Do all four screws of the car license plate need to be installed?

What does the M gear in a manual-automatic transmission mean?

M gear in a manual-automatic transmission refers to the manual shifting mode. Below is relevant information about the M gear in a manual-automatic transmission: Tips for using the M gear in a manual-automatic transmission: When overtaking, if you are in D gear, the vehicle speed will not increase rapidly even if you press the accelerator hard, and you can only shift up sequentially to overtake. However, switching to M gear makes a big difference. At this time, pressing the accelerator allows the vehicle to utilize the high torque of lower gears for instant acceleration, completing the overtaking action more quickly. When going down a long slope, if driving an automatic transmission, the vehicle speed will uncontrollably increase, requiring timely braking while coasting. But if you engage manual mode when going downhill and shift the gear lever backward to lower the gear, you can fully utilize engine braking to reduce speed. Upon reaching the bottom of the slope, you can quickly shift up or switch back to automatic mode to resume normal driving. Functions of the M gear in a manual-automatic transmission: M gear is the manual mode of a manual-automatic transmission or the simulated manual mode of a CVT transmission. It can also be used to shift up or down via paddle shifters on the steering wheel.

17

0

Share

Can Trailers Go on Highways?

It depends on the specific situation. If it is a personal trailer, it is not allowed on highways. Legal Basis for Trailers: According to Article 56 of the "Regulations for the Implementation of the Road Traffic Safety Law," motor vehicles towing trailers must comply with the following provisions: Trucks, semi-trailer tractors, and tractors are only allowed to tow one trailer. The lighting signals, brakes, connections, and safety protection devices of the trailer must comply with national standards; small passenger cars are only allowed to tow travel trailers or trailers with a total mass of less than 700 kilograms. Trailers must not carry people; the load capacity of the trailer towed by a truck must not exceed the load capacity of the truck itself. Large and medium-sized passenger cars, low-speed trucks, three-wheeled vehicles, and other motor vehicles must not tow trailers. Regulations for Towing Motor Vehicles: The towed motor vehicle must not carry people other than the driver and must not tow a trailer. The width of the towed motor vehicle must not exceed the width of the towing motor vehicle. When using a soft connection towing device, the distance between the towing vehicle and the towed vehicle must be more than 4 meters and less than 10 meters. Both the towing vehicle and the towed vehicle must turn on the hazard warning flashers. Truck cranes and wheeled special-purpose machinery vehicles must not tow other vehicles. Motorcycles must not tow vehicles or be towed by other vehicles.

11

5

Share

Can China 5 Vehicles Be Licensed After the Implementation of China 6 Standards?

After the implementation of China 6 standards, China 5 vehicles can no longer be licensed, but newly licensed China 5 vehicles can still continue to be used. Below is an introduction to China 5 and China 6: Introduction to China 6 Standards: Compared to China 5, China 6 standards impose stricter requirements on carbon monoxide, nitrogen oxides, and hydrocarbons in emissions. Additionally, China 6 standards include new regulations on PN particulate matter. Introduction to China 5 Standards: During the China 5 phase, emission standards for diesel and gasoline vehicles differed. However, China 6 adopts a fuel-neutral principle, meaning the emission limits are the same regardless of the fuel type. Differences Between China 6 and China 5: After the formal implementation of China 6 standards, the main impact will be on the production, import, sale, and registration of new vehicles. Existing China 5 vehicles will no longer be allowed to be registered or licensed. However, previously registered and licensed China 5 vehicles can still be used, will not affect normal annual inspections, and can be traded as used vehicles. The China 6 standard will be one of the strictest standards globally. After July 1, 2019, China 5 vehicles in most regions of the country will no longer be eligible for licensing, and many regions have already or will implement the China 6 standard ahead of schedule.

1

Share

What are the precautions for purchasing a new car?

When purchasing a new car, pay attention to the vehicle's manufacturing time, check the glass markings, and inspect the inner wall of the exhaust pipe. Check the vehicle's manufacturing time: On the nameplate of the co-driver's door, there is the vehicle's manufacturing date. For domestic cars, it should not exceed three months, and for imported cars, it should not exceed six months. Otherwise, it might be a stock car. Check the glass markings: Check if the glass markings are consistent with the original factory. The production date should not be later than the factory's date. The numbers represent the year, and the dots represent the month. If the dot is in front, subtract it from 7; if it's at the back, subtract it from 13. If the markings on all four glasses are different, it might be an accident car. Check the inner wall of the exhaust pipe: The mileage should preferably not exceed 50 kilometers. Inspect the inner wall of the exhaust pipe for any black traces. If it's noticeably black, it might be a test-drive car. Check the car paint under both direct and indirect light for scratches. Small dents should be repainted smoothly.

11

1

Share

Is a Power of Attorney Required for Out-of-Province Vehicle Annual Inspection?

Out-of-province vehicle annual inspection requires a power of attorney. Introduction to Vehicle Annual Inspection in Another Location: Vehicle annual inspection in another location refers to conducting the vehicle's annual inspection in a place other than where it was purchased. For example, if the owner purchases the vehicle and registers it in City A but primarily uses it in City B, this creates a situation of using the vehicle in a different location. Since vehicles require periodic inspections every few years, driving the vehicle back to City A for inspection can be very inconvenient. This leads to the need for an out-of-city vehicle inspection, meaning a vehicle registered in City A undergoes inspection in City B. Documents Required for Out-of-City Vehicle Inspection: First and foremost, the most important document is the Power of Attorney for Out-of-City Vehicle Inspection. When conducting an out-of-city vehicle inspection, you must first obtain this Power of Attorney, then bring it along with other relevant documents to the local vehicle management office where the inspection is to be performed. To apply for the Power of Attorney, you need to submit the owner's ID card, vehicle insurance documents, vehicle registration certificate, original and copy of the vehicle and vessel tax, and an application for out-of-city inspection to the vehicle management office in the registration location. During the inspection, you must bring the vehicle registration certificate, insurance documents, and the Power of Attorney to the designated vehicle management office. It is important to note that the vehicle undergoing inspection must not have any unresolved traffic violations.

11

0

Share

How many kilometers can the XPeng G3 electric vehicle run?

The XPeng G3 electric vehicle comes in two variants, offering ranges of 520 kilometers and 460 kilometers respectively. Below is a detailed introduction to the XPeng G3 electric vehicle: 1. The XPeng G3 520i Premium Edition, which was announced in April this year and made its debut at the 2020 Chengdu Auto Show in July. In terms of basic parameters, the XPeng G3 520i Premium Edition is equipped with a second-generation permanent magnet synchronous motor, delivering a maximum power of 145kW and a peak torque of 300N·m. The battery type is a ternary lithium battery with a capacity of 66.5kW·h, providing an NEDC comprehensive range of 520km. 2. The XPeng G3 boasts a peak torque of up to 300N·m, ensuring strong performance even in economy driving mode. It can outpace most gasoline-powered cars from a standstill at traffic lights and accelerates effortlessly up to 70km/h, making city driving and overtaking stress-free. 3. The XPeng G3 is equipped with the XPILOT autonomous driving assistance system, which includes ACC adaptive cruise control. This feature allows the car to automatically follow and stop within a safe distance without manual intervention, simplifying the driving experience. Combined with ATC adaptive curve cruise and LCC lane centering assist system, the vehicle achieves Level 2.5 intelligent driving, reducing driver fatigue and ensuring road safety.

16

1

Share

Do all four screws of the car license plate need to be installed?

What does the M gear in a manual-automatic transmission mean?

Can Trailers Go on Highways?

Can China 5 Vehicles Be Licensed After the Implementation of China 6 Standards?

What are the precautions for purchasing a new car?

Is a Power of Attorney Required for Out-of-Province Vehicle Annual Inspection?

How many kilometers can the XPeng G3 electric vehicle run?

What gear should be used when towing an automatic transmission vehicle?

What is the maintenance interval for the Subaru BRZ?

What Should Be Noted for Safe Driving in Summer?

What are the requirements for participating in the license plate lottery?