Does the Volkswagen Tharu have a manual transmission?

1 Answers
Ron
07/29/25 6:34pm
Volkswagen Tharu does not have a manual transmission. The Volkswagen Tharu is positioned as a compact SUV with dimensions of 4453mm in length, 1841mm in width, and 1632mm in height, with a wheelbase of 2680mm. In terms of power, the Tharu is equipped with two engines: a 1.4T and a 2.0T. The 1.4T engine delivers a maximum power of 110 kW, a maximum horsepower of 150, and a maximum torque of 250 Nm. The 2.0T engine produces a maximum power of 137 kW, a maximum horsepower of 186, and a maximum torque of 320 Nm. For the transmission system, the Volkswagen Tharu is paired with a 7-speed dual-clutch transmission.
Was this review help?
16
4
Share
More Forum Discussions

How many seconds is the maximum allowed for stopping midway during reverse parking?

Reverse parking must not exceed a 210-second stop duration midway. Below are relevant details: Regulation: The new rules require examinees to complete the entire process of reversing into the garage and exiting within 210 seconds without stopping midway. Any occurrence of stopping midway or exceeding the time limit will result in an "unqualified" assessment. Additional Information: Reverse parking became a mandatory test item for obtaining a small vehicle driver's license after 2013. It evaluates the driver's ability to maneuver the vehicle within a confined space. Reverse parking is a key assessment point in the driver's test, specifically testing the candidate's skill in accurately reversing the vehicle into the garage from both sides while in motion.
11
1
Share

What does trouble code P2177 indicate?

P2177 trouble code means: The P2177 trouble code indicates that the system (air-fuel mixture) is too lean when off idle (Bank 1) (System-Too-Lean-Off-Idle (Bank-1)). There are many reasons that can cause a lean mixture when accelerating, such as fuel system blockage, malfunctioning mass air flow sensor, etc. More relevant information is as follows: 1. P2177: This refers to the closed-loop control self-learning value of the air-fuel ratio exceeding the upper limit. The air-fuel ratio is the ratio of fuel to air mixture. Closed-loop control means that under non-rapid acceleration and non-warm-up conditions, the oxygen sensor sends signals to the ECU to adjust the fuel injection volume. 2. Specific meaning of trouble code P2177: It indicates that the electronic control unit (ECU) adjusts the fuel delivery by increasing or decreasing the injector opening time to achieve the optimal air-fuel ratio for the engine (air to gasoline mass ratio of 14.7:1). A too-rich air-fuel ratio means excessive fuel delivery, while a too-lean air-fuel ratio means insufficient fuel delivery. 'System too lean' indicates that the fuel quantity (relative to the intake air volume) is too low. Possible causes include air leaks after the mass air flow (MAF) sensor, PCV system leaks, faulty oxygen sensor, exhaust leaks near the oxygen sensor, EGR leaks, dirty MAF sensor, clogged fuel injectors, insufficient fuel supply from the fuel pump, etc.
1
3
Share

What is the reason for the left side being wider and the right side narrower when reversing into a parking space?

The reasons for the left side being wider and the right side narrower when reversing into a parking space include driving too fast or with inconsistent speed, which leads to inaccurate steering when aligning with reference points. Below is a related introduction: Introduction: Misjudging the 30 cm distance during reverse parking results in the right side being too narrow when correcting the steering. The vehicle speed suddenly increases when turning the steering wheel, leaving no opportunity to adjust the distance. Additional information: The width of the reverse parking space equals the vehicle width plus 60 cm. The standard parking requires the vehicle body to be 30 cm away from each side of the parking space lines. The width of the space determines how much steering correction is needed. If the rear wheel is already less than 30 cm from the corner when entering, the distance from the parking line will naturally be less than 30 cm after entering.
1
5
Share

Can a Blurry Rearview Camera Be Repaired?

Can a blurry rearview camera be repaired? Introduction to the camera: Most rearview cameras currently sold on the market are waterproof devices. If you purchase a low-quality camera, it is prone to water seepage, leading to a blurry image. Handling the camera: If the issue is caused by dust or dirt sticking to the lens, simply cleaning it will suffice. If the blurriness is due to prolonged use leading to chip aging, you can take it to a repair shop for maintenance or replacement. If moisture has entered the camera, you can try using a hairdryer to blow warm air at the camera for a few minutes. It is also advisable to perform a sealing treatment afterward to prevent future water seepage.
8
1
Share

Is It Normal to Get Worse at Reverse Parking with More Practice?

It is normal to get worse at reverse parking with more practice. Here are the relevant explanations: Introduction: Normally, practicing 7 or 8 runs a day is mainly about mastering the key points through repetition. However, one or two days before the test, usually only 1-2 rounds of the five items are arranged to consolidate the key points. Practicing too much can lead to fatigue, which may affect your performance during the test. Additional Information: At the beginning, learning reverse parking requires an attitude of humility and willingness to learn. The correction mantra for steering too early or too late is: if you steer too early and the right side is narrow, turn the wheel back to the left; if the left side is narrow after steering, maintain the right full lock. At the same time, you can use the clutch and brake to control the speed, which allows sufficient reaction time and room for correction.
17
2
Share

What Happens If You Forget to Engage the Handbrake While Reversing?

Forgetting to engage the handbrake while reversing may cause the brake caliper to seize, result in smoke from the rear of the car, and also damage the vehicle's tires. Here are the relevant details: Introduction: If the handbrake is pulled too tightly or if the car is driven at high speed over a long distance, the handbrake pads can wear out severely, potentially reaching the point of replacement after just one instance. Additional Information: There are two indicators that the handbrake hasn't been released: a beeping sound inside the car, similar to the sound for not wearing a seatbelt, which continues persistently. Secondly, the handbrake warning light on the dashboard will remain lit. Most people check the dashboard frequently enough to notice this.
19
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.