Can You Still Drive When the BMW Shows Engine Overheating?

Does the 12123 System Automatically Record After Passing Subject 4?

After passing Subject 4, the 12123 system will automatically record the results. Here are specific details about the driver's license examination process: 1. Subjects: The tests are conducted in sequence from Subject 1, Subject 2, Subject 3, to Subject 4. 2. Retakes: For Subjects 2 and 3 of the driving test, candidates can only take each test up to five times. If they fail beyond these attempts, they must repay the tuition and practice fees. According to the Ministry of Public Security's Orders No. 123 and No. 124, if a candidate fails the fifth scheduled test for Subject 2 or Subject 3 road driving skills, all previously passed subjects will be invalidated. To obtain a driver's license, the candidate must re-enroll and pay the tuition fees to the driving school again.

7

1

Share

Where is the Buick LaCrosse cabin air filter located?

The cabin air filter of the new Buick LaCrosse is located inside the glove compartment on the passenger side. To replace the filter, you need to first remove the glove compartment and then open the cover of the cabin air filter housing. Generally, the replacement interval for the Buick LaCrosse cabin air filter is every 10,000 kilometers. The steps for removing and replacing the Buick LaCrosse cabin air filter are as follows: 1. Pry open the glove compartment from its side. 2. Unscrew the 3 screws at the top and 2 screws at the bottom of the glove compartment using a 7mm socket. 3. Pull out the glove compartment. The glove compartment is also secured by several clips. First, pull it toward the passenger seat until the clips loosen or detach, then open the glove compartment cover and forcefully pull the other side outward to remove the glove compartment. 4. After organizing the wiring and air conditioning pipe clips, remove the entire glove compartment. 5. Once the glove compartment is removed, open the clips on the outer side of the cabin air filter. Then, use a small screwdriver to gently pry both sides of the cabin air filter outward to remove it. Pay attention to the markings on the front of the cabin air filter—the side with text should face outward, and the arrow should point downward. Insert the new cabin air filter in the same orientation. 6. Complete the installation.

18

3

Share

What Are the Standards for Total Loss Compensation of Flood-Damaged Vehicles?

Here is an introduction to the standards for total loss compensation of flood-damaged vehicles: 1. Level 1: The water level just reaches the vehicle chassis, with water entering the exhaust pipe, fuel tank, and carbon canister. The vehicle floor may become damp, but the likelihood of significant water ingress is low, and the impact on in-car electrical equipment is minimal. 2. Level 2: The water level reaches half of the wheels. Due to the vehicle's incomplete sealing, water will start entering the interior. For lower-bodied sedans, the water level inside may affect the adjustment motors of the seats and electrical components such as heating and ventilation. 3. Level 3: The water level almost completely submerges the tires. At this point, the water level inside the vehicle will fully immerse the seat cushions and the central armrest area, while affecting a large number of electrical devices.

1

3

Share

Will passing through a yellow traffic light result in penalty points?

When the yellow light is on, vehicles that have already crossed the stop line may continue to proceed. According to the regulations of the Road Traffic Safety Law Implementation Ordinance, this does not constitute a traffic violation and no penalty points will be deducted. However, running a yellow light is also considered a traffic violation, with the same penalty standards as running a red light. The following are the indications for motor vehicle traffic signals and non-motor vehicle traffic signals: 1. Green light on: Vehicles are permitted to proceed, but turning vehicles must not impede the passage of through vehicles and pedestrians. 2. Yellow light on: Vehicles that have already crossed the stop line may continue to proceed. 3. Red light on: Vehicles are prohibited from proceeding; at intersections without non-motor vehicle traffic signals or pedestrian crossing signals, right-turning vehicles may proceed when the red light is on, provided they do not impede the passage of through vehicles and pedestrians.

19

1

Share

Does the 2020 Tayron 330 have a particulate filter?

The 2020 Tayron 330 is equipped with a particulate filter to meet the China VI emission standards. The particulate filter is a ceramic filter installed in the diesel engine's exhaust system, which captures particulate emissions before they enter the atmosphere. It can reduce the soot produced by diesel engines by more than 90%, and the captured particulate emissions are subsequently burned off during vehicle operation. Diesel engine pollution mainly comes from three sources—particulate emissions, hydrocarbons (HCx), nitrogen oxides (NOx), and sulfur. Among these, particulate emissions (soot) are mostly composed of tiny particles of carbon or carbon compounds (smaller than 4-20μm). Working principle of the particulate filter: The diesel particulate filter is coated with metals such as platinum, rhodium, and palladium. The black smoke containing carbon particles emitted by the diesel engine enters the exhaust particulate filter through a dedicated pipe. After passing through the densely arranged bag-type filters inside, the carbon soot particles are adsorbed onto a filter made of metal fiber felt. When the adsorption of particles reaches a certain level, the burner at the end automatically ignites, burning off the adsorbed carbon soot particles and converting them into harmless carbon dioxide that is then expelled. To check whether the 2020 Tayron 330 has a particulate filter, you can use the following three methods: Check the and to see if there is a particulate filter function. Additionally, you can carefully review the fault codes in the manual to see if there is a "Particulate Filter" warning light indicator. Check the label above the oil filler cap. If the oil cap clearly states 0W-20 grade oil, it indicates the presence of a particulate filter. Check whether there is a cylindrical section on the exhaust pipe behind the three-way catalytic converter. If there is, that is the particulate filter.

15

1

Share

Release the Clutch First or the Handbrake First?

When driving a manual transmission car, you should first press the clutch to engage the gear, and then release the handbrake before the car starts. Below are the relevant details: 1. Precautions: Whether it's an automatic or manual transmission model, the handbrake should always be the last to be released. The main reason for engaging the gear first and then releasing the handbrake is that once the gear is engaged, the power transmission path of the transmission is connected, generating significant torque. If the brake is not properly applied, the car might suddenly lurch forward, which is very dangerous. The handbrake serves as a double safety measure in this scenario. 2. Torque Converter: If the handbrake is not released after engaging the gear, all the power output from the engine will be absorbed by the torque converter, causing its temperature to rise sharply. Prolonged exposure to such conditions can lead to the torque converter overheating and getting damaged.

15

2

Share

Can You Still Drive When the BMW Shows Engine Overheating?

Does the 12123 System Automatically Record After Passing Subject 4?

Where is the Buick LaCrosse cabin air filter located?

What Are the Standards for Total Loss Compensation of Flood-Damaged Vehicles?

Will passing through a yellow traffic light result in penalty points?

Does the 2020 Tayron 330 have a particulate filter?

Release the Clutch First or the Handbrake First?

What Brand is Exeed?

Why does the engine not rev up and feel weak when accelerating?

Why is there no air coming from the rear air vents?

What Are the Reasons Why a Vehicle Won't Start?