Do you need a driver's license to drive a new energy vehicle?

Is stopping within 50 cm considered early or late?

There is no concept of stopping too early or too late; stopping within 50 cm on the slope is within the required range. Below is relevant information about the Subject 2 driving test: 1. Hill start and designated parking: During hill start and designated parking, when the vehicle stops on the slope, the handbrake is engaged to prevent rolling back. The process of accelerating and passing the slope from this stationary position constitutes the hill start test. 2. Reverse parking: Reverse parking is one of the most practiced and commonly considered challenging tasks in Subject 2. The most crucial aspect during this test is not stopping midway - if the vehicle stops, the test is considered failed.

12

3

Share

How to Identify the National Emission Standard on the Vehicle License?

To identify the national emission standard on the vehicle license, check the vehicle model number: if it starts with 'bh', the suffix 'w' or 'x' indicates China III emission standard, 'y' indicates China IV, 'v' indicates China V, and 'vi' indicates China VI. Other methods to check the vehicle's emission standard include: 1. Review the motor vehicle conformity certificate; 2. Check the vehicle's accompanying documents for the emission standard in the vehicle information section; 3. Check the conformity certificate; 4. Visit the official motor vehicle environmental protection website for inquiries; 5. Inspect the vehicle's environmental protection label. The 'National' emission standards refer to China's phased vehicle emission standards, from China I to China VI, marked by the symbols i, ii, iii, iv, v, and vi respectively.

14

4

Share

Is the transmission of the new Passat 330 Elite dry or wet?

The transmission of the new Passat 330 Elite is wet. The Volkswagen new Passat uses a dual-clutch transmission, with the 1.4T model equipped with a dry transmission and the 1.8T/2.0T models with a wet transmission. The wet type is relatively more stable. The latest National VI 2.0T engine (330TSI or 380TSI) is paired with the DQ381 wet dual-clutch transmission, while the 1.4T (280TSI) is paired with the DQ200 dry dual-clutch transmission. Advantages and disadvantages of wet and dry dual-clutch transmissions: 1. Wet dual-clutch transmission refers to a dual-clutch system consisting of two sets of multi-plate clutches, one large and one small, coaxially installed together in a sealed oil chamber filled with hydraulic fluid. Therefore, the wet clutch structure offers better adjustment capability and excellent thermal performance, enabling it to transmit larger torque. This technology is stable and mature, not only achieving fast and smooth gear shifts but also preventing overheating at low speeds due to the cooling effect of the oil. However, the downside is that the wet dual-clutch structure is complex, relatively larger and heavier, with higher manufacturing costs compared to dry dual-clutch transmissions. Additionally, maintenance is more time-consuming and labor-intensive, requiring regular coolant replacement. 2. Dry dual-clutch transmission transmits torque through friction plates on the driven disc of the clutch. By eliminating the related hydraulic systems and leveraging the high efficiency of dry clutches in torque transmission, dry systems consume less energy during gear shifts compared to wet systems, significantly improving fuel economy. Moreover, dry dual-clutch transmissions are lighter than wet ones. The disadvantage is that dry dual-clutch transmissions have relatively inferior heat dissipation and lower torque capacity. However, due to lower manufacturing costs and subsequent maintenance expenses, they are generally used in budget-friendly models.

4

5

Share

What is the normal RPM when starting a car?

The normal RPM when starting a car is between 1000 and 1400 RPM. Different car models may have varying cold-start RPM values due to differences in engine specifications. Car RPM refers to the rotational speed of the car engine, and its functions include: 1. Reflecting the engine's operating condition in real-time; 2. Helping drivers better coordinate with transmission gears and throttle positions; 3. Maintaining the car in optimal working condition; 4. Reducing consumption and extending engine lifespan. The reasons for high RPM when starting a car include: 1. Sudden increase in throttle opening; 2. Fuel injector dripping or clogging; 3. Slippage or damage to the air conditioning clutch; 4. Air intake system leakage; 5. Insufficient engine output power. Solutions for high RPM when starting a car include: 1. Adjusting the throttle opening; 2. Replacing the fuel injector, air conditioning clutch, air intake system, or engine.

18

1

Share

Can the Land Cruiser use 92 octane gasoline?

The Land Cruiser can use 92 octane gasoline. The precautions for refueling are: 1. Choose to refuel when the temperature is relatively low; 2. If the car is not used for a long time or used infrequently, keep a small amount of fuel; 3. Do not refuel when the tanker is unloading; 4. Turn off the engine when refueling a gasoline vehicle; 5. Do not mix gasoline of different octane ratings. Taking the 2016 Land Cruiser as an example, it is a mid-to-large-sized SUV with body dimensions of: length 5170mm, width 1975mm, height 1930mm, and a wheelbase of 2850mm. The 2016 Land Cruiser is equipped with a 4.0L naturally aspirated engine, with a maximum horsepower of 275PS, a maximum power of 202kW, a maximum torque of 385Nm, and is paired with a continuously variable transmission.

8

5

Share

Which is more comfortable, SUV or sedan?

In terms of comfort alone, sedans are better. Sedans benefit from a lower seating position, which provides better support for the legs and neck, and the elbows naturally hang down when operating the steering wheel, creating a relatively more comfortable and effortless posture. On the other hand, SUVs generally have a higher seating position, where the driver's thighs and neck are at a 90-degree angle, which can put more pressure on the hips and cervical spine during long drives, making the driver more prone to backaches and fatigue. Here are more comparisons between SUVs and sedans: 1. Fuel consumption: Due to lower aerodynamic drag coefficients, sedans generally have lower fuel consumption compared to SUVs with the same displacement. Theoretically, the lower the resistance, the lower the fuel consumption. 2. Handling: Sedans have a lower center of gravity, providing better handling, while SUVs naturally have a higher center of gravity, making them more prone to body roll during turns and less stable during lateral movements, resulting in slightly inferior handling. 3. Space: Due to their taller and generally larger body design, SUVs offer more generous longitudinal and lateral space, and they also have an advantage in cargo space compared to sedans. 4. Visibility: With their higher seating position, SUVs provide a better view of the road ahead, allowing drivers to see farther. In case of sudden incidents ahead, SUV drivers can observe them more easily and take measures in advance. 5. Safety: SUVs are safer than sedans. Due to their higher front-end design, in scenarios like rear-end collisions or head-on collisions, the bumper of a sedan may not function effectively, and its vulnerable parts and core components may directly face the SUV's crash beams. Therefore, sedans tend to fare worse in both high-speed and low-speed collisions. However, sedans have the advantage of a lower center of gravity, which provides better stability at high speeds. Overall, in terms of safety, SUVs have an advantage over sedans.

3

0

Share

Do you need a driver's license to drive a new energy vehicle?

Is stopping within 50 cm considered early or late?

How to Identify the National Emission Standard on the Vehicle License?

Is the transmission of the new Passat 330 Elite dry or wet?

What is the normal RPM when starting a car?

Can the Land Cruiser use 92 octane gasoline?

Which is more comfortable, SUV or sedan?

How to reset the maintenance light on Jiangling Transit?

How to Remove Rear Window Tint Film?

Is the engine of the Jetour X70 made of cast iron or aluminum alloy?

What does VSS fault mean?