Does the Mercedes-Benz GLC300L have seat ventilation?

Why is the car making a buzzing sound?

Here is the relevant introduction about the car buzzing sound: 1. Check the belt tension: Sometimes the car belt is loose, which can cause a buzzing sound. You should go to a repair shop to check the belt and try tightening it appropriately to see the effect. Usually, you should pay attention to the maintenance of the belt, ensuring the tension is moderate. You can pull the belt by hand yourself. If it feels too loose or too tight, it's safer to have it inspected by a repair shop. 2. Check the brake pads: If the car makes a buzzing sound when you step on the brake while driving, it means the brake pads have worn to the limit and have started grinding against the brake disc. In this case, you should go to a repair shop as soon as possible for inspection to determine the cause of the buzzing sound and avoid driving forcefully. You should also develop the habit of regularly checking the brake pads yourself to see if the brake pads on all four wheels are wearing normally and if there is any abnormal wear.

7

0

Share

Will Points Be Deducted for Making a U-Turn Over a Crosswalk?

Making a U-turn over a crosswalk will result in point deductions as it is a traffic violation. According to Article 49 of the "Implementation Regulations of the Road Traffic Safety Law of the People's Republic of China": Motor vehicles are not allowed to make U-turns at locations with no U-turn or no left-turn signs or markings, as well as at railway crossings, pedestrian crossings, bridges, sharp curves, steep slopes, tunnels, or sections of road prone to danger. The definition of yielding to pedestrians at crosswalks: When pedestrians are walking on the right side of the crosswalk and have not reached the centerline of the road, vehicles on the left side of the road should slow down and allow them to pass safely. When pedestrians are waiting outside the boundary line of the motorized and non-motorized lanes and have not entered the road, vehicles should slow down and allow them to pass safely. If pedestrians have crossed the boundary line between the lanes and non-lanes, and vehicles do not stop to let them pass, it is a violation and should be penalized. When pedestrians enter the motorized lane (Lane A) along the crosswalk, vehicles in Lane B should slow down and allow them to pass safely. If vehicles in Lane A do not stop to let them pass, it is a violation and should be penalized. If pedestrians are waiting at the centerline of the road without entering the vehicle lane, and vehicles do not stop to let them pass, it is a violation and should be penalized. If pedestrians cross the centerline of the road into the vehicle lane, and vehicles do not stop to let them pass, it is a violation and should be penalized. When pedestrians are separated by a green belt in the middle of the road and are waiting in the stopping area, vehicles must slow down and allow them to pass safely. Cases where U-turns are allowed: If there is a U-turn sign at an intersection, you can make a U-turn. If there is a U-turn traffic light, follow its instructions. If there is no traffic light, make a U-turn based on the specific situation, ensuring it does not hinder other vehicles or pedestrians. If there is no explicit prohibition of U-turns or left turns at an intersection, you can make a U-turn. "No explicit prohibition" means there are no "No U-turn" or "No left turn" signs, and the centerline is not solid. U-turns are also allowed on yellow grid lines. Yellow grid lines are no-parking zones marked at intersections prone to congestion due to temporary stops, important unit entrances, and other necessary locations. Stopping on these lines (including waiting for traffic lights) is a violation. However, U-turns are permitted on yellow grid lines if there are no central barriers. If there is a U-turn traffic light at an intersection, follow its instructions—only make a U-turn when the light is green. If "No left turn" and "U-turn allowed" signs appear together, U-turns are permitted, but left turns are not. Note that "No U-turn" is not the same as "No left turn." Precautions when making U-turns at intersections: Observe road markings. If the line is solid, U-turns are prohibited under any circumstances. Continue driving to find a suitable location. If there is a "No left turn" sign ahead, even if "No U-turn" is not mentioned, U-turns are not allowed at that intersection because U-turns and left turns are similar maneuvers—both require turning left first. U-turns must be made from the innermost left-turn lane. If you are in the second left-turn lane, you cannot make a U-turn at that intersection. Always yield to oncoming vehicles when making a U-turn. If you interfere with their normal flow, you will bear full responsibility for any accidents. Near the intersection stop line, lanes usually have guiding arrows. The leftmost lane does not always have a left-turn arrow. If there is a straight arrow, even without explicit "No U-turn" signs, U-turns are not allowed.

4

5

Share

Where to Apply for a Mobile Crane Operation Certificate?

Mobile crane operation certificates are uniformly issued by the Quality and Technical Supervision Bureau. The following are precautions for crane operators: 1. Crane Operators: Crane operators must undergo specialized training and pass assessments conducted by relevant authorities to obtain a qualification certificate before being allowed to operate. Unauthorized personnel are strictly prohibited from operating lifting equipment. Before performing lifting operations, crane operators must check whether all devices are functioning normally, whether steel cables meet safety regulations, and whether brakes, hydraulic devices, and safety equipment are complete, reliable, and responsive. Operating any part of the crane with faults is strictly prohibited. Crane operators must work closely with signalers and follow their instructions. A horn must be sounded before operation. If the signal is unclear or incorrect, the operator has the right to refuse execution. During operation, the operator must immediately comply with any emergency stop signal from anyone and can only resume work after eliminating unsafe factors. 2. Signalers: Signalers must clearly communicate instructions to crane operators beforehand. If signals are unclear during operation, an intermediary assistant should be appointed to accurately relay signals. Hand signals should be clear and unambiguous, and signaling with gloves is prohibited. Before lifting an object, check whether the binding is secure. Padding should be placed where ropes pass over edges or sharp corners. The lifting point's center of gravity must be accurate, and the object must not twist, bend, sink, or tilt under force. Before the lifted object is secured in place, the crane operator must not leave the workstation or interrupt work while the sling is under tension or the object is suspended. If the crane operator refuses to lift due to overweight, the signaler should take measures to reduce the overload. Forcing the crane to operate under overload is strictly prohibited.

9

5

Share

How Many Points Can Be Deducted Through Traffic Law Learning?

The maximum points that can be deducted through traffic law learning within one scoring cycle is 6 points. According to Article 5 of the Notice issued by the Ministry of Public Security on January 14, 2020 (Public Traffic Management [2020] No. 14), titled "Work Standards for Reducing Points of Road Traffic Violations Through Accepting Traffic Safety Education (Trial)": Motor vehicle drivers who apply to participate in traffic safety education to reduce points for traffic violations must participate in corresponding road traffic safety laws, regulations, and related knowledge learning, examinations, or traffic safety public activities according to their highest permitted driving license type and meet relevant requirements to apply for point reduction. Traffic law learning and point deduction is a measure for drivers holding a driving license who have been penalized with points due to traffic violations. After participating in online traffic safety learning and passing the examination, their points can be reduced. This is a convenient traffic management measure uniformly deployed by the Traffic Management Bureau of the Ministry of Public Security. Specific precautions are as follows: Applicable Groups: Motor vehicle drivers holding a People's Republic of China motor vehicle driving license, regardless of the driving license type or whether they are commercial vehicle drivers, can participate in traffic law learning and point deduction. They must participate in corresponding road traffic safety laws, regulations, and related knowledge learning and examinations according to their highest permitted driving license type. Specific Rules: Motor vehicle drivers participating in online road traffic laws, regulations, and related content learning must study continuously for 5 minutes each time, accumulating 30 minutes of study time within 3 days. They can then register for an examination within 7 days. Passing the examination can reduce 1 point. Drivers can also attend on-site learning, with each session lasting no less than 1 hour. After completing the required study hours, they can apply for an examination. Passing the examination can reduce 2 points. Drivers can also participate in offline safety public activities, with each hour of participation reducing 1 point. Non-acceptance Situations: The following circumstances will not be accepted: In the previous scoring cycle, the driver had two or more full-point records. Within a 3-point cycle, the driver was involved in hit-and-run accidents, drunk driving, or the manufacture or alteration of documents or license plates. The motor vehicle driving license is in the probation period or has not been reviewed on time. The driver has unprocessed traffic violation records under their name. The driver has a motor vehicle under their name with an expired safety technical inspection or not deregistered as required. The driver has already reduced the maximum 6 points within the cycle.

6

1

Share

How to Open the Trunk of a BMW 5 Series?

The trunk switch of the BMW 5 Series is located at the bottom of the window lift switch on the driver's door. Pulling the button upward for more than 3 seconds will automatically open the trunk. Below is a summary of methods to open the trunk of a BMW 5 Series: 1. Gently pull up the switch button to open the trunk. 2. You can unlock the trunk with the key by pressing the trunk unlock button on the key directly. 3. Using the key's sensing function (within about 1m distance), you can directly pull the trunk switch. 4. Some models have two additional buttons on the trunk, one for closing the trunk and the other for closing the trunk and locking the car.

11

5

Share

Can Waxing Eliminate Paint Color Differences?

Waxing cannot eliminate color differences; it only serves to protect the car paint by creating a layer of wax on the surface, reducing oxidation of the car's paint. Below are the functions of waxing: 1. Filling in minor scratches on the paint surface. 2. Forming a protective layer on the paint surface: protecting the car paint from oxidation and radiation, and enhancing its resistance to dirt. 3. Increasing the gloss and brightness of the car body. 4. Protecting the car paint: forming a dense protective layer to prevent corrosion from acid rain, air conditioning water, and bird droppings. 5. Enhancing the brightness of the car paint: making the paint more glossy and easier to clean from rain and dirty water.

18

0

Share

Does the Mercedes-Benz GLC300L have seat ventilation?

Why is the car making a buzzing sound?

Will Points Be Deducted for Making a U-Turn Over a Crosswalk?

Where to Apply for a Mobile Crane Operation Certificate?

How Many Points Can Be Deducted Through Traffic Law Learning?

How to Open the Trunk of a BMW 5 Series?

Can Waxing Eliminate Paint Color Differences?

Why is there no air coming from the rear air conditioning vents?

Can New Energy Vehicles Run 300,000 Kilometers?

What are the differences between the Enclave and the Blazer?

Why does the Envision dashboard suddenly go black?