Can You Still Drive with a Cut in the Tire Sidewall?

1 Answers
MacDakota
07/29/25 8:50am
Sidewall damage is one of the most common types of tire damage. Generally, whether the tire needs to be replaced depends on whether the damage has reached the cord layer, as well as the vehicle's usage conditions. For example, if the vehicle is used for long-distance high-speed driving, such a tire is not suitable, but it may still be usable for short commutes. It is recommended to replace the tire—either one or two, depending on the wear level. Tires on the same axle should be of the same specification. Below are some tire maintenance and usage tips: 1. Tire Maintenance: Check the tire pressure every 15 days, including the spare tire. Perform regular wheel balancing to prevent the vehicle from pulling to one side. Inspect the tires for excessive wear once a month. If any foreign substances are stuck to the tires, remove them promptly. 2. Usage Tips: Overinflating the tires can cause the tread to bulge, leading to excessive wear in the center area over time. Therefore, always inflate the tires according to the standard pressure specified in the vehicle's manual. Conversely, driving with underinflated tires for extended periods can cause excessive wear near the inner and outer tire shoulders.
Was this review help?
9
3
Share
More Forum Discussions

What are the situations that should be paid attention to when driving a motor vehicle in following distance?

Things to pay attention to: When following a taxi, be prepared for it to pull over at any time to pick up or drop off passengers; when the car in front has a "new driver" sticker, increase the following distance to prevent sudden braking; when following a large truck loaded with goods, increase the following distance and avoid following for too long to prevent dangers from falling cargo or blind spots; when driving in fog, be alert to sudden braking by the vehicle ahead. Here are some relevant points: 1. Following distance: Always maintain a safe distance from the vehicle in front to prevent rear-end collisions. 2. Nighttime precautions: When driving at night, use lights appropriately and overtake only when it is safe to do so.
8
4
Share

What are the reasons for the high fuel consumption of the Besturn B70?

Here are the specific reasons for the high fuel consumption of the Besturn B70: 1. Affected by temperature: Fluctuations in temperature can cause variations in fuel consumption. In winter, lower temperatures lead to increased fuel consumption. 2. Lack of vehicle maintenance: Dirty engine oil and air filters can also result in higher fuel consumption. Dirty oil leads to poor lubrication, increasing resistance in the engine's moving parts, which requires more energy to overcome, thereby raising fuel consumption. 3. Excessive carbon buildup in the vehicle: Carbon deposits commonly accumulate in the throttle body, fuel injectors, intake manifold, and piston tops. Excessive carbon buildup in any of these areas can cause incomplete combustion, leading to increased fuel consumption.
9
4
Share

What to Do When an Old Car Burns Engine Oil Severely?

This phenomenon occurs due to the aging of valve stem seals. The solution is to remove the engine cylinder head and replace the valve stem seals. The engine needs to be lifted out for a major overhaul. The repair time is approximately 2-4 days.
5
3
Share

Where is the Besturn Anti-Theft Module Located?

Besturn anti-theft module is located under the handbrake. Below are detailed introductions about the vehicle anti-theft system: 1. Anti-theft authentication: For vehicles equipped with a keyless system, press the unlock button or the keyless button on the driver's side door handle to open the door and deactivate the vehicle's alert status. Switch the power to the ON position, and upon successful engine anti-theft authentication, the anti-theft indicator light on the dashboard will turn off. 2. Automatic locking: If any door, window, or ignition switch is not opened within 30 seconds after unlocking, the doors will automatically lock and re-enter the alert status. 3. Components: It consists of an electronically controlled remote or key, electronic control circuit, alarm device, and actuators.
18
5
Share

How to adjust the audio system of an old Polo?

Find the settings in the Volkswagen's central control screen, and then locate the sound settings. Next, find the equalizer, which allows you to adjust the sound effects yourself. If no matter how you adjust it, it still doesn't meet your needs, you can also modify the car's audio system.
7
1
Share

What are the reasons for soft brakes?

As a crucial component for safe driving, brakes should be given special attention by every driver. Before each drive, it's advisable to test the working condition of the brake pedal. When the engine is not started, the brake pedal will feel very firm; after normal engine startup, the brake pedal will slightly sink. The reasons for soft brakes include the following: 1. Mixed brake fluid: Using different brands of brake fluid together can reduce braking performance. 2. Air in the brake fluid: The presence of unexpelled air in the brake fluid. 3. Oil leakage or poor sealing: Oil leakage in the master cylinder or wheel cylinders, or poor sealing. 4. Damaged outer packaging: Damage to the external casing of the brake lines.
6
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.