Does the Baojun 310W have seven seats?

Where is the Engine Exhaust Pipe Located?

The exhaust pipe of a car is located at the rear right side of the vehicle. Its low position serves to reduce vibration and noise, facilitate installation, and prolong the lifespan of the exhaust muffler system, thereby enhancing noise reduction effectiveness. Function of the Exhaust Pipe: The primary function of the exhaust pipe is to reduce engine noise and emissions of pollutants. Structure of the Automotive Exhaust System: The structure of a car's exhaust system is highly complex and not merely a simple pipe. The core components include the catalytic converter and the muffler. The catalytic converter transforms harmful gases such as CO, HC, and NOx emitted from the vehicle's exhaust into harmless carbon dioxide, water, and nitrogen through oxidation and reduction processes.

7

2

Share

Why does the car shake at idle but not while driving?

Car shaking at idle but not while driving is usually caused by excessive carbon deposits or spark plug issues. It can also be due to unstable oil pressure or aging engine components. When the car is running in a natural state without shifting gears or accelerating, steering wheel vibration is referred to as idle shaking. Below are the common causes of idle shaking: 1. Excessive carbon deposits inside the engine: During startup, carbon deposits absorb some fuel, leading to an overly lean air-fuel mixture. Once the carbon deposits become saturated with gasoline, the engine starts operating normally. However, when the mixture is ignited, the gasoline absorbed by the carbon deposits is sucked back into the cylinder by vacuum pressure, resulting in an overly rich mixture. This alternating lean and rich condition causes engine shaking. 2. Prolonged use of spark plugs can lead to increased spark plug gaps or excessive carbon buildup on the ignition points. These issues can cause poor sparking or insufficient ignition energy, resulting in cylinder misfires, reduced power, and engine shaking. 3. If the throttle body, air filter, spark plugs, and carbon deposits are all in good condition, the fuel supply system should be checked. Insufficient fuel pump pressure can also lead to reduced engine power and shaking.

16

3

Share

Is Minor Transmission Oil Seepage Serious?

Automobile oil seepage is a normal phenomenon. If it's minor seepage, it's not a big issue; but if it's oil leakage, then it's more serious and should be repaired immediately. Most oil seepage occurrences are caused by seal corrosion and aging, especially in vehicles that have been used for a long time. Below is relevant information about automobile oil seepage: 1. Automobiles are consumables. With prolonged use, the sealing components in various parts will harden and age, losing their original elasticity. Under the high-intensity working conditions of the transmission, seals will gradually shrink, harden, and may eventually break, leading to transmission oil seepage or leakage, which is unavoidable. 2. Minor transmission oil seepage is not a serious issue, but you should keep an eye on it and have it addressed during your next visit to the shop. If the transmission exhibits more severe oil leakage, it is necessary to promptly go to a 4S shop or a professional auto repair shop for maintenance or replacement. Otherwise, insufficient oil in the transmission can lead to inadequate lubrication, accelerated wear, rough gear shifting, weak acceleration, unusual noises, jerking, and other issues. In severe cases, it may cause the transmission to seize up and become damaged.

3

0

Share

Is making a U-turn at a red light considered running a red light?

If the U-turn signal is red, making a U-turn is considered running a red light. According to the "Road Traffic Safety Law," this violation incurs: 6 penalty points and a fine of 200 yuan. If there is no U-turn signal, and the gap is marked with a dashed line, the U-turn is not affected by the traffic signal and does not require crossing the pedestrian crossing. If the gap is marked with a solid line, the U-turn must cross the pedestrian crossing and is subject to the traffic signal. Making a U-turn directly may result in being photographed or penalized by on-site traffic police. When making a U-turn that requires crossing the pedestrian crossing, yielding to pedestrians is necessary: Pedestrians walking on the right side of the road's crosswalk, not reaching the centerline of the road. Vehicles on the left side of the road should slow down and proceed only after ensuring safety. Pedestrians waiting outside the boundary line of the motorized and non-motorized lanes. If they have not entered the roadway, vehicles should slow down and proceed only after ensuring safety. If pedestrians cross the boundary line between the motorized and non-motorized lanes, vehicles failing to stop and yield is a violation and should be penalized. When pedestrians enter the motorized lane via the crosswalk, vehicles must slow down and proceed only after ensuring safety. Failure to stop and yield is a violation and should be penalized. Pedestrians waiting at the centerline of the road without entering the vehicle lane. Vehicles failing to stop and yield is a violation and should be penalized. Pedestrians crossing the centerline of the road into the vehicle lane. Vehicles failing to stop and yield is a violation and should be penalized. Roads with a median strip separating pedestrians. When pedestrians are waiting in the median area, vehicles must slow down and proceed only after ensuring safety. Permissible U-turn scenarios: Intersections with U-turn signs allow U-turns: If there is a clear U-turn sign at the intersection, a U-turn is permitted. If there is a U-turn signal, follow the signal's instructions. If there is no signal, proceed with the U-turn without obstructing other vehicles or pedestrians. Intersections without explicit "No U-turn" or "No Left Turn" signs allow U-turns: If there is no explicit prohibition, a U-turn is allowed. "No explicit prohibition" means the absence of "No U-turn," "No Left Turn," or solid centerlines. Yellow grid lines also permit U-turns: Yellow grid lines indicate no-stopping zones at intersections prone to congestion, important entrances, etc. Stopping on these lines (including waiting for traffic lights) is a violation. However, U-turns are permitted in yellow grid zones unless there is a center divider. Intersections with U-turn signals: If a U-turn signal is present, follow it—green means U-turn is allowed. Simultaneous "No Left Turn" and "U-turn Allowed" signs: U-turns are permitted, but left turns are prohibited. Note that "No U-turn" is not the same as "No Left Turn." Precautions when making a U-turn at intersections: Observe road markings. If the line is solid, U-turns are prohibited under any circumstances. Continue driving to find a suitable U-turn location. If there is a "No Left Turn" sign, even without a "No U-turn" sign, U-turns are not allowed at that intersection, as U-turns inherently involve a left turn. U-turns must be made from the innermost left-turn lane. If in the second left-turn lane, U-turns are not permitted at that intersection. Always yield to straight-moving vehicles. Only proceed with a U-turn if it does not interfere with straight-moving traffic; otherwise, you bear full responsibility for any accidents. Near intersection stop lines, lanes often have guiding arrows. The leftmost lane is not always a left-turn lane. If it has a straight arrow, U-turns are prohibited even without explicit "No U-turn" signs.

10

1

Share

What is the function of the kingpin inclination angle?

The function of the kingpin inclination angle is: The kingpin inclination angle enables the vehicle's wheels to automatically return to the straight position after steering. The larger the inclination angle, the stronger the self-centering effect, but it makes steering the wheel more laborious and increases tire wear. It also facilitates easier steering. Below is relevant information: 1. The kingpin inclination angle refers to the acute angle formed by the projection of the vehicle's steering knuckle kingpin axis (or the connecting line between the upper and lower ball joint centers of an independent suspension) and the vertical line on a plane perpendicular to the vehicle's longitudinal symmetry plane. When viewing the tire from the front or rear of the vehicle, the kingpin axis tilts inward toward the vehicle body, and this angle is called the kingpin inclination angle. 2. When the wheel rotates around the kingpin, the lowest point of the wheel would theoretically sink below the road surface. However, in reality, the lower edge of the wheel cannot sink below the road surface. Instead, the steering wheel and the entire front part of the vehicle are lifted to a corresponding height. This creates an effect where the vehicle's own gravity helps the steering wheel return to its original straight position, making it easier to reset the steering wheel.

14

5

Share

How to restart the Audi MMI system?

Here are the methods to restart the Audi MMI system: 1. Simultaneously press the SET-UP button and the button in the upper right corner of the large knob, then press the large knob to restart the system. 2. Visit an authorized 4S dealership to seek professional assistance. Below is relevant information about the MMI system: 1. Audi has developed a new operational control concept: the Multi Media Interface (MMI). The MMI ingeniously integrates the operation of all infotainment components within a single display and operating system. By streamlining the controller and implementing a unified logic, the MMI enables quick, convenient, and intuitive access to a wide range of functions and technologies. 2. The Audi MMI is Audi's innovative operational control concept: the Multi Media Interface (MMI). The MMI seamlessly combines the operation of all infotainment components in one display and operating system. Through a simplified controller and consistent operational logic, the MMI allows for rapid, easy, and intuitive use of numerous functions and technologies. Today, Audi drivers can access a broad array of information and entertainment systems, such as radio, CD player, TV, navigation system, and car phone. This combination of information and entertainment (infotainment) will become increasingly important in the future. However, the expanding range of functions and options inevitably conflicts with traditional in-car operational control structures.

16

5

Share

Does the Baojun 310W have seven seats?

Where is the Engine Exhaust Pipe Located?

Why does the car shake at idle but not while driving?

Is Minor Transmission Oil Seepage Serious?

Is making a U-turn at a red light considered running a red light?

What is the function of the kingpin inclination angle?

How to restart the Audi MMI system?

Is a Manual-Automatic Transmission More Fuel-Consuming Than a Manual Transmission?

Should You Shift to P Gear or Pull the Handbrake First When Parking an Automatic Car?

What Principle Does the Reversing Radar Operate On?

Can You Turn Off the Engine in Neutral (N) Gear for Automatic Transmission?