Does Running Out of Windshield Washer Fluid Affect the Car?

What is the reason for the car not being able to shift gears the day after driving through water?

The reasons why a car cannot shift gears the day after driving through water are as follows: 1. Air filter: The air filter is the gateway for air to enter the engine. After the vehicle has driven through water, check the air filter and intake pipes. If they are wet, it indicates that water may have entered the engine, and a thorough inspection of the engine's internal water ingress is required. 2. Engine compartment wiring harness: There are numerous wiring harnesses and circuits in the engine compartment. Driving through water can easily wet the connectors of the wiring harnesses. If the connectors are found to be wet during inspection, they need to be dried immediately. If not treated promptly, it may lead to a short circuit. 3. Chassis malfunction: When driving through water, dirt can accumulate in the gaps of the chassis and other areas, leading to rust and even component failure. Therefore, after driving through water, the owner should take the vehicle to a car wash for a thorough cleaning of the chassis. Applying a chassis armor can also enhance the chassis's rust resistance.

5

4

Share

Is it easier to climb a slope with the air conditioning on during hill start?

Starting on a slope with the air conditioning on makes it harder to climb. Here is an introduction to hill start knowledge: 1. Test subject: Hill start is part of the field test in driving license exam (Subject 2), which involves starting a vehicle parked on a steep slope. When learning the technique of hill start for manual transmission vehicles, the steps are: first pull the handbrake, press the accelerator to at least 2000 RPM, then release the clutch until it drops to around 1000 RPM, release the handbrake, slightly release the clutch while adding a bit more gas, and the car will naturally climb the slope. 2. Precautions: The sequence of starting operations should be standardized and correct, with actions performed in order or simultaneously, without omission; during the start, maintain the correct driving posture, keep eyes on the road ahead, and avoid looking down.

11

4

Share

Is the Transmission Oil the Same as the Rear Axle Oil?

Transmission oil and rear axle oil are different. When replacing transmission oil, it is necessary to use dedicated transmission oil and not substitute it with other fluids. Transmission oil is crucial for the transmission system as it serves functions such as power transmission, heat dissipation, lubrication, and rust prevention. More details are as follows: 1. There are two types of car transmissions: automatic transmissions and manual transmissions. 2. There are three common types of automatic transmissions in cars: AT transmissions, dual-clutch transmissions, and CVT transmissions. 3. Dual-clutch transmission: This is a product developed based on manual transmissions. Its structure is similar to that of a manual transmission, with the addition of an extra clutch and a set of gear-shifting control mechanisms. One clutch controls the odd-numbered gears, while the other controls the even-numbered gears. Dual-clutch transmissions offer fast gear-shifting speeds and relatively high transmission efficiency. 4. CVT transmission: This is a relatively simple automatic transmission with only two cone wheels and a steel belt inside. The steel belt can move on the cone wheels, allowing the transmission to change speed and torque. CVT transmissions are compact, lightweight, and relatively low-cost.

10

0

Share

How to Fix Bubbles in Rear Windshield Tinting Film?

Solutions for bubbles in rear windshield tinting film include: 1. Scenario 1: If there are numerous large bubbles that are difficult to smooth out, it is recommended to replace the film entirely, as this not only affects aesthetics but also compromises driving safety. 2. Scenario 2: If the bubbles are few but large, you can make a small incision, then use a squeegee and heat gun to gradually smooth them out. 3. Scenario 3: If the bubbles are few and small, you can puncture them with a needle and then press them flat. 4. Scenario 4: If the issue arises suddenly with many large bubbles that affect driving safety, you can mimic the method used for phone screen protectors—gently lift the bubbled edge and reapply it following the proper procedure. However, this is only a temporary fix, and it is advised to replace the film as soon as possible afterward.

13

1

Share

What are the explanations for manual transmission gears?

Manual transmission, also known as MT, refers to a transmission system where the driver manually shifts gears by moving the gear lever to change the gear engagement inside the transmission, thereby altering the gear ratio for speed adjustment. Below are the explanations for manual transmission gears: 1. 1st gear: Used for normal starting or climbing very steep slopes. The speed typically ranges around 10 km/h when using this gear; 2. 2nd gear: Used as a transition gear for acceleration after starting, or for low-speed driving or climbing steep slopes. The speed usually ranges around 20 km/h; 3. 3rd gear: Generally used when the speed is between 20 km/h and 40 km/h, commonly used for city driving; 4. 4th gear: Can be used when the speed is between 40 km/h and 60 km/h; 5. 5th gear: Used when the speed exceeds 60 km/h, typically for high-speed driving; 6. N gear: N stands for neutral, used when the vehicle is idling, such as when waiting at a traffic light. Shift to N gear and engage the handbrake; 7. R gear: R stands for reverse, used for reversing after the vehicle has come to a complete stop.

12

1

Share

What to do if the rear seats of a Mercedes-Benz C-Class cannot be folded down?

The feature of folding down the rear seats was only available in the first batch of the new C-Class models. After the first facelift in April 2015, the rear seats have been fixed and cannot be folded down. Here is some relevant information: 1. Split-folding rear seats: Split-folding rear seats allow the backrests to be folded down in specific proportions, offering more flexibility compared to a single-piece folding mechanism. This allows for half of the backrest to be folded down to accommodate larger items while the remaining part can still be used for seating. Common split-folding ratios include 1/3, 2/3, and 1/2. 2. Single-piece folding rear seats: Single-piece folding rear seats have a one-piece backrest. When larger items need to be transported, the entire backrest can be folded down to create more space. The drawback of this design is that the rear seats cannot be used for seating when folded down.

18

1

Share

Does Running Out of Windshield Washer Fluid Affect the Car?

What is the reason for the car not being able to shift gears the day after driving through water?

Is it easier to climb a slope with the air conditioning on during hill start?

Is the Transmission Oil the Same as the Rear Axle Oil?

How to Fix Bubbles in Rear Windshield Tinting Film?

What are the explanations for manual transmission gears?

What to do if the rear seats of a Mercedes-Benz C-Class cannot be folded down?

Does the Magotan have seat ventilation?

Does Earth Dreams Engine Have Less Carbon Deposits with 95 or 92 Octane?

Who is Responsible for Water-Damaged Cars in Underground Garages?

What does a light bulb with a cross represent as a fault?