Does Having One New Tire and One Old Tire on the Front Wheels Have Any Impact?

1 Answers
LeCharles
07/29/25 9:54am
Having one new tire and one old tire on the front wheels is acceptable as long as they are of the same model and tread pattern. Below is an extended explanation: 1. Tire Replacement Rules: Front tires must be of the same model and tread pattern; otherwise, it may affect driving safety. It is best to replace tires in pairs—replace both front tires, and if only one rear tire is replaced, the new tire will wear out much faster. 2. Replacement Timing: Generally, manufacturers set the service life of tires at 3 years. If a vehicle is driven 20,000 kilometers a year, replacement should be considered after 2–3 years. If driven around 10,000 kilometers a year, replacement should be considered after 4–5 years. Even if only 5,000 kilometers are driven annually, replacement should still be considered after 4–5 years. Even brand-new tires should be considered for replacement after 3 years of storage. Therefore, spare tires in the car trunk also require regular maintenance, and unused spare tires that have been stored for too long should be replaced.
Was this review help?
15
5
Share
More Forum Discussions

What are the precursors to BMW N20 chain failure?

The most common symptom is loud and noticeable noise from the N20 engine. Here are the relevant details: 1. BMW N20: It is a 4-cylinder turbocharged engine produced from 2011 to 2017. It serves as the successor to BMW's naturally aspirated 3.0-liter 6-cylinder N52 engine and is the predecessor to the current B48 engine. 2. Loud and noticeable noise from the N20 engine: This noise is relatively easy to distinguish from the noise of the high-pressure fuel pump. During mild acceleration, the engine may produce a whining sound. Chain wear can be observed by opening the oil filler cap. This issue typically occurs around 70,000 kilometers.
15
4
Share

Can Getting a Driver's License Be Used as a Reason for Leave?

Getting a driver's license can be used as a reason for leave. You can say that it is for the convenience of work, so taking leave to get a driver's license makes it easier to request. It might not even be counted as leave, especially if driving is required for the current job. It depends on the position. Those who frequently travel for work are more likely to have their request approved, while those who rarely travel may not have this reason accepted, and it might be considered personal leave. Below is an introduction to the driver's license process: 1. Subject 1: Study and examination, usually takes about 2 weeks. 2. Subject 2: Study and examination, including pile training and pile test, field training and field test, ideally taking about 3 weeks. 3. Subject 3: Study and examination, road training and road test, ideally taking about 3 weeks. In total, it takes about 8 weeks, roughly 2 months.
2
4
Share

Do Audi Owners Enjoy Free Airport Parking?

Free parking programs are available at some airports but not all. Here are the specific details: 1. Airports offering free parking for Audi owners: Guangzhou Baiyun International Airport has established an "Audi VIP Owner Parking Zone" located in Area B, Lane 3, 1st Floor of P3 Parking Building at Baiyun Airport, just a 2-minute walk from the departure level. Beijing Capital International Airport T2. Location: F1 Level, Lane 08, T2 Parking Building, Beijing Capital International Airport. Beijing Capital International Airport T3. Location: Area B, Lane 07, T3 Parking Building, Beijing Capital International Airport. 2. Telephone reservation: Call the reservation hotline and provide the customer service representative with your name, vehicle model, license plate number, and estimated parking duration.
14
4
Share

What vehicles are compatible with 235/50R18 tires?

235/50R18 tires are generally compatible with SUV and MPV models. Below is a detailed introduction to automotive tire specifications: 1. Specification model representation: Tires are important components of vehicles, and there are many specification models of tires, with different specification models suitable for different vehicle types. The specification model identification is usually on the side of the tire, represented by a series of alphanumeric characters, corresponding to the tire's tread width, aspect ratio, type, wheel size, load index, and speed rating. 2. Speed rating: Based on the different maximum speeds they can withstand, tire speed ratings can be divided into different grades from A to Z, with grade A further subdivided into eight different grades from A1 to A8. The further back the letter representing the tire speed rating is, the better the tire performance is.
11
0
Share

What causes abnormal noise in BMW N13 engine?

The causes of hysterical noise in BMW N13 engine can be attributed to issues such as air filter, spark plugs, ignition wires, gasoline, fuel filter, carburetor, or fuel pump. Check if the air filter is dirty, if the spark plugs are worn out, if the ignition coil is damaged, or if the gasoline is contaminated. 1. When driving, acceleration may seem normal and ignition might appear fine, but when maintaining a constant speed, you may notice that the engine RPM is too high while the speed doesn't seem to increase. Try checking the coolant, oil pressure (whether too high or too low), inspect the oil pressure gauge, or there might be an issue with the ignition timing setting, which could also lead to such symptoms. 2. When accelerating, the engine produces a whirring sound, or it may also occur when decelerating. In short, the sound changes with RPM variations. If the power steering fluid is low, refill it. The generator bearing might be damaged. Problems with the power steering pump or water pump can also produce similar noises.
11
3
Share

What are the driving techniques and methods?

1. Door limit: Check the crane's movement. 2. Power start: Press the power connection button for movement. 3. Power stop: Press when parking and not operating. 4. Emergency stop: A rotatable and pressable button; pressing it in emergencies immediately cuts off power and stops the crane's movement. 5. Forced pre-limit: For example, when lifting high objects, pull up the button (if the object height exceeds the pre-limit). More related information is as follows: 1. Crane operation: Before operation, check the upper limit switch, whether the bumper is deformed, and whether the wire rope is deformed, broken, or misaligned. The most important thing is to 'catch the swing' by driving in the direction of the lifted object's swing to reduce the amplitude. 2. Note: When driving and lifting objects, avoid all obstacles. During movement, position the trolley in a safe location (where it won't hit obstacles). In case of any danger, immediately return to the neutral position (neutral gear, stop).
16
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.