Does Electric Power Steering Require Steering Fluid?

What Causes High RPM When the AC is On?

High RPM when the AC is on can be caused by the following reasons: 1. Engine control logic error, unable to receive the AC activation signal: When the system cannot determine whether the AC is on, the Engine Control Unit (ECU) mistakenly interprets it as a temporary high load and attempts to compensate for idle resistance by increasing RPM. When the engine RPM drops, it cannot handle the load from the AC compressor, causing it to increase RPM again. This back-and-forth results in unstable idle. 2. AC control circuit error, unable to send the AC activation signal: Similar to the first point, since the system cannot determine the AC's status, the ECU continuously adjusts the idle RPM, leading to unstable idle. 3. AC circuit malfunction, causing intermittent AC operation: When the AC is off, the AC compressor belt runs without load, so it does not affect the engine load. However, intermittent operation of the AC compressor forces the engine to continuously adjust idle RPM, resulting in unstable idle.

14

4

Share

What are the reasons why the Haval H2 cannot start?

Haval H2 one-button start not responding is generally due to the following reasons: Smart key battery is low; car battery voltage is insufficient, dead, or damaged; gear not returned to P/S position when parking; improper operation. Function of one-button start: The one-button start device is part of a smart car, a button device that simplifies the starting process and can also turn off the engine. This device can be retrofitted at the original car key lock position or as an independent panel. Starting method of one-button start: The starting method is software-based one-button start. There are three main points to note when installing a car one-button start system (the wiring plug under the ignition switch, the position of the button, and the handling of the steering lock), and it has multiple functions.

7

4

Share

Why does the brake make noise when not pressed but not when pressed?

The reasons why the brake makes noise when not pressed but not when pressed are as follows: 1. New pads installed on old rotors—old rotors usually have grooves, and the new pads may contact the upper and lower edges of the old rotor, causing noise. Solution: Chamfer the edges of the brake pads or resurface the rotor to resolve the issue. 2. New pads installed on new rotors—if the new rotor or new pad has excessive unevenness, poor bedding-in between the rotor and pad, or uneven wear on one side, it may cause noise. Solution: After using the brakes for some time, the rotor and pad will bed in properly. If the unevenness is severe, reinstallation may be required. 3. Poor retraction of the brake caliper, causing drag and premature volatilization of the organic material in the brake pads, leading to noise after some use. Solution: Inspect and maintain the caliper, check if the brake pads are intact, and replace them if they are burnt.

17

4

Share

Will you fail if you cross the line in Subject 3?

Subject 3 will fail if you cross the line. The test content for driving license Subject 3 includes: Content 1: preparation for getting on the car, walking around the car counterclockwise for a week, fastening the seat belt after getting on the car, turning on the left turn signal, shifting into gear, releasing the brake, and honking the horn; Content 2: starting, driving in a straight line, shifting gears, changing lanes, parking by the roadside, going straight through intersections, turning left at intersections, turning right at intersections, passing through pedestrian crossings, passing through school zones, passing through bus stops, meeting oncoming vehicles, overtaking, making U-turns, and driving at night; Content 3: the test distance for small cars should be no less than 3 kilometers, and no less than 20% of the candidates should take the night test. If the night test is not conducted, the use of night lights should be simulated.

8

1

Share

What type of engine oil does the Chery E5 use?

The Chery E5 uses 10W40 engine oil, which is a mineral oil, with approximately 3.7 liters required for each oil change. Engine oil, also known as engine lubricant, serves multiple functions including lubrication and wear reduction, auxiliary cooling, sealing to prevent leaks, rust and corrosion protection, as well as shock absorption. The Chery E5 is a compact sedan produced by Chery Automobile, and as of August 2019, it has been completely discontinued. In terms of body dimensions, the 2014 Chery E5 measures 4580mm in length, 1760mm in width, and 1483mm in height. Regarding powertrain options, the 2014 Chery E5 was available with either a 1.5L naturally aspirated engine or a 1.8L naturally aspirated engine. The 1.5L variant delivers a maximum horsepower of 109 HP, a maximum power output of 80 kW, and a peak torque of 140 Nm.

12

4

Share

How to Align the Timing Chain Marks on a Kia Forte?

The steps to align the timing chain marks on a Kia Forte are: 1. Align the timing mark of the crankshaft sprocket with the upper surface of the cylinder head, then install the chain tensioner arm; 2. Rotate the crankshaft to align the car's transmission and flywheel; 3. Rotate the camshaft to align the mark on the camshaft timing gear with the bottom of the valve chamber; 4. Align the rectangular protrusion on the drive end of the engine oil pump shaft with the direction of the crankshaft; 5. Insert the distributor assembly into the mounting hole and align the distributor rotor with the mark on the housing; 6. Cover the distributor cap, then connect the spark plug wires and various internal components; 7. Install the timing chain. The Forte is a compact sedan produced by Dongfeng Yueda Kia, equipped with a 1.6-liter naturally aspirated engine delivering a maximum horsepower of 123 hp, paired with either a 6-speed manual or a 6-speed automatic transmission.

19

1

Share

Does Electric Power Steering Require Steering Fluid?

What Causes High RPM When the AC is On?

What are the reasons why the Haval H2 cannot start?

Why does the brake make noise when not pressed but not when pressed?

Will you fail if you cross the line in Subject 3?

What type of engine oil does the Chery E5 use?

How to Align the Timing Chain Marks on a Kia Forte?

Can the car still be driven with a VSS malfunction?

What is the actual fuel consumption of the Bestune T55?

Why is the Peugeot 207 not as good as the 206?

Which model is the Volkswagen Lavida svw71521df?