Do You Need to Use Turn Signals for Reverse Parking in Subject 2?

[CamilaAnn]

Using turn signals is not required for reverse parking in Subject 2. Here are the relevant details: Instances where turn signals are needed in Subject 2: 1. Immediately after parallel parking, turn on the left turn signal, then drive out onto the road and turn it off. 2. Right after stopping on the slope, turn on the left turn signal, drive over the crest, and when the steering wheel is turned back 90 degrees, the turn signal will automatically turn off. Key steps for reverse parking: 1. Reversing into the parking space from the starting point: After adjusting the seat and mirrors and fastening the seatbelt, shift into reverse, release the parking brake, and let the car move backward at idle speed. Observe the parking space through the right rear window. When the black edge of the right rear window aligns with the right boundary line of the parking space, turn the steering wheel fully to the right. 2. Driving from the parking space to the turnaround point: Shift into first gear and drive out of the parking space. When the hood approaches the road boundary line, turn the steering wheel fully to the left and stop once the car is straight. 3. Reversing into the parking space from the turnaround point: Shift into reverse, keep the steering wheel turned fully to the left, and reverse. Observe the left rearview mirror and adjust the steering to guide the rear of the car into the space. Once inside, check the right rearview mirror. When the entire right boundary line of the parking space is visible, straighten the steering wheel. Then, look at the left rearview mirror and stop when the left door handle aligns horizontally with the base line of the parking space. 4. Driving from the parking space back to the starting point: Shift into first gear and drive out of the parking space. When the hood approaches the road boundary line, turn the steering wheel fully to the right and stop once the car is straight.

[DeCassidy]

In my actual experience taking the Subject 2 driving test, there are indeed specific rules about using turn signals during reverse parking. For example, you must turn on the left signal in advance when starting to exit the parking space, so the system knows you're preparing to move left. When the front of the car is about to touch the boundary line, turn the steering wheel to the right while simultaneously turning off the turn signal. Forgetting to signal or signaling the wrong direction will deduct 10 points immediately. Worse, if you fail to use the turn signal throughout the entire exiting process, you'll lose all 100 points. My instructor repeatedly emphasized that signaling isn't just for the test—it also alerts vehicles behind you to your movements in real driving, helping avoid collisions. It's crucial to remember that after signaling, you mustn't turn the steering wheel more than three full rotations, or the system will judge it as an incorrect operation. Finally, the car body must be straightened when exiting the parking space—mastering these details is essential to pass.

[OCharles]

I remember the most common mistake I made when practicing reverse parking was forgetting to turn on the indicator. The instructor banged on the window and yelled, 'Pulling out without signaling is like driving with your eyes closed!' The requirements for the Subject 2 test are very clear: when starting from the parking space and exiting to the left, you must turn on the left indicator; when exiting to the right, turn on the right indicator. This action must be completed before the wheels start moving, and just turning on the indicator isn't enough—it must remain on for at least 3 seconds. During one mock test, I turned off the indicator immediately after turning it on and was directly marked as failing. Looking back now, it feels quite unfair since my rearview mirror and front bumper positioning were fine, but I failed because of the indicator. So, I recommend practicing this specific action rhythm during training. You can silently recite the mantra 'signal—three seconds—move wheels' to develop the habit.

[LaNicole]

The key to using turn signals during reverse parking lies in the exiting phase. According to driving test standards, you must activate the left turn signal when exiting to the left, and the right signal when exiting to the right. This step is often overlooked but directly affects scoring. I've seen many test-takers fail simply because they forgot to signal - it's not a technical issue but carelessness. Develop a reflex during practice: synchronize steering wheel movement with turn signals. For example, immediately activate the left signal when turning the wheel left. Pay special attention when straightening the wheel - turn off the signal in advance to avoid system misjudgment. Test vehicles are highly sensitive; signals lasting less than 3 seconds will incur penalties, so it's better to keep them on slightly longer. Most importantly, ensure all lights function properly throughout - faulty lights lead to immediate disqualification.