Does the Hongqi HS5 come with factory-installed underbody armor?

2 Answers
CadenLynn
07/29/25 6:28am
Hongqi HS5 does not come with factory-installed underbody armor. Here is more information about the Hongqi HS5: 1. Weight: The body structure primarily consists of steel plates, with the side panels composed of three-layer steel plates. Both the front bumper and underbody use aluminum alloy materials to reduce vehicle weight. 2. Safety features: The Hongqi HS5 is equipped with an autonomous emergency braking system that continuously monitors the distance to vehicles ahead. When an imminent collision is detected, the system automatically applies the brakes to prevent or mitigate collision damage. 3. Powertrain: The Hongqi HS5 is powered by a low-power version of the CA4GC inline four-cylinder turbocharged direct injection engine, with a rated power of 165kW and maximum torque of 340Nm.
Was this review help?
18
1
Share
DiReed
08/12/25 9:54am
I've been driving the Hongqi HS5 for a while now, and I noticed that it usually doesn't come with factory-installed underbody armor—just a plastic protective layer that's good for keeping out dust but can't handle gravel roads. I've had a few minor scrapes myself, so I later installed metal armor plates. It cost a bit, but the results were great—the underbody is much better protected now. If you're worried about off-roading or rough roads, I recommend asking the dealership if there's a higher trim version that includes this feature or getting it installed afterward. The process isn't too complicated; a professional shop can finish it in a day. This upgrade can extend the underbody's lifespan and reduce repair costs, especially in areas with lots of rain or snow, thanks to its rustproofing benefits. In short, the base Hongqi HS5 doesn't include underbody armor, but upgrading or adding it afterward makes driving much more reassuring.
Was this review help?
16
4
Share
Expand All
More Forum Discussions

What are the reasons for decreased power and increased fuel consumption?

The reasons for decreased power and increased fuel consumption are as follows: 1. Fuel system issues: When the vehicle's power significantly decreases, it may be caused by fuel injection problems or poor atomization in the fuel system. In severe cases, it might even prevent the vehicle from starting. These issues are primarily due to excessive carbon buildup in the fuel injectors, which blocks the injector needle valve, leading to poor fuel injection or atomization. 2. Electrical system issues: Electrical problems mainly include wiring issues and spark plug problems. When there are wiring problems, it can affect the operation of certain sensors, which may also lead to these symptoms. Additionally, spark plug issues, such as excessive carbon buildup and aging, can also cause insufficient vehicle power. 3. Intake system problems: When the vehicle's intake system malfunctions, it results in insufficient air intake, preventing enough oxygen from mixing with fuel for complete combustion. This not only increases fuel consumption but also affects the vehicle's power.
8
4
Share

What Causes the Engine Yellow Warning Light and Car Shaking?

Reasons for the engine yellow warning light and car shaking: poor combustion of the air-fuel mixture, spark plug failure, and abnormal pressure. Poor Combustion of the Air-Fuel Mixture: When the air-fuel mixture in the cylinder is too rich, the vehicle may experience knocking and shaking. If the mixture is too lean, the vehicle may exhibit poor acceleration. Solution: When the engine warning light comes on and the car starts shaking, immediately stop the vehicle and call for a tow truck to await assistance. Spark Plug Failure: If the issue is not with the air-fuel mixture, it could be due to problems with the spark plugs, high-voltage wires, or ignition coils. Poor performance of the ignition system or weak spark plug firing can also cause the engine warning light to illuminate and result in shaking and insufficient power. Solution: If such a problem is detected, check for any abnormalities in the spark plugs and have them inspected thoroughly at a professional repair shop. Abnormal Pressure: This can be caused by abnormal fuel supply pressure or a faulty intake pressure sensor. Incorrect fuel pump pressure or erroneous readings and poor performance of the intake pressure sensor can lead to car shaking and power loss. Solution: First, stop the vehicle immediately and check if the engine oil level is sufficient, then proceed to a professional repair shop for maintenance.
1
4
Share

Where is the gear position switch located?

For manual transmissions, the reverse gear switch is located on top of the transmission in the engine compartment. For automatic transmissions, the gear position switch is situated beneath the gear lever. Here's relevant information: 1. Shift lock button: Automatic gear levers feature a shift lock button to prevent accidental operation and potential safety hazards. This button must be pressed when moving out of P (Park) position or shifting into R (Reverse) or P (Park). 2. S stands for Sport mode: When engaged, this mode allows free gear shifting while delaying shift timing to maintain higher engine RPM, thereby increasing vehicle power. Note that using this mode will significantly increase fuel consumption.
5
4
Share

What are the consequences of driving with the electronic parking brake engaged?

Here is a detailed introduction to the consequences of driving with the electronic parking brake engaged: 1. Degree of engagement and driving distance: If the parking brake is not engaged tightly and the driving distance is short, the impact on the car is minimal, but there will be increased wear on the parking brake pads and higher fuel consumption. 2. Tight engagement: If the parking brake is engaged tightly and not noticed, or if the car is driven at high speed over a long distance, the parking brake pads can wear out severely, potentially reaching the point of needing replacement after just one instance. Excessive wear and heat generation from the brake pads can cause smoke and a burning smell. The heat can also transfer to surrounding components, and high temperatures may reduce the strength of these parts or even cause deformation. 3. Assessing the outcome: If there is no smoke or strong burning smell, there is likely no issue, and no inspection is needed. However, if there is a strong burning smell and visible smoke, check whether the parking brake still functions properly—whether it releases fully when disengaged, whether the engagement force is the same as before, and whether it can still hold the car on a slope.
3
0
Share

How to Check the Owner of a License Plate Number?

Methods to check the owner of a license plate number: 1. Search for the vehicle management office online, then click to enter the online vehicle management office, and then click to enter the vehicle information inquiry; 2. Input the type of license plate and the license plate number that need to be queried, and click the query; 3. The inquirer can determine whether this is the vehicle they need to query through the body color, vehicle brand, driver, file number and other related vehicle information; 4. The person who needs to inquire can go to the insurance company with valid documents, and apply to find the owner according to the other party's license plate number reporting method. However, due to the protection of the owner's information by the insurance company, the required procedures will be more cumbersome.
13
5
Share

What Causes High Fuel Tank Pressure?

The causes of high fuel tank pressure are: blockage of the car fuel tank cap regulator valve, blockage of the carbon canister, or damage to the solenoid valve. If the car fuel tank cap regulator valve is blocked, it will result in excessively high pressure inside the fuel tank. In this case, it should be disassembled and cleaned. If the fuel tank is overfilled during refueling, some fuel may evaporate and enter the carbon canister, forming particles inside that can cause blockages. If the solenoid valve is damaged, the engine's pipeline system cannot properly ventilate to form a circuit, preventing the release of fuel vapor from the fuel tank, which will cause the internal pressure to rise. Excessively high fuel tank pressure can make refueling difficult, as fuel struggles to enter the tank. If the fuel tank pressure remains too high for an extended period, it can cause deformation of the fuel tank and potentially damage the fuel pump.
7
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.