Does the Geely King Kong have an automatic car locking function?

1 Answers
ElleDella
07/30/25 3:57am
Geely King Kong does not have an automatic car locking function. The owner can directly control the door switch via the remote key, which is convenient and worry-free. If the door is not properly closed when locking, the car will automatically sound a horn warning. Geely King Kong automatic window closing function: Geely King Kong is equipped with a thoughtful automatic window closing device. Simply press the lock button on the remote twice, and any unclosed windows will automatically close. Principle of automatic car locking: The automatic car locking system uses RFID (Radio Frequency Identification) technology. Typically, when the owner approaches the vehicle within about one meter, the door locks will automatically open and the anti-theft system will be deactivated. When leaving the vehicle, the door locks will automatically lock and enter the anti-theft state. When the owner enters the vehicle, the in-car detection system will immediately recognize the smart card, and then the vehicle can be started normally by simply pressing the start button (or turning the knob).
Was this review help?
3
4
Share
More Forum Discussions

What is the function of the secondary air pump?

The following is an introduction to the function of the secondary air pump: It draws fresh air into the air pump and then injects it into the exhaust system. The fresh air entering the exhaust system accelerates the catalytic reaction of the three-way catalytic converter, converting carbon monoxide and hydrocarbons in the exhaust gas into carbon dioxide and water, thereby serving an environmental protection function. It operates for a maximum of five minutes; it helps the three-way catalytic converter reach its working temperature sooner, reducing harmful substances in the exhaust gas and serving an environmental protection function. The working principle of the secondary air pump: When the engine is running, the air pump is driven by the crankshaft belt, pumping a large volume of low-pressure air flow through a hose into the diverter valve. Under normal conditions, the valve on the diverter valve opens, and the air flows through the diverter valve and check valve into the air injection manifold.
18
3
Share

How Many Times Can You Take the Driving License Subject 1 Exam?

For the Subject 1 exam on the same day, you can take it twice. If you fail the first time, you can retake it for free the second time. If you still fail the second time, the Subject 1 exam will be terminated, and you can only schedule another exam after ten days. Subjects 2 and 3 have five attempts, with one free retake per exam. If you do not pass within the five attempts, you will have to start learning from Subject 1 again. Below is more relevant information: Notes for the Subject 1 Exam: 1. Receive the Subject 1 exam voucher, carefully check the information on the voucher, and follow the instructions to the designated exam venue and session. 2. Arrive at the exam venue early or on time, and enter with your ID card and exam voucher. 3. Take your seat according to the assigned number. The exam is monitored by cameras capturing your face throughout, so ensure your entire face is clearly visible to the camera. Do not cover your face with hair, hands, scarves, clothing, etc., or you will be marked as failing.
4
5
Share

What Types of Car Insurance Can You Purchase?

Vehicle insurance must include compulsory traffic insurance, third-party liability insurance, vehicle damage insurance, and comprehensive vehicle insurance. Here is more relevant information: 1. Comprehensive vehicle insurance includes: compulsory traffic insurance + vehicle damage insurance + third-party liability insurance + no-deductible insurance + passenger liability insurance, etc. If conditions permit, you can also add theft insurance, glass insurance, body scratch insurance, and spontaneous combustion insurance. 2. Third-party liability insurance: Like compulsory traffic insurance, third-party liability insurance compensates the injured third party, essentially serving as a supplement to compulsory traffic insurance. The compensation limit of compulsory traffic insurance is limited and relatively low, or you can opt for higher coverage.
3
5
Share

What should be paid attention to in Subject 2?

Precautions for Subject 2 exam: 1. Before the exam: Dress comfortably and be mentally prepared; pay attention to key points when reversing into the garage, do not turn left or right; when parallel parking, ensure the rear wheel exceeds the edge line of the garage, adjust the distance properly, remember to turn on the turn signal and honk the horn. 2. During the exam: When making a sharp turn, steer the wheel decisively after aiming at the right position; when driving on a curve, make wide turns after entering the curve, maintain a steady speed, and avoid crossing the line in all the above situations. 3. After the exam: Drive the car back to the starting position after the exam, sign for confirmation before turning off the engine. 4. Mock exam: The purpose of the mock exam is to familiarize candidates with the exam environment and allow the instructor to point out areas prone to deductions, so the mock exam is absolutely essential. Being well-prepared is the best way to face the challenge.
2
3
Share

What does truck gear ratio mean?

Gear ratio refers to the transmission ratio of the internal transmission gears in a vehicle. There are many gears in a truck's transmission, and the transmission ratios between these gears vary. Vehicles also have main reduction gears, and different vehicle models have different main reduction gear ratios. Related information: When starting a car normally, first gear is required. First gear has a relatively large transmission ratio, resulting in greater torque, which allows the vehicle to start smoothly. However, the speed in first gear is not very high, and most vehicles can only reach a maximum speed of 20 kilometers per hour in first gear. If a small gear drives a large gear to rotate, the transmission ratio is relatively large, resulting in greater output torque. If a large gear drives a small gear to rotate, the transmission ratio is relatively small, resulting in higher output speed. Function of reduction gears: The main reduction gear in the vehicle differential serves to reduce speed and increase torque. When the engine operates normally, the speed is very high, so the transmission and main reduction gear are needed to reduce the speed, thereby increasing torque and allowing the vehicle to drive normally. Truck gear ratio: The gear ratio of a truck generally refers to the ratio of the main reduction gear. This ratio is fixed, and changing it requires replacing the main reduction gear.
19
1
Share

What is the e3 car?

e3 is the third-generation evolution of Mitsubishi's EVO. It is also the first prototype of Toyota's classic sports car, the Corolla. FC is the nickname for Mazda's twin-rotor engine sports car, also known as the "Twin Star" RX-7. Here is an introduction to the e3: 1. Exterior: All aerodynamic components, including the front bumper, front lip, side skirts, rear bumper, and rear spoiler, have been completely renewed. In other words, to meet the challenges of higher speeds, the goal was to increase downforce and significantly improve aerodynamics. Additional air intakes were added on both sides of the front lip to enhance the cooling of the braking system. The rear spoiler was widened to match the width of the car body, ensuring better downforce. 2. Configuration: To meet the demands of WRC challenges, more powerful performance was essential. Therefore, the first improvement was the pistons, increasing the compression ratio from 8.5 to 9.0, and the turbocharger was redesigned to enhance power output at high RPMs. Additionally, the exhaust system's pipe diameter was enlarged to reduce backpressure, increasing horsepower by 10 to reach 270 HP. With a 2.0L displacement, it delivers 270 HP.
15
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.