Does the Honda Elysion belong to GAC or Dongfeng?

Why is the speed on highways required to be above 60 km/h?

After entering the highway, drivers must increase their speed to above 60 km/h to avoid affecting vehicles traveling on the main lanes when merging into traffic. Below is relevant information about highway speed limits: The maximum speed on highways must not exceed 120 km/h, and the minimum speed must not be lower than 60 km/h. For small passenger vehicles, the maximum speed is 120 km/h; for other motor vehicles, it is 100 km/h; and for motorcycles, it is 80 km/h. For roads with two lanes in the same direction, the minimum speed in the left lane is 100 km/h. For roads with three or more lanes in the same direction, the minimum speed in the leftmost lane is 110 km/h, and the minimum speed in the middle lane is 90 km/h. If the speed indicated by road signs differs from the above lane speed regulations, drivers should follow the speed indicated by the road signs.

4

Share

What is the function of a retarder?

Retarders are auxiliary braking devices for large vehicles (trucks, buses), allowing heavier vehicles to decelerate smoothly without consuming the braking system. Currently, electromagnetic retarders are more commonly used, along with hydraulic turbine retarders. Electromagnetic retarder: It is equivalent to installing a "generator" on the driveshaft. When not electrified, there is no contact or wear. When deceleration is needed, the driver turns on the switch on the dashboard, and the driveshaft is subjected to the resistance of the electromagnetic field, achieving the braking effect. Hydraulic turbine retarder: An additional turbine chamber is added at the rear end of the transmission housing. When the braking circuit is activated, the transmission oil is pressurized in the turbine to create damping and achieve the braking effect. There is no wear, but additional heat dissipation is required. These are rarely used domestically.

11

0

Share

Should the Roewe RX5 use 92 or 95 octane gasoline?

According to the official vehicle manual recommendation, the Roewe RX5 should use 92 octane gasoline. In addition to checking the appropriate gasoline grade in the vehicle manual, the Roewe RX5 can also refer to the label on the fuel tank cap. Typically, the required gasoline grade can also be determined based on the engine's compression ratio. Vehicles with a compression ratio between 8.6-9.9 should use 92 octane gasoline, while those with a compression ratio between 10.0-11.5 should use 95 octane gasoline. However, with the application of new technologies, the compression ratio alone cannot determine the required gasoline grade, as high-compression engines can also be tuned to use lower-octane gasoline. Other factors, such as ignition timing, turbocharging technology, and Atkinson cycle technology, also play a role. Generally, the higher the gasoline octane rating, the higher the octane number and the better the anti-knock performance. 92 octane gasoline contains 92% isooctane and 8% n-heptane, while 95 octane gasoline contains 95% isooctane and 5% n-heptane. If the Roewe RX5 occasionally uses the wrong gasoline grade, simply refuel with the correct grade afterward. However, prolonged use of the wrong gasoline grade can have the following effects: For vehicles designed for lower octane gasoline, using higher octane fuel will not cause damage, but the increased octane number may alter the fuel's ignition point, leading to delayed combustion in the engine. This reduces the engine's power output and thermal efficiency, resulting in poorer performance. For vehicles designed for higher octane gasoline, using lower octane fuel can cause engine knocking. Due to the significantly lower octane number, the fuel may ignite prematurely during the compression stroke, creating resistance before the spark plug fires. This resistance leads to unstable engine operation. Mild knocking may only increase noise without significant engine damage, but severe knocking indicates serious engine issues, affecting driving stability and causing abnormal wear on pistons and cylinders, potentially leading to cylinder scoring.

18

0

Share

How many points are deducted for driving in the wrong direction on a national highway?

Driving in the wrong direction refers to motor vehicles or non-motor vehicles traveling on the left side of the road, which is considered as driving in the wrong direction. Driving in the wrong direction on a national highway results in a deduction of 3 points and a fine. Traffic safety laws stipulate: According to Article 90 of the "Road Traffic Safety Law of the People's Republic of China", if a motor vehicle driver violates the road traffic safety laws and regulations regarding road traffic rules, they shall be given a warning or fined. If there are other provisions in this law, the punishment shall be imposed in accordance with those provisions. Precautions: If you find yourself driving in the wrong direction on a highway by mistake, you should immediately pull over to the emergency lane while ensuring traffic safety, turn on the hazard lights, move all passengers to a safe area outside the guardrail, place a warning triangle 100 meters in front of the vehicle, and then contact the traffic police. Cooperate fully with the traffic police when they arrive at the scene.

1

Share

Where to Place the Jack When Changing a Car's Front Tire?

When changing a front tire, place the jack under the car's chassis on the raised part of the side rail near the tire you are replacing. This raised edge is usually double-layered. Ensure the grooved end of the jack fits securely into it. Before lifting, it's advisable to loosen the nuts of the tire you're removing by one turn before raising the jack. When changing a car tire, the jack should be placed in the following location: Align the jack with the vehicle's chassis support points. Near the wheels on both sides of the vehicle's chassis, there are designated support points for the jack to contact. The lifting part of the jack must be positioned on these chassis support points. Otherwise, it will be difficult to stabilize the vehicle, and the jack may be damaged or even harm the chassis. After lifting the vehicle, take necessary safety measures. Before replacing the spare tire, place it under the car. In case the jack fails, the spare tire can prevent the car from falling directly. Additional precautions when changing car tires include: Choose the right tire. The specifications of the new tire must match the previous one and should be identical to the other tire on the same axle. Replace the valve stem as well. This is because the aging cycles of the new tire and the old valve stem differ, and the valve stem might fail during the lifespan of the new tire. It's best to install new tires on the rear axle. If more worn tires are placed on the rear axle, they reduce the rear wheels' water drainage capacity, increasing the risk of driving in wet conditions. Avoid sudden braking after installing new tires. New tires have deeper treads and more tread hairs, and they haven't fully broken in with the road surface. Sudden braking can affect the vehicle's braking performance.

7

2

Share

Can FLAC files be played in a car?

Whether FLAC format music can be played in a car depends on whether the installed player in the car model supports FLAC format music. Therefore, some vehicles can play FLAC files while others cannot. However, most vehicles support WAV or MP3 format music. The reason why the vast majority of vehicles support MP3 or WAV format music, while only a few models support FLAC format music, is that MP3 compression encoding is lossy audio, whereas FLAC compression encoding is lossless audio. This means that when audio is compressed with FLAC encoding, there is no loss of information. When FLAC format is restored to WAV format, it is almost identical to the original WAV format before compression. Comparing FLAC and WAV in-car audio, WAV has slightly better sound quality than FLAC. The difference between WAV and FLAC is very minimal, and it's hard to notice the difference without careful listening. FLAC is derived from WAV compression—WAV compressed by half becomes FLAC. This indicates that the memory size of WAV lossless format is twice that of FLAC. In theory, WAV format should have better sound quality than FLAC format. Steps to convert FLAC format to MP3 format: Download and open a FLAC file converter, then click the option to add files; A new window will pop up on the interface. Click on the FLAC format music you want to convert, then click Open; Check the box in front of the FLAC format music you want to convert, then click Start Conversion at the bottom left of the converter; Select the save directory for converting FLAC format to MP3 format, then click OK at the bottom right; The FLAC file batch converter will convert the FLAC format songs to MP3 format. Once the conversion is successful, a new window will pop up with a notification, allowing you to play the music in your car.

5

2

Share

Does the Honda Elysion belong to GAC or Dongfeng?

Why is the speed on highways required to be above 60 km/h?

What is the function of a retarder?

Should the Roewe RX5 use 92 or 95 octane gasoline?

How many points are deducted for driving in the wrong direction on a national highway?

Where to Place the Jack When Changing a Car's Front Tire?

Can FLAC files be played in a car?

What is the difference between yellow guide lines and white guide lines?

How long after replacing the engine should I go to the vehicle management office for registration?

What is a Coffin Car?

Does scraping the car chassis cross member have any impact?