Does the car transmission fluid need to be changed?

1 Answers
Henry
07/29/25 3:09pm
Transmission fluid needs to be replaced. If you need to replace the transmission fluid, the replacement method is as follows: 1. Before changing the oil, to avoid damaging the transmission, you must strictly follow the vehicle manufacturer's instructions, such as not running the engine or towing the vehicle when there is no lubricating oil in the transmission; 2. Remove the drain plug at the bottom of the oil pan, drain the old oil from the transmission, and collect it in a suitable container; 3. Loosen the oil pan screws in the order specified by the vehicle manufacturer to avoid deformation of the oil pan, then remove the old filter and permanent magnet, and clean the residual oil on the oil pan; 4. Install the new filter and sealing ring, and tighten the screws with the specified torque.
Was this review help?
16
4
Share
More Forum Discussions

Which gear starts faster, D or L?

D gear starts faster than L gear. The following is a detailed introduction to car gears: 1. P gear is the parking gear: When the gear lever is in the P position, the transmission is in neutral, but the output shaft is mechanically locked. At this time, the car will stop in place even without stepping on the brake. It is generally used for long-term parking of the car. When engaging the P gear, the car must be completely stationary. Do not engage the P gear when the car has not come to a complete stop, and the handbrake must be applied. When parking on a slope, the handbrake should be applied first before engaging the P gear. 2. R gear is the reverse gear: When the gear lever is in the R position, the rotation direction of the transmission output shaft is opposite to that of the engine, allowing the car to move backward. When engaging the R gear, the car must be completely stationary. Do not engage the R gear when the car has not come to a complete stop. 3. N gear is the neutral gear: When the gear lever is in the N position, the gears inside the transmission are in free rotation, and the clutch is not engaged, resulting in the minimum load on the transmission. The N gear is generally used for short-term parking, such as waiting at a red light, and the transmission should also be in the N gear when the car is being towed. 4. D gear is the drive gear: When the gear lever is in the D position, the gears inside the transmission automatically switch between the lowest and highest gears according to the vehicle speed, throttle opening, and other factors based on the preset shifting pattern. In most cases, the D gear can be used for driving.
17
2
Share

How Many Kilometers Can BYD New Energy Vehicles Run?

The range of BYD pure electric vehicles is between 305 kilometers and 520 kilometers, influenced by the energy density of the vehicle's battery. Methods to increase the range are as follows: Try not to increase the vehicle's weight. Maintain tire pressure at the standard value (AionS standard tire pressure is 250kPa). Choose roads with relatively better surfaces whenever possible. At high speeds, wind resistance significantly impacts electricity consumption; control your speed and avoid excessively high speeds. Frequent rapid acceleration and deceleration increase electricity consumption; try to start smoothly and maintain a constant speed. Using single-pedal mode and extreme energy-saving mode results in lower electricity consumption and more energy recovery, which can increase the range to some extent. Use the air conditioning wisely; it is recommended to set the temperature between 24-26°C with lower fan speed. Use the vehicle's comfort features (such as seat welcome function, seat ventilation, and heating) reasonably as needed. Use lights, multimedia, and other functions reasonably as needed. Prefer slow charging whenever possible (the charging cutoff strategy is determined by the single-cell voltage reaching a certain value. With DC fast charging, the charging current is relatively large, and the single-cell voltage rises quickly. When fast charging shows full, it may not actually be fully charged). 11. It is recommended to plug in the charging gun to preheat the battery before and after using the vehicle in winter (when the battery temperature is low, the temperature control system HVH will activate to heat the battery, consuming some electricity. Choosing plug-in heating can replenish the electricity consumed by the heater in time, improving the range).
13
0
Share

What does Porsche TPMS malfunction mean?

TPMS malfunction refers to a Tire Pressure Monitoring System failure. The illumination of this warning light alerts the driver to abnormal tire pressure, which may be caused by insufficient pressure in one of the tires. It is advisable to check the tire pressure as soon as possible. Increased fuel consumption with low tire pressure: When a car's tire pressure is too low, the most noticeable effect is an increase in fuel consumption. This occurs because low tire pressure increases friction between the tires and the road surface, thereby increasing rolling resistance and leading to higher fuel consumption. Low tire pressure increases risk of blowouts: Additionally, the operational stress on the tires increases. The heightened friction causes the tires to heat up, making them softer and reducing their structural integrity. Maintaining high speeds for prolonged periods under these conditions may even result in tire blowouts, posing a serious safety hazard. Tire pressure values: Normal tire pressure typically ranges between 230-250 kPa (2.3-2.5 bar). Tires require precise inflation pressure to function optimally—both underinflation and overinflation are detrimental.
8
5
Share

How many kilometers should car gear oil be replaced?

Car gear oil is divided into the following types: 1. Transmission oil, one type of gear oil, can be categorized into automatic transmission oil and manual transmission oil. The replacement cycle for manual transmission oil can be slightly longer than that for automatic transmission oil, with both typically replaced every 60,000 to 80,000 kilometers. 2. Rear axle lubricant, another type of gear oil, is often overlooked by many car owners during routine inspections and maintenance. Daily cleaning only requires removing mud and dust from the vent plug on the rear axle housing. If necessary, it can be disassembled for cleaning to ensure the air passage remains unobstructed. Gear oil should be replaced every 20,000 kilometers. Additional information: Car gear oil usually refers to transmission oil and rear axle lubricant. These transmission mechanisms contain numerous gear components and operate under high surface pressure, necessitating gear oil for lubrication, cooling, heat dissipation, and corrosion prevention.
1
4
Share

How to Remove the Airbag on a New Bora?

New Bora airbag removal method: 1. Straighten the steering wheel and insert a small flat-head screwdriver into the left disassembly hole; 2. Align with the metal strip inside the left hole and push hard until the gap on the left side of the airbag widens; 3. Insert the small flat-head screwdriver into the right disassembly hole, align with the metal strip inside the right hole, and push hard until the gap on the right side of the airbag widens; 4. Insert the small flat-head screwdriver into the lower disassembly hole, align with the metal strip inside the lower hole, and push hard until the gap on the lower side of the airbag widens. At this point, the entire airbag assembly will come out. The Bora is a model under FAW-Volkswagen, with body dimensions of 4523mm in length, 1775mm in width, and 1467mm in height, and a wheelbase of 2610mm.
17
5
Share

How long after completing the subject one test can I get my license back if I lost 12 points for drunk driving?

For the re-examination of subject one after a 12-point suspension due to drunk driving, there is a time limit. The driver must report to the traffic management department of the public security authority at the place where the motor vehicle driver's license was issued or where the violation occurred within 15 days to participate in a seven-day study of road traffic safety laws, regulations, and related knowledge. The relevant details are as follows: 1. Participation in study: The motor vehicle driver must report to the traffic management department of the public security authority at the place where the motor vehicle driver's license was issued or where the violation occurred within 15 days to participate in a seven-day study of road traffic safety laws, regulations, and related knowledge. After completing the study, the vehicle management office must conduct a road traffic safety laws, regulations, and related knowledge test within 20 days. 2. Examination results: If the test is passed, the points will be cleared, and the motor vehicle driver's license will be returned. If the test is failed, the driver must continue to participate in study and retake the test. If the driver refuses to participate in the study or take the test, the traffic management department of the public security authority will announce the suspension of the motor vehicle driver's license.
4
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.