···
Log in / Register

Does selecting one less correct answer in the multiple-choice questions of Subject 4 count as correct?

1 Answers
MichaelDella
07/29/25 11:57pm

It counts as wrong. The difficulty of the Subject 4 driving test lies in the multiple-choice questions, where neither selecting too many nor too few options is allowed. Therefore, it is essential to memorize the test questions thoroughly before the exam. Subject 4 is actually part of the Subject 3 test, specifically the safe and civilized driving knowledge exam. Hence, when booking Subject 4 online, it will appear as Subject 3. Below are some precautions for the Subject 3 safe and civilized driving knowledge exam: 1. Pay attention to the questions: When entering the exam room, carefully read each question. The questions may differ from those in the textbook, with possible variations in order and requirements. Be cautious when clicking the mouse—avoid double-clicking and only click once. 2. Questions: Once you move to the next question, you cannot change the answer to the previous one, even if it was wrong. If you are unsure about a question, you can skip it temporarily and return to it after completing the other questions. 3. Camera: During the exam, ensure that the small camera is aligned with your face, as several photos will be taken during the test. If a clear frontal photo is not captured, the exam will be considered invalid.

Was this review help?
7
5
Share
More Forum Discussions

What is the appropriate level to add coolant to a Nissan Sylphy?

The coolant in a Nissan Sylphy should be added to the middle position between the upper mark (MAX) and the lower mark (MIN) on the reservoir. The method for replacing coolant is as follows: Before completely replacing the coolant, conduct a thorough inspection to check for any signs of leakage or cracks in the pipes, with a focus on the five-way water pipe. The coolant flows through the five-way pipe and is then distributed to different parts of the car to function. If there is any leakage of coolant in this section, the water pipe should be replaced or the interface re-secured as needed. Drain the old coolant, then flush the liquid channels with clean water. Add clean water to the coolant reservoir, then continuously inject water into the reservoir so that it flows through the engine cooling system. Start the engine and let it idle for 3 to 5 minutes to circulate the water. The water initially flowing out of the reservoir will be slightly pinkish. Continue adding clean water until the water coming out is clear. Note: Remember to disconnect the heater hose and drain the water from the heater core. After draining for about an hour, add the new coolant through the radiator hose. Then, add another bottle of coolant to the coolant reservoir until it is nearly full. Start the engine and let it run for about 10 minutes. At this point, the coolant level will drop slightly as air is expelled from the cooling system. Add more coolant until it reaches the maximum mark "MAXT" on the reservoir.
18
2
Share

What is the horsepower of the Fista?

The Fista has a horsepower of 140 hp and 204 hp. The car is equipped with a 1.4T engine with a peak torque of 240 Nm and a 1.6T engine with a peak torque of 265 Nm, paired with a 7-speed dual-clutch transmission. In terms of suspension, the front suspension is a MacPherson independent suspension, and the rear suspension is a multi-link independent suspension. The dimensions of the Fista are 4600mm in length, 1790mm in width, and 1425mm in height, with a wheelbase of 2700mm. The car features a 10.25-inch central control color screen, Smartphone Interconnect 2.0 system, multiple driving mode selections, ESC body stability control system, and rear side airbag configurations.
19
2
Share

Where is the fuse box of Wuling Hongguang S located?

The fuse box of Wuling Hongguang S is located in the engine compartment and the cockpit. The fuse box in the cockpit is near the clutch pedal, and it can be seen by removing the interior panel above the clutch pedal. The fuse box refers to the box that installs fuses, making it convenient to install fuses, and some have performance characteristics such as waterproof, fireproof, and high-temperature resistance. The Wuling Hongguang S is powered by a 1.5L DVVT engine with a maximum torque of 146.5Nm, and is matched with a 5-speed manual transmission across the entire lineup. In terms of safety features, the vehicle is equipped with ABS EBD, force-limiting seat belts, LED high-mounted brake lights, rear window heating and defrosting function, rear wiper, child locks for the middle doors, and a remote key with an automatic car-finding function, among other rich safety devices.
4
4
Share

Which factory produces Golden Shield tires?

Golden Shield tires are produced by Weifang Golden Shield Tire Co., Ltd. Below is the relevant introduction of Weifang Golden Shield Tire Co., Ltd.: 1. Introduction: Weifang Golden Shield Tire Co., Ltd. is the earliest established and largest tire manufacturing enterprise in the Weifang area, with over 1,300 employees, including 210 professional technicians. It possesses advanced modern testing equipment and mainly produces all-steel radial tires, with an annual production capacity of 1.8 million sets of all-steel radial tires. 2. Production scope: Manufacture and sale of all-steel radial tires, engineering vehicle tires, agricultural vehicle tires, semi-steel radial tires, truck tires, light truck tires, rubber products, non-woven fabrics, and raw and auxiliary materials for tires and non-woven fabrics.
8
1
Share

What does 175/65r14 tire mean?

175 represents the tire cross-section width of 175MM; 70 represents the aspect ratio; 14 represents the rim size of 14 inches. More related introductions are as follows: 1. Tire specifications: Tire specifications are commonly represented by a set of numbers, with the first number indicating the tire section width and the latter indicating the rim diameter in inches. 2. Letters or symbols: Some tires also contain other letters or symbols with special meanings: "X" indicates high-pressure tires; "C" indicates reinforced tires; "B" indicates bias-ply tires; "-" indicates low-pressure tires. M and S are abbreviations for Mud and Snow in English, indicating that these tires are suitable for use on snowy and muddy roads. 3. There is also a special mark on the tire: wear replacement indicator. Different manufacturers have different markings. Michelin uses a small tire man, Pirelli displays a TWI mark, and some tires use conspicuous white to indicate it.
6
0
Share

What is the speed limit on the Beijing-Tibet Expressway?

On the Beijing-Tibet Expressway, the speed limit is 80 to 100 kilometers per hour in hilly or valley sections, and 120 kilometers per hour in plain areas. Below is an introduction to the Beijing-Tibet Expressway: 1. Overview: The Beijing-Tibet Expressway, also known as the Beijing-Lhasa Expressway, abbreviated as G6, has a planned length of 3,718 kilometers and an operational length of 1,830 kilometers. Construction began in 1996, and the entire route (except for the Golmud-Lhasa section) was completed on October 20, 2016. 2. Speed Limit: The speed limit on the Beijing-Tibet Expressway is 80 to 100 kilometers per hour in hilly or valley sections and 120 kilometers per hour in plain areas.
19
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.