Does ETC have to be installed in the microwave window?

[Tyrone]

ETC is generally installed in the microwave window, but it can also be installed elsewhere as long as it does not obstruct the driver's view and can detect the toll station's detection equipment. Correct ETC installation positions: For small vehicles such as cars and minivans, the ETC card and OBU device should be installed in the upper middle part of the front windshield. For large vehicles like trucks and buses, the installation position is in the lower middle part. ETC installation requirements: the height should be no less than 1.2 meters and no more than 2.5 meters; the installation angle N should be between 30º and 90º (the angle between the surface of the electronic tag and the horizontal plane). The ETC installation process is as follows: Upon receiving the device, first check if the ETC card and electronic tag (OBU) are damaged. Press the anti-tamper button on the back of the OBU, and the red light will briefly illuminate. The OLED screen will display "Tag Invalid" or "Please Insert Card," indicating the device is functioning normally. Clean the front windshield to ensure the surface is smooth, clean, and dry. Then peel off the protective film on the back of the OBU and stick it to the installation position. Press firmly for 2-3 minutes to remove any air bubbles. Insert the ETC card with the front side facing the driver and the back side facing the windshield, ensuring the chip is inserted into the OBU device.