Does exceeding the speed limit at the endpoint of a section speed measurement count as speeding if the average speed within the section does not exceed the limit?
3 Answers
Section speed measurement only calculates the average speed from the starting point to the endpoint, so exceeding the speed limit at the endpoint does not count as speeding. Below is a detailed introduction to section speed measurement: 1. Speed measurement rules: The speed is calculated by comparing the time difference between entering and exiting the section with the total distance of the section. The time difference between when the vehicle enters the highway and when it exits is compared with the distance of that section to determine whether the speed exceeds the limit. If it does, the fine is imposed according to regulations based on how much the speed was exceeded. 2. Penalties and points deduction for ordinary vehicles outside highways: If the speed exceeds the limit by less than 10%, no penalty is imposed. If the speed exceeds the limit by more than 10% but less than 20%, a fine is imposed, and 3 points are deducted. If the speed exceeds the limit by more than 20% but less than 30%, a fine is imposed, and 6 points are deducted. If the speed exceeds the limit by more than 30% but less than 50%, a fine is imposed, and 6 points are deducted.
I've been driving for over a decade and am very familiar with average speed check zones. Going slightly over the speed limit at the endpoint doesn't count as speeding because it measures your average speed across the entire zone, not your instantaneous speed at the endpoint. The system calculates whether you've maintained an average speed within the limit based on the time difference between your entry and exit points. For example, on a stretch from point A to B, I kept my average speed below 100 km/h, but accelerated to 105 km/h near the endpoint - my average still came out to 98 km/h, so no ticket. This proves the rule focuses on overall driving habits, not momentary sprints. However, I must warn you that speeding at the endpoint is actually quite dangerous, as it can easily lead to loss of control or rear-end collisions, especially on highways. It's best to maintain steady speeds while driving, avoiding fluctuations - this is both more fuel-efficient and safer. In summary, it doesn't count as speeding, but don't make a habit of random acceleration - safety first.
As a long-distance driver, I always pay attention to controlling my average speed when encountering interval speed monitoring. Exceeding the speed limit at the endpoint but staying within the average speed limit for the interval does not count as a violation, because the speed measurement is based on an average calculation principle. For example, last month on a mountainous highway, my average speed was 90 km/h for the entire stretch, and I reached 110 km/h at the endpoint, but the recorded average was only 92 km/h, so it didn't count as speeding. However, I must say that accelerating at the endpoint is unnecessary and only increases fuel consumption and tire wear. I recommend using cruise control to maintain a steady speed and develop good habits. Related point: Some sections may have other cameras that can capture momentary speeding, so don't be too careless. Drive steadily, and as long as your average speed is within the limit, you'll be fine.
