Do I need to press the brake when going straight at an intersection in Subject 3?

What is the normal tire pressure for the Buick Verano?

The normal tire pressure for the Buick Verano is around 2.5, with a fluctuation of 0.2. Due to the effect of thermal expansion and contraction, the tire pressure can be slightly higher in winter and slightly lower in summer. When the vehicle is equipped with a Tire Pressure Monitoring System (TPMS), the system can alert the driver in case of low tire pressure. The Buick Verano is a new compact model under the Buick brand. The dimensions of this car are 4718mm in length, 1802mm in width, and 1466mm in height (1471mm for the 1.5T model), with a wheelbase of 2700mm. The Buick Verano offers two engine options: a 1.5L and a 1.5T, with maximum power outputs of 118 horsepower and 169 horsepower, respectively.

8

5

Share

How to Set One-Touch Window Lift?

Setting one-touch window lift method: Pull the window button directly to raise the window to the top. Then, keep holding it for 3 to 5 seconds before releasing. Next, press the window button to lower the window completely. Again, hold for 3 to 5 seconds before releasing. After that, test the one-touch lift function, and the setup is now complete. Whether controlled by a smart key or mechanical button, the one-touch window lift generally comes with an anti-pinch feature. During the automatic closing operation, if an object is detected between the glass and the window frame, the closing action will automatically stop midway and revert to the initial state to prevent potential pinching hazards.

14

0

Share

How to Set Up Remote Window Control?

Method to set up remote window control: Turn on the ignition switch, use the switch to open the power window halfway, then fully push the switch until the power window is completely closed, and keep holding the switch for 3 to 5 seconds after the window is fully closed. If you forget to close the windows after getting out of the car and the distance is too far to walk back, simply take out the key and lightly press the lock button on the remote key, and all four windows and the sunroof will automatically close. The power window settings should be reconfigured under any of the following circumstances: 1. Replacement or disassembly of the multiplex network master switch, multiplex network switch, multiplex network door ECU harness, or power window regulator motor; 2. Replacement of fuses or relays related to power window control. Unless the power window regulator motor is reset, the AUTO operation function, anti-pinch function, and remote control operation function of the multiplex network master switch will not work.

10

0

Share

How to Replace the Remote Battery for Volvo S90?

Steps to replace the remote battery for Volvo S90: 1. Remove the mechanical key. Open the panel to see the mechanical key, which is fixed between two panels via a slot. Press the small black button on the top of the key sideways and push the logo side forward to open it; 2. Press the protruding button on the back panel sideways and pull the back panel upward by 5mm. At this point, the back panel will detach from the main body and can be removed; 3. Rotate the battery cover to the 'ope' position, then remove the battery cover from the gap and take out the O-ring seal; 4. Now you can see the coin battery, which is model CR2032. Simply remove the old battery and replace it with a new one. The Volvo S90 is a luxury sedan under the Volvo brand. The dimensions of this car are 5090mm in length, 1879mm in width, 1450mm in height, with a wheelbase of 3061mm.

14

0

Share

What to Do When the Steering Wheel Pulls to the Left When Braking?

The solution to the steering wheel pulling to the left when braking is to perform a four-wheel alignment. Four-wheel alignment is based on the four-wheel parameters of the vehicle, adjusting them to ensure good driving performance and a certain level of reliability. Front wheel alignment includes four aspects: caster angle, kingpin inclination angle, camber angle, and toe-in. Rear wheel alignment includes camber angle and toe-in for each rear wheel. Reasons for the steering wheel pulling to the left: severe uneven tire wear, especially when the diameter difference between the inner and outer rear tires is significant, leading to more severe irregular braking deviation; uneven tread depth on both sides of the tires, which can cause the car to tilt to one side—it's best to use tires of the same model.

14

5

Share

Where is the engine number located on the Santana?

The engine number of the Santana is located in the engine compartment, between the battery and the brake master cylinder. On the front of the engine, there is a small black block with three sets of numbers and letters. The 17-digit one is the vehicle identification number (VIN), and the 11-digit one is the engine number. The number of digits in the engine number varies by brand, with common engine numbers typically being between 7 and 8 digits. The Santana is a brand car produced by Volkswagen in California, USA. The new generation of this model has dimensions of 4475 mm in length, 1706 mm in width, and 1469 mm in height, with a wheelbase of 2603 mm. The new Santana is equipped with a 1.5-liter naturally aspirated engine, coded EA211DIf, which delivers a maximum power of 82 kW and a maximum torque of 145 Nm.

14

4

Share

Do I need to press the brake when going straight at an intersection in Subject 3?

What is the normal tire pressure for the Buick Verano?

How to Set One-Touch Window Lift?

How to Set Up Remote Window Control?

How to Replace the Remote Battery for Volvo S90?

What to Do When the Steering Wheel Pulls to the Left When Braking?

Where is the engine number located on the Santana?

Why is the fan noise loud in the Venucia D60?

What is the emission standard for China VI vehicles?

Why Do Hatchbacks Have Rear Wipers?

Is it necessary to install underbody armor for a new car?