Does the Haval H5 meet China 6 emission standards?

How to take out the spare tire of Cadillac XT5?

To take out the spare tire of Cadillac XT5, follow these steps: 1. Open the liftgate; 2. Lift the trunk floor cover; 3. Turn the wing nut counterclockwise to remove the spare tire and place it next to the tire to be replaced; 4. Take out the jack, wrench, extended wheel bolt for securing the damaged wheel, and towing hook from under the spare tire. The Cadillac XT5 is a mid-size 5-door, 5-seat SUV with body dimensions of 4813mm in length, 1903mm in width, and 1682mm in height, with a wheelbase of 2857mm. It is equipped with a 2.0T turbocharged engine and a 9-speed automatic transmission, delivering a maximum power of 174 kW and a maximum torque of 350 Nm. The drive system is front-wheel drive, with a MacPherson strut front suspension and a five-link independent rear suspension.

2

0

Share

Should You Accelerate or Decelerate When Driving Through Puddles?

When driving through puddles, you should slow down and pass through gradually. Here are some precautions to take when driving through puddles: 1. Brake gently: On rainy days, always brake gently to avoid sudden stops. Generally, passenger cars can handle water depths of 15-20 cm in urban areas without issues. The key is to avoid driving too fast and minimize splashing by using a low gear. 2. Never drive through ditches or puddles at high speed: Excessive speed can cause water to splash, increasing the actual wading depth and potentially leading to engine water intake. Avoid driving through water if it exceeds the centerline of your tires. 3. Clean side mirrors: Raindrops on the side mirrors can create blind spots for the driver, so it's important to clean them regularly. When changing lanes, drivers should also be extra cautious. In cases of heavy rain or severe thunderstorms, park the vehicle in a higher location to avoid flooding.

17

0

Share

Where is the oil pressure sensor located on the Mercedes-Benz 274 engine?

The oil pressure sensor on the Mercedes-Benz 274 engine is generally located at the rear of the engine, on the cylinder block, next to the oil filter housing. Introduction to the pressure sensor: The electronic oil pressure sensor consists of a thick-film pressure sensor chip, signal processing circuit, housing, fixed circuit board assembly, and two leads. The signal processing circuit includes a power supply circuit, sensor compensation circuit, zero adjustment circuit, voltage amplification circuit, current amplification circuit, filtering circuit, and alarm circuit. Working principle of the pressure sensor: When the measured liquid pressure acts on the ceramic elastic body, the elastic diaphragm undergoes deflection deformation. Simultaneously, the thick-film resistors printed and fired on the elastic diaphragm experience the same amount of strain. Among them, two thick-film resistors are subjected to compressive strain, resulting in a decrease in resistance value, while the other two are subjected to tensile strain, leading to an increase in resistance value. In this way, the measured pressure value is converted into a bridge output signal, with the signal magnitude being proportional to the pressure.

6

4

Share

What are the reasons why the Hyundai ix25 cannot start with one key?

Hyundai ix25 one-key start not responding: It may be due to the smart key running out of battery. After opening the car door, place the smart key into the storage box behind the handbrake, and then you can perform the one-key start. Additionally, a locked steering wheel or the gear not being in the P position may also prevent the car from starting. Relevant information about the one-key start is as follows: 1. Introduction: The one-key start device is part of a smart car, a button device that simplifies the starting process and can also turn off the engine. This device can be retrofitted at the original car key lock position or as an independent panel. 2. Function: Different from the traditional mechanical key ignition method and the conventional starting procedure, simply pressing the one-key start button can start or turn off the engine, avoiding the hassle of losing or searching for keys. During the ignition process, most of the time, the foot brake needs to be pressed.

13

2

Share

Is a car's water temperature of 100 degrees Celsius normal in summer?

It is abnormal for a car's water temperature to reach 100 degrees Celsius in summer. Extended information is as follows: 1. Under normal circumstances: Check whether the liquid level in the coolant replenishment tank is appropriate; then start the engine and observe the water temperature gauge as the temperature gradually rises. Feel the upper radiator hose with your hand, and it should gradually warm up; the lower radiator hose should remain almost unchanged in temperature. 2. After the engine warms up: The cooling fan also operates, but when the water temperature exceeds 95°C, the lower hose may be slightly cooler than the upper hose. The reason is that the thermostat opening is insufficient, reducing the coolant circulation flow, and the amount of water flowing from the engine into the radiator decreases, causing the engine's heat to not be dissipated in time, thereby increasing the engine's coolant temperature. 3. When the water temperature gauge rises to 95°C: Both the upper and lower hoses should be equally hot to the touch. The reasons could be a damaged cooling fan or circuit, a faulty thermal switch on the radiator, or a blown fuse. A blown fuse is often accompanied by or hides early faults in the circuit or fan.

16

5

Share

Should the Handbrake Be Engaged When Parking an Automatic Transmission Vehicle?

When parking an automatic transmission vehicle, the handbrake should be engaged. The method for parking an automatic transmission vehicle is as follows: 1. Press the foot brake; 2. Shift from N (Neutral) to R (Reverse); 3. Release the handbrake; 4. Check the rearview mirror to observe the path behind; 5. Gradually release the foot brake; 6. After reversing to the designated position, press the foot brake, engage the handbrake, and then release the foot brake; 7. Press the foot brake and shift from R (Reverse) to N (Neutral); 8. Release the foot brake. The gears of an automatic transmission vehicle are as follows: 1. D (Drive) is the forward gear; 2. S (Sport) is the sports mode driving gear; 3. P (Park) is the parking gear; 4. N (Neutral) is the neutral gear; 5. L (Low) is the low-speed gear; 6. W (Winter) is the snow and rain gear; 7. R (Reverse) is the reverse gear.

20

3

Share

Does the Haval H5 meet China 6 emission standards?

How to take out the spare tire of Cadillac XT5?

Should You Accelerate or Decelerate When Driving Through Puddles?

Where is the oil pressure sensor located on the Mercedes-Benz 274 engine?

What are the reasons why the Hyundai ix25 cannot start with one key?

Is a car's water temperature of 100 degrees Celsius normal in summer?

Should the Handbrake Be Engaged When Parking an Automatic Transmission Vehicle?

How to Play Music via Bluetooth in a Buick Car?

Which country is the Monroe shock absorber brand from?

Is 20 liters per 100 kilometers considered high fuel consumption?

Why is 40-weight oil recommended for the Audi A3?