Does the Dongfeng Nissan P0846 fault need to be repaired?

3 Answers
AndrewDella
07/28/25 1:06pm
Dongfeng Nissan Sylphy has a P0846 fault code, which indicates that the transmission pressure sensor switch is closed and the transmission solenoid valve is damaged. The transmission valve body needs to be replaced. The following are related symptoms of a damaged transmission valve body: 1. The transmission contains electronic components such as oil temperature sensors, speed sensors, and solenoid valves. When a fault occurs, the computer can detect it, and the fault light will illuminate to alert the driver, putting the transmission into a lock-up state, also known as protection mode. 2. During driving, there is a noticeable jerking sensation when shifting gears, and the vehicle may shake. This is caused by excessively high transmission oil temperature, internal stubborn dirt and impurities, leading to blockages in the valve body, which results in transmission jerking.
Was this review help?
17
3
Share
StDawson
08/11/25 5:47pm
I've encountered similar issues. As someone who's been driving for nearly a decade, I strongly advise not to ignore the P0846 fault code. It indicates problems with the transmission sensor or circuitry, which can cause severe gear shifting hesitation - especially dangerous on highways. I remember a friend's Nissan had this code; he delayed repairs and ended up paying much more for a full transmission replacement. If you notice this issue, visit an authorized 4S shop immediately. Their diagnostic tools can pinpoint whether it's a faulty sensor, wiring issue, or just a blown fuse (sometimes a minor part replacement solves it). Never postpone repairs, particularly if you frequently drive in stop-and-go traffic - repeated jerking accelerates transmission wear and poses major safety risks. Early repairs save money and prevent nighttime roadside breakdowns. Safety first: address this promptly without gambling with your vehicle's condition.
Was this review help?
3
2
Share
Expand All
OEllie
09/28/25 8:05am
As an owner of an older Nissan model, I'd say whether to repair the P0846 fault depends on your budget. It might be an issue with the transmission pressure sensor. If left unrepaired, you might only experience slight jerking in the short term, but long-term neglect could worsen the transmission, multiplying repair costs several times over. I've consulted several repair shops - replacing a standard sensor costs just a few hundred, but transmission damage could run into thousands or even tens of thousands. After weighing the options, I don't think it's worth the risk, especially since such faults are common in Nissans. Pay attention to driving habits like avoiding sudden acceleration to prolong component life. The money-saving approach is addressing minor issues early before they strand you roadside. Safe driving is paramount - this fault increases accident risks in complex road conditions. I suggest first checking fuses or wiring yourself; handle simple fixes, but consult professional technicians for complex issues.
Was this review help?
14
1
Share
Expand All
More Forum Discussions

How many cylinders does the Nissan X-Trail engine have?

Dongfeng Nissan X-Trail is equipped with a four-cylinder engine. Below is the relevant introduction: Market performance of the X-Trail: As the mainstay of Nissan in the compact SUV market, the X-Trail has consistently demonstrated outstanding market performance. Its early rugged style made it unique, and after the facelift, it decisively transformed, successfully joining the ranks of urban SUVs and catching the strong growth period of the market, achieving both fame and fortune. The 2019 X-Trail was officially launched not long ago. Although the annual facelift did not bring many changes in design, the upgraded configuration still maintains its sufficient competitiveness, and the cost-performance ratio is more advantageous compared to the older models. In terms of recommended choices: The 2.0L Comfort version is the second lowest trim in the entire lineup, belonging to the mid-range version among the 2.0L models, with significantly improved configurations compared to the entry-level model.
18
3
Share

Does the BMW 1 Series automatically cut off power after turning off the engine?

Generally, most electrical appliances are turned off after the engine is shut down, but some remain powered, such as the cigarette lighter and keyless start sensors. Additionally, if there are additional devices like anti-theft systems or dashcams, it depends on where the power is connected. Circuits directly connected to the battery line remain powered continuously, while those connected after the ACC (accessory) turn on with ignition and off with engine shutdown. More details are as follows: 1. Powertrain: The BMW 1 Series is the entry-level model of imported BMWs, available in both hatchback and sedan versions. It offers a relatively wide range of engine options, including 1.5T, 2.0T, and 3.0T. 2. Exterior: The new imported BMW 1 Series hasn't changed much in appearance, featuring 17-inch and 18-inch wheel options. It retains the familiar kidney grille and maintains its consistent sporty style, with youthfulness, fashion, and dynamism remaining its biggest highlights. The sleek design is very dynamic and highly aggressive.
18
5
Share

Location of the Automotive Oxygen Sensor?

An automobile has two oxygen sensors, installed in the exhaust pipe. Below is an introduction to the two oxygen sensors in a car: 1. One is located before the three-way catalytic converter, referred to as the primary oxygen sensor or upstream oxygen sensor, used for mixture feedback control. The engine control unit adjusts the fuel injection quantity based on the feedback signal from the primary oxygen sensor, maintaining the actual air-fuel ratio close to the theoretical air-fuel ratio, to detect the oxygen concentration before catalytic conversion. 2. The other is located after the three-way catalytic converter, known as the secondary oxygen sensor or downstream oxygen sensor, used to monitor the catalytic purification efficiency of the three-way catalytic converter. When the three-way catalytic converter is damaged and its conversion efficiency is lost, it is almost equivalent to not having a three-way catalytic converter installed. The signal voltage waveforms of the front and rear oxygen sensors become similar, and the voltage fluctuation ranges also tend to be consistent, indicating a decline in the conversion capability of the three-way catalytic converter.
9
0
Share

The Pros and Cons of Engine Insulation Cotton

Engine insulation cotton not only effectively slows down the aging of the paint surface but also prevents rapid heat loss from the engine compartment. However, the downside of engine insulation cotton is that it can increase the load pressure on the overall cooling system. Below is a detailed introduction: 1. Definition of insulation cotton: Broadly speaking, any cotton product that provides thermal insulation can be referred to as insulation cotton. 2. Characteristics of insulation cotton: Insulation cotton is resistant to high temperatures, difficult to burn, and has a low thermal conductivity. Currently, most industrial insulation cotton is made from glass fiber, such as fiberglass cotton and glass wool. These products can be further processed by combining them with aluminum foil or fiberglass cloth, making their applications even broader. 3. Function of insulation cotton: Insulation cotton is generally installed under the car hood. Its functions include sound insulation, heat insulation, vibration damping, and preventing paint discoloration due to high temperatures.
7
0
Share

How many seconds does the RAV4 take to accelerate from 0 to 100 km/h?

9.6 seconds (0-100km/h). Below is the relevant introduction: Toyota RAV4: The Toyota RAV4 is the base model in Toyota's compact multi-purpose off-road vehicle family. Its name comes from the abbreviation of "Recreational Active Vehicle with 4-wheel drive," meaning "four-wheel-drive recreational sports vehicle." Model introduction: At the Los Angeles Auto Show closing at the end of 2012, the fourth-generation RAV4 was officially launched. The new model adopted a completely new exterior and interior design style, with the overall styling further evolving towards an urban SUV, while the off-road style gradually faded from this model. Vehicle positioning: The RAV4 is positioned as an urban SUV. As a leader in urban SUVs, the RAV4 combines high quality and performance with driving comfort and excellent off-road capability, capable of handling both ON-ROAD and OFF-ROAD sections freely to meet diverse lifestyle needs—a high-performance urban SUV that "adapts effortlessly."
6
4
Share

What is the ground clearance of the RAV4 in centimeters?

Minimum ground clearance is 193mm. Below are relevant details: Introduction: The Toyota RAV4 is the base model in Toyota's compact multi-purpose off-road vehicle family. Its name derives from the abbreviation of "Recreational-Active-Vehicle with 4-wheel drive," meaning "four-wheel-drive recreational sports vehicle." Features: Combines the "powerful dynamism" of an SUV with "urban simplicity," featuring a sporty and stylish design; employs P/F·E/G for passenger car use, achieving both off-road and urban road high-performance and ride comfort; body layout integrates the excellent cabin space unique to SUVs with the flexibility specific to passenger cars; high practicality: large-capacity storage boxes, 6:4 split seats, ergonomically designed center console (self-illuminating instrument panel). China-specific configurations: Added E/G grade (CBU only); separately added M/T (CBU only has A/T).
20
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.