Does an EFI Engine Need Carbon Deposit Cleaning?

1 Answers
LukeFitz
07/30/25 4:21am
An EFI engine does require carbon deposit cleaning. Carbon buildup in the engine can cause engine shaking and abnormal noises, and in severe cases, it may lead to engine failure to start or even complete engine breakdown. Regular cleaning of engine carbon deposits is necessary, as neglecting this can affect the vehicle's power performance. The working principle of an EFI engine is as follows: 1. Single-point and multi-point injection principles: The single-point injection system (SPI), also known as central fuel injection (CFI), consists of three parts similar to the multi-point injection system: the fuel supply section, the air supply section, and the control section. 2. The fuel supply section includes components such as the fuel tank, electric fuel pump, fuel filter, pressure regulator, and central injector. The electric fuel pump is typically installed inside the fuel tank. The system pumps fuel at a low pressure of 0.1MPa, filters impurities through the fuel filter, and delivers it to the central injector for spraying. 3. The air supply section comprises the air filter, throttle valve, intake manifold, and cylinders. When air is drawn into the throttle valve, it begins to mix with atomized fuel to form a combustible mixture, which is then distributed to each cylinder via the intake manifold. 4. The control section consists of the electronic control unit (ECU) and various sensors. Key sensors include the throttle position sensor, oxygen sensor, and crankshaft position sensor. These sensors send signals back to the ECU, which then issues operational commands to components such as the central injector.
Was this review help?
3
2
Share
More Forum Discussions

Can a Bulging Tire Run 100 Kilometers?

A bulging tire cannot run 100 kilometers. The impacts and causes of tire bulging are as follows: Impacts of Tire Bulging: A bulging tire not only affects driving but also poses a serious risk of sudden blowout at any time, which is a major accident hazard for vehicle operation. Once a tire bulge is detected, it must be immediately inspected and replaced at a professional tire shop. Causes of Tire Bulging: Excessive tire pressure makes the tire too hard and reduces elasticity, increasing the risk of blowout upon external impact. Insufficient tire pressure increases the contact area between the tire and the ground, making it prone to breakage of the tire cords when hitting hard objects. Therefore, tire bulging is not due to poor tire quality but is caused by uneven road surfaces and unstable tire pressure.
5
4
Share

Does Audi Offer Free Roadside Assistance?

Audi's rescue service vehicles provide a 24-hour integrated rescue solution. With powerful professional equipment and a dedicated team, they offer various forms of assistance including towing, oil delivery, fuel delivery, and on-site emergency repairs, ensuring you receive swift and professional service when you need it most. Free Jump-Start Service: Free jump-starts are quite common. For instance, if a driver forgets to turn off the headlights overnight, the car battery may drain, leaving the vehicle unable to start the next day. In such cases, drivers can seek help from a 4S shop or repair shop, but they usually charge a fee. However, if the driver contacts their car insurance company, they typically offer free jump-start services, though there may be usage limits, so drivers should still try to conserve battery power. Free Fuel Delivery Service: Many absent-minded drivers often forget to check their fuel levels while driving. Running on low fuel can cause the car to stall unexpectedly, especially if there are no nearby gas stations, leading to frustration. In such situations, drivers don't need to panic. Simply calling their car insurance company will usually result in a fuel delivery within an hour, with the driver only needing to pay for the fuel itself.
18
2
Share

What does 'Slow down, drive carefully, check tires' mean?

It means you should check the tire pressure. When aware of tire issues, the system automatically monitors tire pressure in real-time during driving and alerts for leaks or low pressure. The functions of the ABS system and tire pressure monitoring alarm are as follows: ABS System Introduction: This system compares the rotational speed differences between tires using the wheel speed sensors of the car's ABS system to monitor tire pressure. ABS determines whether a wheel is locking up through wheel speed sensors to decide if the anti-lock braking system should activate. When tire pressure decreases, the vehicle's weight causes the tire diameter to shrink, leading to changes in speed. These changes can trigger the alarm system to warn the driver. Function of Tire Pressure Monitoring Alarm: Prevents tire blowouts by monitoring tire pressure and temperature in real-time, addressing issues before they occur. Saves fuel by maintaining correct tire pressure, reducing vehicle fuel consumption. Reduces wear—insufficient pressure causes excessive wear (tire scrubbing), shortening tire lifespan.
16
2
Share

How often should vehicles over 15 years old undergo inspection?

Vehicles over 15 years old require two inspections per year. Annual inspections can promptly identify any issues with the vehicle, allowing owners to stay informed about their vehicle's condition and carry out necessary repairs. After the revision of the motor vehicle scrappage policy, the usage lifespan restriction for private vehicles was removed, replaced by a guideline to scrap private vehicles after reaching 600,000 kilometers. However, if a private vehicle fails to obtain the relevant motor vehicle inspection certificate for three consecutive inspection cycles, it will also be subject to mandatory scrapping. Emissions Test: During the annual inspection, the vehicle's emissions will be tested for compliance, specifically focusing on the oxygen sensor and catalytic converter. Their optimal operating temperature ranges between 400 to 800 degrees Celsius, so it is recommended that owners warm up their vehicles in the external inspection area before the emissions test to increase the pass rate. Lighting Check: The vehicle management office will inspect the vehicle's lighting. If the vehicle's lights are found to be either too dim or too bright, it will be deemed unqualified and will not pass the annual inspection. It is advisable to restore the original headlights' condition before the inspection to ensure compliance.
7
0
Share

What is the speed limit on national highways?

National highways have a speed limit of 80 km/h, and you should drive according to the speed limit signs on the road. According to Article 78 of the Implementation Regulations of the Road Traffic Safety Law, expressways shall indicate the driving speed of each lane, with the maximum speed not exceeding 120 km/h and the minimum speed not lower than 60 km/h. For expressways with two lanes in the same direction, the minimum speed of the left lane is 100 km/h; for expressways with three or more lanes in the same direction, the minimum speed of the leftmost lane is 110 km/h, and the minimum speed of the middle lane is 90 km/h. On expressways, the maximum speed for small passenger vehicles shall not exceed 120 km/h, for other motor vehicles shall not exceed 100 km/h, and for motorcycles shall not exceed 80 km/h.
19
0
Share

Does Leaving a New Car Outside in the Rain Have Any Impact?

Leaving a new car outside in the rain can have several negative effects. The acidic substances in rainwater can damage the car's paint; the electrical circuits and ignition system are prone to moisture, leading to poor ignition and reduced engine performance; and the chassis can become soaked. Paint corrosion: Pollution is widespread in many areas, and rainwater is often acidic. Therefore, exposure to rain is equivalent to exposing the paint to acid rain, which can corrode the paint, causing water spots, oxidation, and even cracking. Dampness and mold: After rain, the interior of the car can easily become damp and moldy. Additionally, water can seep into the seams of the car body, causing metal parts to rust and corrode. Therefore, it's essential to remove accumulated moisture as soon as the rain stops to prevent mold and other issues. Headlights prone to water ingress: Driving in the rain can cause water to enter the headlights, not only reducing brightness but also altering the direction of the light, posing a safety hazard. After a new car is exposed to rain, it should be washed immediately to avoid unnecessary problems and extend the vehicle's lifespan. Post-rain car maintenance methods: Timely car washing: Urban rainwater is typically acidic and may carry sticky substances that adhere to the car once the water evaporates, making them difficult to remove. It's advisable to take the car to a 4S shop or a professional car detailing service as soon as possible to clean it thoroughly, paying special attention to areas like the gaps under the doors and the wheel wells where mud and debris can accumulate. The car's undercarriage should also be cleaned. Paint care: Rainwater often contains acidic substances that can corrode the car's clear coat, and it may also carry invisible dust particles that, when exposed to sunlight, can lead to oxidation. Therefore, it's best to perform a paint treatment after rain, with waxing being a simple and effective method. Brake system maintenance: Most cars use a dual-circuit vacuum-assisted hydraulic braking system, and the brake fluid, which transmits braking force, is highly absorbent. If water enters the brake fluid, it can cause brake failure. During maintenance, it's crucial to check the brake fluid and any water traces on the brake discs to ensure the safety of the driver and passengers.
3
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.