Do I need to manually turn off the turn signal during parallel parking?

1 Answers
VonAlivia
07/30/25 8:33am
Parallel parking turn signals do not need to be manually turned off. Below are relevant introductions about parallel parking: 1. Traditional parallel parking: Four poles were erected on the ground to symbolize the four corners of the parking space. Whether the vehicle successfully entered the parking space and whether it touched these four poles was one of the criteria. 2. After the implementation of new traffic regulations: Parallel parking no longer uses poles, and all parking space boundaries are marked with ground lines. For students learning to drive with a C1 license, the length of the parallel parking space is 1.5 times the length of the vehicle plus 1 meter. Drive the vehicle to the front of the parking space parallel to the direction of travel, then reverse into the parking space to the right rear without any pauses in between. As long as the vehicle is parked within this range without crossing the boundary lines of the parking space, it is considered a pass.
Was this review help?
9
0
Share
More Forum Discussions

Where is the cabin air filter located in the Land Rover Range Rover Evoque?

The cabin air filter in the Land Rover Range Rover Evoque is located inside the glove compartment on the front passenger side. You can access it by removing the glove compartment. To do this, you need to detach the white bracket, which has a cover plate on its side. Simply unfasten the three clips to remove it. The arrow on the filter indicates the direction towards the interior of the vehicle. The recommended maintenance interval for the cabin air filter is every 10,000 kilometers or approximately one year. If you frequently drive in areas with severe smog, it is advisable to replace the filter more frequently as needed. The Land Rover Range Rover Evoque has body dimensions of 4371mm in length, 1904mm in width, and 1649mm in height, with a wheelbase of 2681mm.
7
1
Share

What Type of Fire Extinguisher is Suitable for Sedans?

Sedans are best equipped with dry powder fire extinguishers and water-based fire extinguishers. Among them, dry powder fire extinguishers are fast and effective in extinguishing fires, with a wide range of applications. Water-based fire extinguishers are further divided into water-based clean water extinguishers, water-based foam extinguishers, and water-based mist extinguishers, featuring dust-free operation, anti-suffocation properties, excellent fire suppression effects, and non-toxic environmental friendliness. Common causes of car fires include electrical fires and fuel leakage fires. For electrical fires, water-based mist extinguishers are more suitable; for fuel fires, water-based foam extinguishers are preferable. Dry powder fire extinguishers offer good versatility and a broad application range, making them suitable for both aforementioned fire scenarios. Each type has its own characteristics and is suitable for vehicle use, allowing for selection based on specific needs. For ordinary family cars, it is recommended to use 1 to 2 kg fire extinguishers, as they are lightweight, easy to carry, and simple to secure in the vehicle.
6
4
Share

How to Change the Oil in a Mercedes 9-Speed Transmission?

Method for changing the oil in a Mercedes 9-speed transmission: 1. Secure the vehicle on a lift, remove the middle and rear underbody panels of the engine, use tools to detach the quick-release lock on the oil pan, and replace the transmission oil, filter, and oil pan together; 2. Add approximately 6L of transmission oil to the transmission. A completely drained transmission requires about 10L of transmission oil. Finally, clean the oil pan and reinstall all removed components. The Mercedes 9-speed model has a length, width, and height of 4784mm, 1810mm, and 1457mm respectively, with a wheelbase of 2920mm. The car body type is a 4-door, 5-seater sedan, equipped with a 9-speed automatic manual transmission.
1
4
Share

What Causes the Camry Sunroof to Not Close?

Here are the specific reasons why the Camry sunroof may not close: 1. Component aging: Press the sunroof switch button and observe the movement track of the sunroof. Check if there is obvious up-and-down fluctuation. If so, it is likely due to component aging, and the only solution is to replace the parts. 2. Presence of debris particles: Prolonged use inevitably leads to some debris particles on the sliding rails. As the sunroof moves along the rails, it rubs against these particles, causing unusual noises. Open the lubricant and apply it to both sides of the sunroof's sliding rails. 3. Loose screws: Loose screws can cause rattling noises from the roof lining and the sunroof, and even pose a risk of the sunroof falling off. Tightening the sunroof screws will resolve this issue.
11
5
Share

Where is the expansion valve located on the Jinbei Grace?

It is located behind the evaporator box. The precise location is under the white air intake cover beneath the windshield wiper water deflector. There are two screws on each side; after removing them, you will see the expansion valve. Relevant information about the expansion valve is as follows: 1. Introduction to the thermal expansion valve: The thermal expansion valve, also known as the throttle valve, is one of the four major components in the automotive air conditioning refrigeration system (evaporator, compressor, condenser, and expansion valve). It senses the superheat of the refrigerant vapor at the outlet of the evaporator to adjust the opening degree of the expansion valve, thereby controlling the flow of liquid refrigerant entering the evaporator. 2. Thermal expansion valve balance: Based on the balance method, thermal expansion valves are divided into internal balance and external balance types. The working principles of internal and external balance expansion valves are basically the same. The difference lies in: the internal balance expansion valve diaphragm senses the pressure at the evaporator inlet. When the pressure drop in the evaporator is too large, it reduces the superheat sensed by the power head, causing insufficient valve opening. The external balance expansion valve diaphragm senses the pressure at the evaporator outlet, avoiding the influence of evaporator pressure drop on the valve opening and overcoming the shortcomings of the internal balance valve.
1
3
Share

What are the reasons for a Jinbei vehicle having power and fuel but failing to start?

Jinbei has power and fuel but fails to start for the following reasons: 1. Spark plug damage: Check the spark plug to see if it is aged or has heavy carbon deposits, and replace it with a new one if necessary. 2. Poor contact in the high-voltage line: Use a multimeter to test whether the resistance is normal. 3. Ignition circuit failure: Use a multimeter to check for open circuits. 4. The vehicle is too old: The fuel line is severely aged, and the fuel supply cannot keep up when starting the vehicle, often causing failure to start. Therefore, when starting, slightly press the accelerator pedal to speed up the fuel circulation, making it easier to start.
12
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.