or erosion). If present, disassemble the engine and replace the cylinder head gasket. After 5~10 minutes of initiating the major circulation, any leaks in the cooling system—whether from the radiator, rubber hoses, or gaskets—will cease. You can promptly use a screwdriver to wrap the rubber hose connector clamp around the hose joint and then tighten it with pliers.
10
1
Share

How to deal with speeding by 10%?

For violations where the speed exceeds the prescribed limit by less than 10%, a warning will be issued. Here is some relevant information about speeding violations: Content: For violations where the speed exceeds the prescribed limit by less than 10%, a warning will be issued; for violations where the speed exceeds the prescribed limit by 10%-20%, 3 points will be deducted and a fine of 200 will be imposed; for violations where the speed exceeds the prescribed limit by 20%-50%, 6 points will be deducted and a fine of 200 will be imposed; for violations where the speed exceeds the prescribed limit by more than 50%, 12 points will be deducted, a fine of 2000 will be imposed, and the driver's license will be revoked. Notes: Bring your ID card, driver's license, and vehicle registration certificate to the traffic police team at the place of violation or vehicle registration to process the violation and print the processing form. If there is no fine or points deduction, the process is complete after printing the form. If there is a fine or points deduction, pay the fine and wait until the end of the current scoring cycle for the points to be cleared.
16
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.