Does exceeding the speed at the endpoint of an interval speed measurement count as speeding if the average speed over the interval is not exceeded?

2 Answers
LukeAnn
07/29/25 11:52pm
Interval speed measurement only calculates the average speed from the starting point to the endpoint, so exceeding the speed limit at the endpoint does not count as speeding. Below is a detailed introduction to interval speed measurement: 1. Regulations: The management model of interval speed measurement on highways will be fully implemented. Speeding violations recorded by single-point speed measurement devices will be retained but not used as the basis for fines or penalty points, only as evidence for determining liability in traffic accidents. 2. Types: There are three main methods of speed measurement and evidence collection on highways: single-point speed measurement, interval speed measurement, and mobile speed measurement. Single-point speed measurement is mainly used for sections with varying speed limits, complex road conditions, and low safety standards. Due to these objective factors, drivers passing through single-point speed measurement sections tend to focus on avoiding speed traps, often braking abruptly upon seeing speed measurement warning signs. Moreover, speeding violations captured by single-point speed measurement can sometimes be coincidental.
Was this review help?
9
2
Share
WyattFitz
08/16/25 3:23am
I often encounter average speed checks on highways. Simply put, it measures your overall average speed. Cameras at the start and finish points record your time, and the system calculates whether your average speed exceeds the limit. Even if you speed up momentarily near the finish line, as long as your average speed stays within the limit, you generally won’t be ticketed. The system focuses on the overall speed, not individual moments. But don’t get too complacent—there might be other radar traps near the finish line targeting spot speed checks. If you’re caught speeding at any point, you could still get a ticket. My advice is to maintain a steady speed throughout, avoiding last-minute sprints. This makes driving safer, smoother in traffic, and reduces accident risks. Using a navigation app for alerts can help build good habits, save fuel, and prevent sudden braking. Ultimately, driving within the rules keeps you relaxed and minimizes risks on the road.
Was this review help?
8
0
Share
Expand All
More Forum Discussions

How to Turn on the High Beam on the Verano?

To turn on the high beam in the Verano, first rotate the knob on the lower left side of the steering wheel to the far right to activate the low beam. Then, push or pull the left control lever on the steering wheel to switch to the high beam. Generally, it is not recommended to use high beams in urban areas as the lighting conditions are usually adequate. High beams can easily dazzle oncoming drivers and pedestrians due to their elevated angle, impairing their vision and creating safety hazards. The Verano measures 4718mm in length, 1802mm in width, and 1466mm in height, with a wheelbase of 2700mm. The car's engine delivers a maximum horsepower of 125Ps, a maximum power of 92kW, and a maximum torque of 180Nm.
19
2
Share

What are the symptoms of a loose universal joint?

The symptoms of a loose universal joint are: 1. Abnormal noises and oil leakage in the car; 2. The car's steering wheel becomes uncontrollable; 3. The car's direction wobbles or deviates. A universal joint is a component in a car that changes the angle to transmit force, altering the position of the car's drive shaft axis direction. It serves as the joint part of the universal drive in the car's drive system, combined with the car's drive shaft to form the universal joint drive assembly. In front-engine, rear-wheel-drive vehicles, the universal joint drive assembly is typically installed between the transmission output shaft and the drive axle's main reducer input shaft. The universal joint plays a role between the front axle half-shaft, which is responsible for both driving and steering, and the wheels.
5
1
Share

How to replace the air conditioning filter in a Volvo XC60?

The steps to replace the air conditioning filter in a Volvo XC60 are: 1. Remove the clips located at the front of the passenger side in the engine compartment, then take out the sound insulation cotton; 2. Remove the filter. After taking out the sound insulation cotton, reach in to remove the baffle, then reach in again to take out the air conditioning filter. The cleaning method is to hold the air gun about 5cm away from the filter and blow at a pressure of 500kPa for approximately 2 minutes. The dimensions of the Volvo XC60 are 4688mm in length, 1902mm in width, and 1658mm in height, with a wheelbase of 2865mm. The car's engine has a maximum horsepower of 190Ps, a maximum power of 140kW, and a maximum torque of 300Nm.
7
4
Share

What does engine mean?

Engine is the core part of the motor, so it is commonly used to refer to the motor. The main component of the engine is the cylinder, which is also the power source of the entire car. Its function is to provide power for the car, enabling the car to move. According to the fuel type, it can be divided into diesel engines, gasoline engines, natural gas engines, and hybrid engines. The engine is a machine that can convert other forms of energy into mechanical energy, including internal combustion engines, external combustion engines, jet engines, and electric motors. The engine can be used for power generation devices, and it can also refer to the entire machine including the power device, such as gasoline engines and aviation engines.
1
5
Share

Is the Reverse Light the Rear Fog Light?

Reverse lights are not rear fog lights. The reverse light turns on automatically when the car is put into reverse gear, while the rear fog light has a separate control switch and needs to be manually activated. The reverse light is installed at the rear of the car to illuminate the road behind and alert vehicles and pedestrians that the car is reversing. All reverse lights are white. The rear fog light, on the other hand, is specifically designed for use in foggy or rainy conditions when visibility is significantly affected by the weather, making the car more visible to other vehicles. The fog light is only used in foggy conditions and is not needed for normal reversing. Most cars have only one reverse light and one rear fog light, typically arranged with the fog light on the left and the reverse light on the right.
11
4
Share

Does the Mercedes-Benz GLB have a four-wheel drive version?

Mercedes-Benz GLB does not have a four-wheel drive version; all Mercedes-Benz GLB models are front-wheel drive. This vehicle is a compact SUV under the Mercedes-Benz brand, equipped with a 1.3-liter turbocharged four-cylinder engine across the entire lineup. The engine is paired with a 7-speed dual-clutch transmission. The front suspension of the Mercedes-Benz GLB uses a MacPherson independent suspension, while the rear suspension employs a multi-link independent suspension. The dimensions of the Mercedes-Benz GLB are 4638mm in length, 1834mm in width, and 1687mm in height, with a wheelbase of 2829mm. The front track is 1590mm, and the rear track is 1585mm. The engine delivers a maximum horsepower of 136Ps, a maximum power of 100kW, and a maximum torque of 200Nm.
9
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.