Does the Skoda Kamiq have front fog lights?

1 Answers
SanLawson
07/30/25 1:51am
Skoda Kamiq does not have front fog lights. How to use the turn signals on Skoda Kamiq: Push the control lever downward to activate the left turn signal. Lift the control lever upward to activate the right turn signal. Gently flick the light lever to make the corresponding turn signal flash three times, then automatically turn off. How to use the high beam on Skoda Kamiq: After turning on the low beam, push the light control lever forward to activate the high beam. With the low beam on, pulling the light control lever backward will momentarily activate the high beam, also known as flashing the high beams, which is commonly used to alert other vehicles or pedestrians.
Was this review help?
16
5
Share
More Forum Discussions

How to Clear the P0140 Trouble Code?

p0140 trouble code needs to be cleared at a repair shop according to the specific vehicle model's clearing procedure. Below is relevant information about automotive trouble codes: 1. Introduction: Automotive trouble codes are error codes reflected by the vehicle's computer ECU after analyzing a fault. 2. Classification: Automotive trouble codes can be divided into two types, one is intermittent faults, and the other is actual faults.
5
2
Share

Is the b48b20c engine domestically produced or imported?

The b48b20c engine is a domestically produced engine, manufactured at BMW Brilliance's Tiexi factory. The BMW 3 Series 25i is equipped with the b48b20c engine, which has a maximum power output of 135kW, a maximum torque of 290 Nm, and a maximum horsepower of 180. For daily maintenance of the b48b20c engine, the following methods can be used: Use lubricating oil of the appropriate quality grade. For gasoline engines, select SD--SF grade gasoline engine oil based on the additional equipment of the intake and exhaust systems and usage conditions; for diesel engines, choose CB--CD grade diesel engine oil according to the mechanical load, with the selection standard not lower than the manufacturer's specified requirements; Regularly change the engine oil and filter. The quality of any grade of lubricating oil will change during use. After a certain mileage, performance deteriorates, which can cause various problems for the engine. To avoid malfunctions, change the oil regularly based on usage conditions and maintain an appropriate oil level; As oil passes through the fine pores of the filter, solid particles and viscous substances in the oil accumulate in the filter. If the filter becomes clogged and oil cannot pass through the filter element, it may rupture the filter element or open the safety valve, allowing oil to bypass through the bypass valve and carry contaminants back to the lubrication areas, accelerating engine wear and increasing internal contamination; Regularly clean the crankcase. During engine operation, high-pressure unburned gases, acids, moisture, sulfur, and nitrogen oxides from the combustion chamber enter the crankcase through the gap between the piston rings and cylinder walls, mixing with metal particles from component wear to form sludge. In small amounts, it remains suspended in the oil; in large amounts, it precipitates out, clogging filters and oil passages, making engine lubrication difficult and causing wear; Regularly use a radiator cleaner to clean the radiator. Removing rust and scale not only ensures the engine operates normally but also extends the overall lifespan of the radiator and engine.
1
5
Share

Do I Need to Drive for an Hour After Jump-Starting a Dead Car Battery?

If the vehicle's battery is severely depleted, it will require a longer period of time after jump-starting to ensure the battery has enough power to start the engine. For safety reasons, it is generally recommended to drive normally for at least half an hour after starting the engine to ensure the battery is sufficiently charged. Additionally, avoid idling the engine, as the alternator generates relatively little power at idle speed, resulting in slow charging. If the battery still doesn't hold a charge, it may be necessary to replace the battery or check for charging system faults. More relevant information is as follows: 1. Idling: If the owner charges the car battery in an idle state, it will take even longer to fully charge the battery. While the alternator's voltage can provide enough power for some electrical devices, it may not meet the demands of high-power equipment such as air conditioning or car audio systems. 2. Maintenance: Owners should also pay attention to the battery's condition during routine maintenance. After parking, all electrical devices in the car should be turned off to avoid battery drain due to prolonged inactivity, which may prevent the car from starting normally the next time it is used.
3
4
Share

Why does the car air conditioning work in the morning and evening but not at noon?

The reasons for the car air conditioning not cooling at noon are: first, a dirty air filter, and second, a dirty condenser. Here are detailed explanations and solutions: 1. The simplest way to determine if there is a cooling issue is to measure the temperature at the air outlet: a temperature around 10°C is normal, but it varies significantly between different cars. Some cars can reach around 4°C, while others may only reach 8-9°C. 2. Dirty air filter: A dirty filter leads to insufficient airflow. Even if the fan is set to a high speed, the actual amount of air blown out is minimal. Although the air is cool enough, the low volume of air can still cause the cabin temperature to remain high. 3. Lack of refrigerant and condenser blockage: If the pressure is too low when the air conditioning is off and remains low when turned on, it indicates a lack of refrigerant, which can be resolved by recharging. If the pressure is normal, consider a condenser blockage, which requires cleaning. Minor blockages can be resolved by rinsing with a water gun during car washing, while severe cases may require disassembly and thorough cleaning.
14
3
Share

What brand of car is represented by the 'a' logo?

a is the emblem of Acura automobiles. Acura is a premium subsidiary brand under Japan's Honda Motor Company, established in the United States in 1986. The name 'Acura' is derived from the Latin word 'Accuracy,' and its logo features a caliper design used in engineering measurements, symbolizing Acura's exquisite automotive craftsmanship and pursuit of perfection. More details about Acura are as follows: 1. Introduction: As the first Japanese luxury car brand, Acura has reinterpreted the concept of luxury vehicles with its 'Performance Luxury' philosophy that emphasizes individuality and cutting-edge technology. All Acura models are designed, developed, and manufactured in North America, resulting in a diverse product lineup led by models such as the TL, RL, and MDX. The Acura brand officially entered the Chinese market on September 27, 2006. 2. Meaning of the logo: Initially, Acura used a precision caliper as the prototype for its logo. As a masterstroke, Honda's founder and spiritual leader, Soichiro Honda, added a small horizontal bar between the two caliper arms, creating a stylized uppercase 'A' to represent the brand. Both the Latin origin and the caliper prototype signify Acura's core values as a brand representing the pinnacle of automotive manufacturing: precision, meticulousness, and refinement.
6
3
Share

Which is the brake and which is the accelerator in a manual transmission car?

In a manual transmission car, the pedal on the right is the accelerator, and the one in the middle is the brake. Here are the specific details about manual transmission cars: 1. Position: From left to right, they are the clutch pedal, brake pedal, and accelerator pedal. 2. Do not rest your left foot on the pedal: During long drives, both feet can get quite tired, leading to unconsciously pressing down. If your left foot is on the brake pedal at this time and you press the brake, it can easily cause an accident and be dangerous. Most people are right-handed, and their right foot reacts faster. In case of an emergency, the right foot can react in the shortest time possible, lifting off the accelerator and pressing the brake pedal. If the left foot is on the brake pedal, the right foot will be in a suspended state when braking, making it easy to press both pedals simultaneously, which is dangerous.
17
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.