Does the Chery QQ have a three-way catalytic converter?

How many seats does the Avancier have?

The Avancier is a 7-seater vehicle. Below are the detailed specifications of the Honda Avancier: 1. Configuration: The Avancier is equipped with an ANC active noise cancellation system, a large-capacity sliding center console at the front, and a rear central control system with audio control buttons. 2. Powertrain: It comes with two powertrain options: a 1.5T and a 2.0T engine. The mid-to-low trim models are powered by a 1.5T turbocharged engine, delivering a maximum horsepower of 193Ps, a maximum power of 142kW, and a peak torque of 243N.m, paired with a CVT continuously variable transmission. The high-end models feature a 2.0T direct-injection VTEC turbocharged engine, producing a maximum horsepower of 272Ps, a maximum power of 200kW, and a peak torque of 370N.m, mated to a 9-speed automatic transmission.

15

0

Share

What are the gear positions of GAC Trumpchi automatic transmission vehicles?

Here is an introduction to the gear positions of GAC Trumpchi automatic transmission vehicles: 1. P (Parking) gear: Used for parking and starting. When the vehicle is parked and not in use, the gear should be in P position, which mechanically locks the wheels to prevent the car from rolling. 2. R (Reverse) gear: Used for reversing. 3. N (Neutral) gear: Used for temporary parking. This position indicates neutral, and the brake must be applied to prevent the vehicle from rolling on a slope. 4. D (Drive) gear: Used for forward movement, also known as the driving gear. 5. L (Low) gear: Used when going downhill or on long slopes. Engaging this gear restricts the car to the lowest gear, allowing the engine to assist in braking, preventing the driver from having to apply the brakes for extended periods, which could overheat the brake pads and cause danger. 6. OD (Overdrive) gear: Used for high-speed driving.

15

5

Share

Does crossing the stop line with the front wheels count as running a red light?

No. If the vehicle's front wheels have just crossed the stop line when the light turns red, and the vehicle stops immediately without moving, it will not be considered running a red light. However, if the vehicle continues to move in violation of the rules, it will be deemed as running a red light. According to Article 90 of the new traffic regulations: driving a motor vehicle in violation of traffic signal lights will result in a 6-point deduction and a fine of 200 yuan. If the vehicle completes crossing the line and continues to move until it is fully past the line before stopping, affecting the passage of other vehicles and pedestrians, according to Article 3, Section 7 of the Road Traffic Safety Law: violating the prohibition sign will result in a 3-point deduction and a fine of 100 yuan. Crossing the stop line can be divided into two situations: the front wheels crossing the stop line, or the entire vehicle crossing the stop line. The Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China, Article 38: motor vehicle signal lights and non-motor vehicle signal lights indicate: When the green light is on, vehicles are allowed to pass, but turning vehicles must not obstruct the passage of straight-moving vehicles and pedestrians. When the yellow light is on, vehicles that have already crossed the stop line may continue to pass. When the red light is on, vehicles are prohibited from passing. When the red light is on, right-turning vehicles may pass if they do not obstruct the passage of other vehicles and pedestrians. At intersections without non-motor vehicle signal lights or pedestrian crossing signal lights, non-motor vehicles and pedestrians should follow the motor vehicle signal lights. The new traffic regulations clearly stipulate that the following three conditions must be met to constitute running a red light: The vehicle illegally crosses the stop line. The vehicle illegally enters the intersection. The vehicle illegally crosses the opposite stop line. Running a red light can be determined with just three photos: A photo showing the front wheels not crossing the stop line when the red light is on, a photo of the vehicle passing the middle of the road, and a photo of the vehicle reaching the opposite road; these three clear photos can prove the vehicle's movement trajectory after the red light turns on, thus determining the act of running a red light. Drivers should pay attention to the following three situations: If the vehicle's front wheels cross the stop line or both front and rear wheels cross the stop line but the rear of the vehicle does not cross the stop line, and the vehicle stops immediately, the traffic police will not penalize it as running a red light, but may penalize it for stopping beyond the line. If the vehicle's front wheels cross the stop line, regardless of whether the entire vehicle has fully crossed the stop line, and the vehicle stops and then reverses back, if caught by electronic surveillance with two complete movement images, it will be treated as running a red light, resulting in a 6-point deduction and a fine of 200 yuan. If the entire vehicle fully crosses the stop line and stops or continues to move forward, and within one red light cycle, the electronic surveillance captures three complete images constituting the act of running a red light, regardless of whether the vehicle reaches the intersection or crosses the opposite stop line, it will be considered as running a red light and penalized accordingly.

15

2

Share

How to install the license plate on a Volkswagen Polo?

Here are the steps to install the license plate on a Volkswagen Polo: 1. After receiving the license plate, there is usually a pack of secure screws included. Open it and check if the screws are sufficient. According to regulations, vehicles must now have 4 screws installed on both the front and rear license plates, totaling 8 mounting holes. 2. Take out the license plate screws and insert them into the anti-theft caps while rotating (be careful not to screw them in the wrong direction). 3. Then, position the license plate correctly and align the screws with the four gaps on the bumper. Use a cross-head screwdriver to secure them. Since these screws cannot be removed once tightened, do not apply full force initially. After all four screws are in place, tighten them individually. 4. Once tightened, cover the screws with the anti-theft caps by pressing them gently into place.

7

1

Share

Where is the fuel pump relay located on the Jianghuai Refine?

The fuel pump relay of Jianghuai Refine is located on the right side of the driver's position. After removing the storage compartment, you will find a metal pillar in the upper right corner of the engine compartment's fuse box, towards the front right. This is where the main engine relay and fuel pump relay are connected together. Below is an introduction to the Refine S3: 1. The Refine S3 is a compact SUV under Jianghuai's brand, with dimensions of 4345mm in length, 1765mm in width, and 1640mm in height, and a wheelbase of 2560mm. 2. This vehicle is equipped with two engines: a 1.5-liter naturally aspirated engine producing 113 horsepower and 146 Nm of maximum torque, and a 1.6-liter naturally aspirated engine delivering 120 horsepower and 150 Nm of maximum torque.

6

0

Share

Will the sunroof not leak if it is not opened?

Not opening the sunroof does not necessarily prevent leakage, as aging seals can also cause leaks. Below is an introduction to the advantages of a car sunroof: Cooling: Utilizing the negative pressure formed on the roof during vehicle movement to extract hot air can achieve rapid ventilation and cooling. This method is 2-3 times faster than using the car's air conditioning for cooling. Ventilation: When the car is moving at high speed, air flows quickly around the vehicle. Opening the sunroof creates a negative pressure zone outside the car, which, due to the difference in air pressure inside and outside, helps extract stale air from the cabin, maintaining fresh air inside. Auxiliary defogging: Keeping the side windows closed while driving increases the temperature difference between the inside and outside of the car, leading to fog formation on the front windshield. Although most cars are equipped with anti-fog devices, some may not be very effective. Simply opening the sunroof to the rear-ventilation position can easily eliminate fog on the front windshield, ensuring driving safety.

4

1

Share

Does the Chery QQ have a three-way catalytic converter?

How many seats does the Avancier have?

What are the gear positions of GAC Trumpchi automatic transmission vehicles?

Does crossing the stop line with the front wheels count as running a red light?

How to install the license plate on a Volkswagen Polo?

Where is the fuel pump relay located on the Jianghuai Refine?

Will the sunroof not leak if it is not opened?

What problems will occur if the carbon brush is broken?

Can the Wuling Mini last for 5 years?

Will a Faulty Canister Purge Solenoid Valve Significantly Increase Fuel Consumption?

Does Water in the Charcoal Canister Affect the Car?